Question about 2006 Chevrolet Trailblazer

1 Answer

Fuel guage is broken - 2006 Chevrolet Trailblazer

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 339 Answers

{: ) If the gauge or needle is broken, you need to bring it to a qualified electronic service center for repairs, or you can change the whole cluster assembly and have it programmed.

Posted on Jun 08, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Chrysler pacifica 2007 cannot put much fuel in at a time. gas guage drops from half tank to empty in seconds


If you can't put much fuel in i's probably not empty! If there is not a big puddle of fuel underneath then your guage is broken.

Jan 04, 2015 | 2007 Chrysler Pacifica FWD New Cars

1 Answer

Broken trip gauge on 1999 chevy blazer


There may be a blown fuse causing the trip meter failure and quite possibly the gauge reading failure. since you didnt say if they went out at the same same it is hard to say but checking the fuses is a likely culprit for the first problem. it is entirely possibly that you fuel guage just stopped sending the signal up to your guage. this is known to happen usually only remedied by replacing the fuel pump as it is part of the wiring on the pump itself. that is unless that fuse is the reason it is bad. the other thing is the possibility of a broken/shorted wire that provides the signal from the pump to the guage good luck

Feb 12, 2013 | 1999 Chevrolet Blazer

1 Answer

Gas gauge is reading full at all times


fueltank sending unit inside fuel tank is broken or the wire is disconnect.when guage reads past full that means the guage is not getting a signal from fuel tank

Feb 14, 2011 | 1998 Ford Windstar

1 Answer

Fuel gauge reading empty but just filled it


eighther the guage inside is bad or there is another part of the guage inside the fuel tank is bad or there is a broken cable between the tank and the guage get under the car and see the tank inlet for the cable and see if the wire is broken from some place

Feb 07, 2011 | 2000 Volkswagen Golf

2 Answers

Vehicle runs until gas guage is at half full, then dies, gas added will cause vehicle to run again


Remove the fuel tank an check the line connections at the pump, good time to check the fuel guage also

May 16, 2010 | 1996 Ford Explorer

2 Answers

Fuel guage doesnt work. ive tracked down all i can. Anyone got any suggestions. 1983 grand marquis 302 fuel inj


Open circuit - gauge will read full.Grounded circuit - the gauge will read empty. If it reads empty all the time - then the wire that goes to the sender is broken and/or grounded somewhere along its length to the fuel tank. run a jumper wire from bottom of the fuse box in the spot, all the way to top of sending unit on tank. disconnect old wire at both ends, and then turn on the key and observe guage. if not this, check guage itself for sticking.

Apr 29, 2010 | 1983 Mercury Grand Marquis

1 Answer

My gas gauge on my 93 ford mustang quit working. the gauge is stuck on full. Help


i suspect a broken wire between guage and sender unit in tank, but the sending unit could be bad,find the wire to the float guage in the tank and disconnect it, if fuel level does not change then then touch the wire to a ground, if the guage changes then the wire is ok and the unit is bad, if it does not change check wiring and guage for faults.

Jul 30, 2009 | 1993 Ford Mustang

2 Answers

THE GAS GUAGE IS BROKEN WHAT CAN I DO TO FIX THIS PROBLEM


the most common cause of an inoperative gas gauge is the gauge sending unit insde the fuel tank is defective, to replace this u must remove the gas tank and replace the sender.

Apr 22, 2009 | 2000 Chevrolet Blazer

1 Answer

Fuel guage reads half way and the truck runs out of gas


The float that helps detect fuel level is most likely broken. You or a mechanic will have to remove the fuel pump from the gas tank and check and possibly replace the float. Merry Christmas.

Dec 23, 2008 | 2001 Chevrolet S-10

1 Answer

Broken guage


electronic it has a fuel level sending unit that is in the gas tank.

Aug 11, 2008 | 1989 Chevrolet Astro Cargo

Not finding what you are looking for?
2006 Chevrolet Trailblazer Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...