Question about 1997 Chrysler LHS

1 Answer

CAR KEEPS BLOWING 20 AMP ENGINE CONTROLLER FUSE??

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

What keeps blowing my control fuse on my 1997 Chrysler LHS

Posted on Mar 11, 2016

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1348 Answers

SOURCE: 01 chrysler sebring was running good but now keeps

something in the ignition circuit is drawing too much current.the starter draws 10 times that much current.check for shorted wires or a bad coil pack,or even the module,or a short in the distributor.get the wiring diagram.put a 25 watt bulb in the fuse instead,it will light and limit the current to 2 amps.disconnect items until the light goes out,and then check things on that power rail.

Posted on Jun 14, 2009

  • 201 Answers

SOURCE: i blow a 20 amp fuse engine won't turn over.

Then you need to replace them all. Hope this helps!?

Please rate solution - Thanks.

Posted on Apr 23, 2010

ginko
  • 19396 Answers

SOURCE: 20 amp fuel pump fuse

Hi.

Disconnect fuel pump terminals, insulate them, and crank (car will not start). If fuel does not blow, then it was a shorted pump. Replace the pump. If fuse blows again, then there is a wiring problem. You will need to use a test light or a multimeter to find the short.

Posted on Sep 08, 2010

  • 14036 Answers

SOURCE: the start and fuel 20

SOUND LIKE FAULTY IGNITION SWITCH OR FAULTY ASD RELAY FAULTY FUEL PUMP.

Posted on Sep 19, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuse 20 keeps blowing. How can I determine the source of the problem?


easy answer, all things connected to 20 can be shorting
the fuse blows, saving you of a fire.
but you can DIY,
you can , log in to alldata.com and read the wiring page.

fuse 20 in the PDC or fuse 20 in the JB.
at least tell if fuse is in the cab or engine bay, or i can not guess.
manual zone or auto zone option?
no matter the blower runs off fuse JB 7 not 20
and PDC 1.

JB20 runs the manual or az controller.
only, so pull its C1 connector, fuse holds?
good, if not bad harness.
say it holds, so pull all things connected to controller.
then see if fuse JB20 holds.

see heater here , wiring a/c heater....
see those fuses?
unplug all damper motors, many there are)
does that stop the blowing of JB-F20.
see page 8w-42-2 ,etc.
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service


Apr 29, 2014 | Jeep Grand Cherokee Cars & Trucks

1 Answer

20 amp engine fuse for 2000 plymouth grand yoyager keeps blowing


I don't have a picture, just a diagram. In the power distribution center, I see 20A fuse 3 for the automatic shut down relay and 20A fuse 5 for the fuel pump relay. No 15A fuses in the vicinity

Sep 25, 2012 | Cars & Trucks

2 Answers

20 amp fuse keeps blowing engine won't start, fuse


I am a mechanic,i had that same problem where my engine 20amp fuse were blowing....i fixed it...problem were a broken wire in the harnace on the side of the cylinder head....i made over $200 on that job...yahhh

Aug 01, 2011 | 2001 Mitsubishi Galant

1 Answer

Engine management fuse keeps blowing


My car stopped running without any warning, its a 2005 ford focus, 2.0 and the 20 amp fuse for the engine management keeps blowing, it's number 9 in the panel and I have replaced it twice, both times it blew again, any tips? Also the odometer reads ------ and that's it.

Jan 09, 2010 | 2001 Ford Focus

1 Answer

My 20 amp fuse for my radio, cd player, and clock keeps blowing?


I had the same problem, with the blowing fuses and all. I solved this by re-routing the wires to a new power source, and of course it should be equiped with a fuse, try that and if not take the car to a mechanic and see if he can find the wire that is live and bare. Normally this happens when a live wire touches gound somewhere on your car can causes the fuse to blow, hope I helped a bit...

Aug 12, 2009 | 2003 Toyota Corolla

1 Answer

Wiper fuse keeps blowing intermittently.


It looks like the wire circuit for the wiper motor is touching the car body when shaken so the only thing you can do is shake the wires and terminals yourself while engine is running then maybe you can pinpoint where the earthing is.

May 08, 2009 | 2001 Hyundai Accent

1 Answer

Keeps blowing #11 fuse and car quits rumming


there's a grounded wiring on it that's why it keep on blowing your fuse check the wiring.

Apr 17, 2009 | 1998 Jeep Cherokee

Not finding what you are looking for?
1997 Chrysler LHS Logo

Related Topics:

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...