Question about 1992 Isuzu Rodeo

1 Answer

I just bought a 92 Rodeo for my son and there seems to be something wrong with the electrical wiring for the left turn signal. Hazards work, right turn signal works, and the fuse is good but left turn signal will not work.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,793 Answers

Indicator stalk is faulty.

Posted on Sep 11, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Right side turn signal switch does not work/blink?


hi

there is usually a turn signal relay under the dash that clicks when you turn left and right you may need to replace it they wear out over time
25718368-m35oz4jvdfvvmght4a51n0jl-2-0.jpg cheers

May 28, 2015 | 1992 Isuzu Rodeo

1 Answer

I have a 2005 Nissan Sentra 1.8s and my left turn signal and my hazards will not work when running lights are on but the right signal works fine, also the left turn signal indicator in the dash is on


You have a bad ground on the left side. Use a jumper wire on the ground wire near the socket on the left side. If the lights start to work normally than trace the ground wire back to its body connection and repair

Nov 29, 2013 | 2005 Nissan Sentra

1 Answer

1988 jeep comanche wiring


drove mine to the ends of the earth,
there are 4 books,
big main , engine,and one for trans, no PDFs back then so, none sold. just paper books.
its and old car, very old, not too many left run 1988
with that nasty French REniX EFI system/.end rant
I had the 1988 XJ too, a pair of jeeps. then....


i can see your wiring is all messed up
and grounds.

got a voltmeter,
if not only guessing and wire inspections may work
ever consider get a sparks guy to fix it? He can and easy.
I promise.
for me to teach you electrics in this box, is over the top hard.

id have inspected all those wires, every inch
and #1 is trailer wiring hacks at the rear.
the tails are not tails
if you its Parking lamp after the front parking lamps or side markers can not be called TAIL,but yes, some fuses are still using the old 1884 now TRAIL name
check fuses yet, means test them ones that look good test.
using a METER.

.
.i see there are shorts on the KEY switch IGN out pin
for sure.!! radio is off key OUT and off.
or that wires IS SHORTED
harness messed up near steering/cluster,big time.

Feb 28, 2017 | Jeep Comanche Cars & Trucks

1 Answer

I turn the left signal light on and it works fine, I turn the right signal on and the vehicle right blicks, but the left trailer blinks. All brake lights work. What is wrong? Ground connects are good


Who installed the wiring on the vehicle ( dealer, self etc.)
Was trailer wiring pre installed or someone else did it
How old is the trailer?
it seems that there is a bad connection on the vehicles wiring. perhaps wrong part was used or connection from vehicle right turn- to wiring harness is not hooked on properly. Depending on how confortable you feel, test to see if there is proper electrical current flowing to the wiring harness ( right turn, left turn, brakes, headlights) you should be able to detect which area on the harness does not get power when the vehicles right blinker is on. It is not too complicated, just requires deductive reasoning and a tester ( about $5 at Kragens) No harm will come to your vehicle's electrical system by doing this; worst case scenario: you blow a fuse.
If vehicle is working properly, it will be a bad connection on trailer

Dec 21, 2010 | 2008 Ford Escape

1 Answer

My left turn signal no longer works on my '00 T&C. Hazards, brakes and right turn signal works. I've replaced both lights in front and back, replace turn signal switch and check fuses'. What else can I...


SOUND LIKE WIRE PROBLEM.YOU NEED A WIRE DIAGRAM TO CHECK THE TURN SIGNAL SWITCH WIRING DONT PLUG A WIRE IF YOU DONT KNOW WHERE IT GOES COULD CAUSE ELECTRICAL BLOW OUT.TRY TO GO ON LINE LOOK FOR AUTODATA DIY COM LOOK FOR ELECTRICAL DIAGRAM.

Nov 18, 2010 | 2000 Chrysler Town & Country

2 Answers

My toyota 92 pickup truck turn signals don't work;


Try changing out your turn signal flasher.it might be under your dash by your fuse box.Some trucks have two one for turn signals one for 4 way flashers.By all means check the fuse first.

Mar 09, 2010 | Toyota Pickup Cars & Trucks

1 Answer

'94 Rodeo right turn signals not working unless using hazards


sounds like a switch problem in the steering colum, could be a bad switch could be a loose connection. my advice would be to purchase a auto repair manual for you vehicle for detailed instruction on testing and/or replacing the switch.

Feb 14, 2010 | 1996 Isuzu Rodeo

1 Answer

Flasher works, hazards work, but when i turn on my turn signal the lights dont blink. They do when i turn the hazards on though. What is the problem here?


This seems to be a common problem. I bought mine from my uncle and had this issue. Your going to have to pull the steering wheel off and clean the contacts inside the column. Its not hard, just make sure you have the wheels straight so you put the wheel back on straight, and put all the parts back in the housing. Takes 1 or 2 hours.

Jul 11, 2009 | 1993 Isuzu Rodeo

1 Answer

99 Rodeo Right turn signal makes brake lights blink


TURN SIGNALS WILL FEED BACK THROUGH THE TURN SIGNAL SWITCH.THEY ARE INDEPENDENT OUT SIDE ON THE CAR BUT NOT IN THE SIGNAL SWITCH.REPLACE THE SIGNAL SWITCH

Jan 02, 2009 | 1999 Isuzu Rodeo

3 Answers

99 Rodeo Right turn signal makes brake lights blink


could be both unrelated issues at the same time

worn indicator stalk
faulty relays

adjust or test the brake pedal stop light switch

Mar 22, 2017 | 1998 Isuzu Amigo

Not finding what you are looking for?
1992 Isuzu Rodeo Logo

250 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...