Question about 2008 Chevrolet Avalanche

Open Question

2008 Chevy Avalanche - 3 door locks not working, is it possible 3 solenoids are out?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2003 Chevy Avalanche rear doors won't lock automatically

The rear doors will not lock with the keyless remote, the drivers master switch

Posted on Jul 30, 2009

  • 1986 Answers

SOURCE: 2003 CHEVY AVALANCHE dash board telling me left

check the lil switch that'll be located on the latch anchor point or within a few inches of it.... odd is the switch is faulty

Posted on Sep 09, 2009

iambanshee74
  • 3489 Answers

SOURCE: 08 avalanche pass side power door lock not working

if you have any knowledge of automotivce electrical, (and that you need to use a "circuit tester" and not a test light) test for power when someone presses the button. it wouldnt be uncommon for most vehicles for the lock actuator/solenoid/duty actuator to wear out, get weak and fail. this is most probable. given that this is an 08, have you checked withe dealer to see if its still under warranty. if we are only talking a few miles and they wont do anything, look in your owners handbook and get the 1 800 number and get GM's customer service involved. cheers.

Posted on Dec 02, 2009

  • 236 Answers

SOURCE: 2008 avalanche 3 door locks not working started

each door has there own door lock solenoid, the only thing they have in common is one fuse, either they all work or none of them will work. So I would say the door lock actuator inside the door has failed.

Posted on Dec 16, 2009

  • 181 Answers

SOURCE: 2008 chevy malibu. how to program keyless entry remote

You must take it to the Chevy dealer.

Posted on Mar 09, 2010

Testimonial: "thank you"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

04 chevy avalanche starts and dies also poer windows and door locks and keyless entry dont work all happened overnight


sounds like a security issue, disconnect the neg terminal of the battery for 5 minutes, after you reconnect the battery use the door key to lock and unlock the drivers door. try to restart

Feb 11, 2015 | 2004 Chevrolet Avalanche

1 Answer

Power door lock on chevy equinox does not work on one door how can it be fixed


I had the same problem but on the passenger side door. The wire harness on the passenger side had broken wires. Purple wire was for the lock and thicker blue and darker grey was power for the windows. I used butt connectors to repair and it worked like a charm. Area was tight to work in between vehicle frame and door. Was easier to remove door panel and disconnect harness at vehicle frame and pull harness through door to complete the repair.

Mar 19, 2012 | 2008 Chevrolet Avalanche

3 Answers

Where are the door lock relays in the 2008 Avalanche?


FUSE AND RELAYS FOR POWER DOOR LOCKS SHOULD BE UNDER THE HOOD.LOOK IN OWNER MANUAL FOR RELAYS LOCATION OR LOOK ON FUSE RELAY COVER FOR RELAYS LOCATION..

May 08, 2011 | 2008 Chevrolet Avalanche

1 Answer

Good afternoon....what would cause my 2008 Chevy


It could be the power lock motor. You could have a short or bad wiring harness. Might just be a fuse that connects to both. But since you said it's only the driver side. When the power lock motor is bad it can trigger your alarm because they're wired together.

Hope that helps. Good luck.

Apr 06, 2010 | 2008 Chevrolet Avalanche

1 Answer

2008 avalanche 3 door locks not working started with front passenger now both driver front and rear won't open or lock.


each door has there own door lock solenoid, the only thing they have in common is one fuse, either they all work or none of them will work. So I would say the door lock actuator inside the door has failed.

Dec 15, 2009 | 2008 Chevrolet Avalanche

1 Answer

2007 chevy avalanche electrical issues


You need to remove the carpet on the passengers side and check the wireing harness,take off the tape and visually inspect it.You are likely to find broken splices ,bare wires or wires shorted to each other or to ground.

Dec 08, 2009 | 2008 Chevrolet Avalanche

1 Answer

08 avalanche pass side power door lock not working


if you have any knowledge of automotivce electrical, (and that you need to use a "circuit tester" and not a test light) test for power when someone presses the button. it wouldnt be uncommon for most vehicles for the lock actuator/solenoid/duty actuator to wear out, get weak and fail. this is most probable. given that this is an 08, have you checked withe dealer to see if its still under warranty. if we are only talking a few miles and they wont do anything, look in your owners handbook and get the 1 800 number and get GM's customer service involved. cheers.

Dec 02, 2009 | 2008 Chevrolet Avalanche

1 Answer

2003 Chevy Avalanche rear doors won't lock automatically


The rear doors will not lock with the keyless remote, the drivers master switch

May 27, 2009 | 2003 Chevrolet Avalanche

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

255 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...