Question about Dodge B Series Cargo

Open Question

How to replace the water pump on a 1992 dodge b250 van?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 337 Answers

SOURCE: 1992 ford tempo water pump replacement

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528005d60d

Posted on Dec 07, 2008

Ad
michigan man
  • 3533 Answers

SOURCE: i dont have the diagram

normally the diagram for the fuse box is just inside the lid and my suggestion to you is to stop by a dodge dealer and the parts department would print you off a diagram

Posted on Jan 08, 2009

  • 2 Answers

SOURCE: I need to know where

does not have one for ignition system

Posted on Apr 30, 2009

  • 176 Answers

SOURCE: water pump 1996 dodge ram van 318 2500

Before you remove the serp belt, loosen the clutch fan bolts from the water pump. Other wise you will be fighting with them later. Other wise just drain the coolant and remove the pump. I would suggest a new thermostat since the coolant is drained. Make sure the block surface is cleaned of all gasket material and other dirt before installing your new pump. I usually scrape the area with a putty knife and wipe it down with some brake clean on a rag.

Posted on May 20, 2009

  • 1071 Answers

SOURCE: electrical Drawings for a 94 Dodge B250 Primetime conversion

there is no real diagram for the conversion vans you only have stock diagrams because glaval or primetime usually took the shells and made thier own interiors and yes i have seen alot of issues with these its a wonder im not bald just have to use basic electricity for the add ons they are not actually chrysler supplied items yes you can get them from chrysler but they order them from the other 2 companies that convert the vans

Posted on Jul 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can anyone tell me what type of rear axle is used in a 1988 Dodge Ram Van B250?


your local parts store should be able to look it up for you along with capacity

Dec 05, 2013 | 1988 Dodge B250

1 Answer

My 1993 dodge ram B250 wagon is showing signs of a bad fuel pump but mechanic says fuel pump is fine. Wants me to buy a new PCM (which we just did a month ago for a previous problem). The van was running...


one thing to look for is your gas gauge. if it doesnt read or your wagon constantly stops then i would go with the fuel pump. replace the pump and replace the fuel line any water in that line would be bad.

Jul 12, 2011 | 1999 Dodge Ram

1 Answer

I have 1992 dodge B250 van the speedometer is working but the miles counter not working.


if the speedometer is working but the counter is not - then the counter gear is broken.
it is not worth trying to fix -- just buy a new gauge and install it.

c...

Feb 22, 2011 | 1988 Dodge B250

1 Answer

My mechanic is fixing my water pump for my 1985 b250 dodge ram 5.2 8 cylinder van. When he tried to put the belts back on he couldn't figure it out too short too long didn't fit. where do you find a...


Go to your local autozone, or even check autozone.com register and you can see diagrams for most vehicles. Registration is free by the way. Also try dodgetalk.com or turbododge.com there is a lot of info there, including forums.Good Luck!

Sep 03, 2010 | Dodge Ram 250 Cars & Trucks

1 Answer

Dodge ram van stalls when RPM are low


could be fuel filter clogged //fuel pump is going bad which you will need to have a pressure test done ...also is there a gas odor ? could be rusted lines could be air filter ....messing with the timing you should not move to much ...if you have brake /carb choke cleaner try spraying around the intake manifold to see if any change in performance such as lowering the rpm's which would mean a gasket leak are all the Vacuum lines good and not dry-rotted try bending them ans well as spraying with a squirt bottle of water on the plug wires to see if an Arc is present a bad plug wire ..these are a few areas in which i would consider 1st ..hope this helps you

Dec 03, 2009 | 1999 Dodge Ram

2 Answers

1987 dodge ram van STEERING COLUMN


to whom this may concern did you find a steering column. Are you replacing it in a 1987 dodge pick-up

Apr 23, 2009 | 1987 Dodge Ram Wagon B250

1 Answer

I need to know where the water pump is located on 1992 Dodge Caravan 3.0 L, 6 CYL and how to install it. A picture would be helpful.


your water pump is at the front of the motor towards the bottom of the van.look at the pulleys the water pump is the only one that the smooth side of the belt runs on and has three or four bolts on the front of it

do rate the solution.

Jan 30, 2009 | 1992 Dodge Caravan

1 Answer

Adding oil


its the lifters and for a van that age its normal wear on the motor.

Jan 29, 2009 | 1992 Dodge Ram 250

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...