Question about 1986 Ford Econoline

1 Answer

Car wanders when driving - 1986 Ford Econoline

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Contributor
  • 613 Answers

I would have a alignement done sounds like it is out or maybe tires need balanced hope this helps

Posted on Sep 11, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Steering wandering had ball joints track rod ends done for mot last couple of years tracking been done cars wanders when driving quite scary


There are many reasons for wandering, I should highly recommend you do some serious looking before you drive any trips, or any higher speeds until you have the front end checked by a reputable mechanic (one highly recommended.)
Here are some reasons for wandering.
1) A bad tire (the tire can look fine, but be bad.)
2) A bad "front end alignment".
This is repairable, but good shops will not fix it until and unless the whole "front end of the car" is in good order.
3) A worn component in the "front end".
God bless your efforts.

Jul 07, 2017 | Cars & Trucks

1 Answer

Free ford troubleshooting


Worn/loose linkage, over inflated tires, excessive wheel bearing play, worn/loose ball joints, mismatched tire tread design, excessive steering gear play, etc...

Feb 18, 2014 | Cars & Trucks

1 Answer

Just bought a 94 jeep grand Cherokee all wheel drive and it is making a loud noise and wanders all over the road . what can the problem be


yes the tire size is very important! however assuming everything is the correct equipment the wandering problem is likely the u-joints in the front axles binding. If this is the case the front axle u-joints need to be replaced. This is very common on 4x4 vehicles with solid front axles. Good luck!

Aug 03, 2013 | 1994 Jeep Grand Cherokee

1 Answer

Was wandering if its a fairly simple thing to change a water pump on an 88 gmc k 2500


remove the fan and fan shroud. remove the drive belt. remove the four bolts holding the pump to the engine. clean the old gaskets off the engine block and then install new pump.

Jun 20, 2012 | Cars & Trucks

1 Answer

Rear of wanders when driving on ice and snow


whats that mean,,,its ice and snow it should wander

Jan 05, 2011 | Ford Fusion Cars & Trucks

1 Answer

93 1500 chey wants to wander , I replaced the pitman arm, ball joints are ok. Steering box seems OK. Could this be a steering drive shaft problem?


could be. I had a blazer that would do that and it turned out to be the tie rod ends which will also make it wander.

Sep 09, 2010 | 1993 Chevrolet C1500

1 Answer

Have a 1996 jeep grand cherokee zg model


The Jeep has steering idlers (short 7" arms) that eliminate wandering. Sounds like they are worn but FIRSTLY check that you have 4 identical tyre pressures as just one tyre front or back being low will give you the wandering sensation in a 4x4

Regards

Lloyd

Dec 05, 2009 | 1996 Jeep Grand Cherokee

2 Answers

VAGUE AND WANDERING STEERING ON 1990 HILUX 4 X4


Wandering is usually caused by toe-out. Did the aligner use front wheel drive specifications for this rear wheel drive truck? A front wheel drive toes in when the wheels are pulling the car, but the front wheels on your truck drag back to a toe-out position if steering parts are worn. Try pushing the fronts of the front wheels apart. They should still be at least a 16th of an inch closer in the front than in the rear of the tires.

Sep 10, 2009 | 1990 Toyota Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...