Question about 1991 Nissan Maxima

1 Answer

I can't find the window washer fluid reservoir

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,793 Answers

Its under the front fender behind the wheelarch cover.(follow the filler tube down)

Posted on Sep 11, 2010

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 30 Answers

SOURCE: leak in window washer fluid reservoir, need to change

you need to check the hoses on the motor

Posted on Jan 27, 2009

GasparMacari
  • 166 Answers

SOURCE: Replace 2001 silverado 1500 4x4 windshield washer fluid reservoir

the only solution acording to the manual is to replace the reservoir... not much to say about that, u do have the option to patch it...be careful with the product u use to glue that patch.
take care

Posted on Aug 21, 2009

reizac926
  • 56 Answers

SOURCE: WINDSHIELD RESERVOIR RAPIDLY EMPTIES WHEN WASHER

There a small diameter hoses that run the the nozzles for the front and rear windshield. More than likely, one is loose or cracked and is leaking. Do you have good spray on the windshield as you operate it? Is one weaker than the other? - If so, you definitely have a leak in a hose or nozzle. Another common leak area is around the reservoir edge or near the pump. The pump commonly resides at the bottom of the reservoir.
Hope this helps!
Rate this solution!

Posted on Jan 05, 2010

manuelleiva
  • 97 Answers

SOURCE: my washer window washer stopping out om 99 toyota. the reservoir

on the bottom of the reservour is a hose which is attached to a little pump which makes the washer fluid shoot out on to your windshield.it also has an electrical plug connected to it.sometimes by wiggling the plug it will start to work again,if not,make sure that there is power going to the pump.if there is power,your washer pump will have to be replaced.if there is no power,check your fuses. hope this information helps you with your problem. take care, manny

Posted on Feb 01, 2010

  • 65 Answers

SOURCE: were is the reservoir for the rear window washer

on most chevrolet the rear reservoir is the front reservoir.the line runs through the inside of the car to the rear.

Posted on Feb 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse for the water pump for the window washer


A washer pump in a car's windshield wiping system moves washer fluid from a reservoir through hoses. The motorized pump pressurizes the fluid to allow it to be squirted from the hoses through nozzles onto the front and/or rear windshield of a car. The washer fluid helps windshield wipers get rid of rain, dirt, or other objects that can interfere with a driver's visibility. If your washer fluid is not being sent out when activated, the solution could simply be filling the washer system's reservoir with more fluid or cleaning the nozzles and hoses. In more severe cases, the washer pump may need to be replaced. Here are steps to troubleshoot a windshield-washer pump.

Try this link in case you are stuck:

How to Troubleshoot Windshield Washer Pump

Here is another YT video for a similar purpose:

Windshield Washer Pump and System Diagnosis

Apr 13, 2015 | 2001 Ford Explorer Sport Trac

1 Answer

Fill 2008 nissan pathfinder windshield washer fluid


Just one.Check the lines and the pump at reservoir,

Jan 14, 2013 | Nissan Cars & Trucks

1 Answer

Where can i buy a window washer resavoir for my 3.2 jaguar 1996 xj6


WINDSHIELD WASHER FLUID RESERVOIR
Part #: JLM12455 RESERVOIR, WINDSHIELD WASHER FLUID, FITS 1995-1997 XJ6. This is the large lower reservoir the top filler tube will need to be removed from your old reservoir ITS ABOUT 155.00

Aug 10, 2011 | 1996 Jaguar Xj Series

2 Answers

How do I fix my window washer pump on my 2000 dodge caravan?


One can get a repair kit that includes a new motor pump and wiring clips, or

one can get the original motor that plugs into the windshield wiper fluid reservoir.

---
Windshield wiper reservoir (gives idea of how to change the windshield wiper fluid pump motor) Removal & Installation To Remove:
  1. Disconnect and isolate the negative battery cable.
  2. Raise and safely support the vehicle.
  3. Remove the right front wheel and splash shield.
  4. Disconnect the electrical connectors from the pumps and detach the rear washer hose.
  5. Place a drain pan under the reservoir if it contains fluid.
  6. Disconnect the front washer hose at the wiper unit in the engine compartment. NOTE: The front hose will be removed with the reservoir.
  7. Let the fluid drain from the reservoir.
  8. Remove the mounting screws and the reservoir.
To Install:
  1. Install the fluid reservoir with the mounting screws.
  2. Connect the front washer hose in the engine compartment.
  3. Connect the electrical connectors and rear washer hose.
  4. Install the splash shield.
  5. Install the right front wheel.
  6. Lower the vehicle.
prev.gif next.gif

Aug 27, 2010 | 2000 Dodge Caravan

1 Answer

1999 chevy blazer...where is the reservoir to fill the wiper fluid for the back window? Is it located somewhere by the back tailgate, or is it supposed to use the same wiper fluid from the front reservoir....


1999 blazer i m pretty sure uses the same reservoir, its easy to check, look at bootom of res and there should be to pumps. a good way to test wiring and washer button is to wire the rear to frt and hit rear washer button and it should spray frt window, or just use a test light and check for a good ground and power when button is hit hope this helps.

Feb 28, 2010 | Chevrolet Blazer Cars & Trucks

1 Answer

Rear window washer fluid fill


check in the cargo area of the vehicle, there should be an access panel on either the right or left panel in back. if it has a separate reservoir that's the most probable location
hope this helps

Feb 22, 2010 | 2004 Honda Pilot

1 Answer

Mercury villager 1994 washer pump not working


the pump motor likely is bad. get a used washer fluid reservoir at a pick n pull yourself or at car-part.com. page with * is lowest cost.

Pump and Reservoir, Windshield Washer Removal
  1. Disconnect the battery ground cable (14301).
  2. Raise and support the vehicle.
  3. Remove the RH wheel (1007).
  4. Remove the RH front fender splash shield (16103). Refer to Section 01-02 for the removal procedure.
  5. Remove the windshield washer reservoir top bolt.

  6. Disconnect the windshield washer reservoir fluid level sensor electrical connector.
  7. Disconnect the rear window washer pump electrical connector from the rear window washer pump.
  8. Disconnect the windshield washer pump electrical connector from the windshield washer pump (17664).
  9. Place a suitable drain pan under the windshield washer reservoir (17618) and drain the washer fluid.
  10. NOTE: The rear window washer hose end is color-coded, matching the connector on the rear window washer pump. Match the colors to ensure proper installation.

    Disconnect the washer hoses from the windshield washer pump and the rear window washer pump on the windshield washer reservoir.

  11. Loosen the two windshield washer reservoir side bolts.
  12. Remove the windshield washer reservoir by sliding it out of the side slots.
  13. Remove the windshield washer pump.

    Installation
To install, reverse the removal procedure. Tighten the lug nuts (1012) to 98-118 Nm (72-87 lb-ft).

Sep 09, 2009 | 1994 Mercury Villager

Not finding what you are looking for?
1991 Nissan Maxima Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14251 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...