Question about Fiat 124

1 Answer

I have a fiat bravo 1999 with a fuel gauge that reads empty and has warning light on all the time. even when half full it still says the same. scond problem is temp gauge reading fluxuaets the only way to stop this is to push the trip knob to reset temp gauge.. any help please ..

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Fiat Master
  • 17,129 Answers

It looks as though there is a ground fault in the dash board cluster. You might have to check for fault in the connectors, maybe cracks in the board assembly or a harness issue.
Must remove to havea closer look into this section before we can speculate.

Posted on Sep 11, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel gauge not correctly reading full


Sending unit is bad its float thats in the tank reads to the gauge very rare that it will be the cluster its self could even be a ground in some cases

Feb 11, 2016 | 2006 Mitsubishi Outlander

1 Answer

How to adjust gas gauge to read right not reading way over filled like it does now. When 1997 chev 350 vortec truck gauge is at 1 st red mark close to empty, better not past gas station ! ! !


the fuel level sender is inside the fuel tank, part of the fuel pump assembly. did you or was the tank replaced before??they may have bent the float arm on reassembly . you can buy the sender from your parts supply store .you will have to drop the tank to do this it clips onto the side of the pump assembly. run it almost dry first as the tank is big n very heavy even 1/4 full. you can try to bend the old arm

but its very hard on the "sender" as for level indicator full to empty, think of the shape of the tank narrow at top to widest point in the middle (full to half) wide middle to narrow bottom( half to empty)

its just an overall volume thing

Mar 07, 2015 | 1997 Chevrolet C1500

1 Answer

Chrysler sebring gauge


The fuel gage problem is either from a bad ground to the gage or the sending unit in the tank is bad. They will normally read a half tank or less when the car is full if the sending unit goes bad. I would put a scanner on the computer and check for any codes set.

Apr 22, 2017 | Cars & Trucks

1 Answer

Fuel gauge reads correctly then goes to empty


9 times out of 10 the fuel pump/level sender assembly is the cause. Sometimes the gauge pod is faulty, and there have been cases where there were either poor connector pin fit issues and/or chaffed/melted/cut wires in the harness that leads back to the fuel pump. It is an extremely common fault and would be surprised if the pump/level sender assembly wasn't the cause.

I hope this info helps!
~subyguru~

Sep 21, 2012 | 1999 Pontiac Grand Am GT

2 Answers

Gmc jimmy 1999, fuel gauge reading empty, even


the sending unit in the tank has gone bad or a wire is grounded out.

Feb 06, 2010 | 1999 GMC Jimmy

6 Answers

2002 pontiac montana fuel gauge


It needs a tank meter I'ts in the fuel tank

Aug 27, 2009 | 1999 Pontiac Montana

2 Answers

2002 Chevy Suburban: Fuel gauge reads empty, tank is half full


Youre gauge is controlled by a plunger in the fuel tank which is attached to the sensor and the fuel gauge. it sounds like when the plunger goes down half way its either getting stuck down lower then it should. Needs replacing. Any mechanic can do this install for you.

Aug 27, 2009 | 2002 Chevrolet Suburban

1 Answer

1993 Jeep Grand Cherokee gas gauge reads empty but tank is full.


Fuel level sending units are known to go bad on these.

Jun 13, 2009 | 1999 Jeep Grand Cherokee

2 Answers

Fuel gauge not working all the time.


This is a normal concern.
The instrument cluster uses 4 different operating modes to calculate the fuel level:
Anti-slosh (default mode)
Key OFF fueling
Key ON fueling
Recovery
After a fuel fill up, the time for the fuel gauge to move from empty (E) to full (F) ranges from 2 seconds to 55 minutes depending on which operating mode the fuel gauge is in.
The default fuel gauge mode is called the anti-slosh mode. To prevent fuel gauge changes from fuel slosh (gauge instability due to changes in fuel sender readings caused by fuel moving around in the tank), the fuel gauge takes approximately 55 minutes to go from empty (E) to full (F).
The key OFF fueling mode (2 seconds to read empty [E] to full [F]) requires 3 conditions be met:
The key must be in the OFF position throughout the entire refueling of the vehicle.
At least 15% of the vehicle's fuel capacity must be added to the fuel tank.
The instrument cluster must receive a valid key ON fuel sender reading within 1 second of the key being put into the RUN position. The key ON sample readings are considered valid if the fuel sender reading is between 15 ohms ± 2 ohms and 160 ohms ± 4 ohms.
If these conditions are not met, the fuel gauge stays in the anti-slosh mode, which results in a slow to read full (F) event.
The key ON fueling mode (approximately 90 seconds to read empty [E] to full [F]) requires 3 conditions be met:
The transmission is in PARK (P).
The key is in the RUN position.
At least 15% of the vehicle's fuel capacity must be added to the fuel tank.
In key ON fueling mode, a 30-second timer activates after the transmission is put into the PARK (P) position (automatic transmissions). When the 30-second time has elapsed and at least 15% of the vehicle's fuel capacity has been added, the fuel gauge response time is 90 seconds to read from empty (E) to full (F). When the transmission is shifted out of PARK (P), the fuel gauge strategy reverts to the anti-slosh mode. The key on refueling mode prevents slow to read full events from happening if the customer refuels the vehicle with the key in the RUN position.
Recovery mode is incorporated into the instrument cluster strategy to recover from a missing fuel level input during a refueling event. Missing fuel level inputs result from intermittent opens in the fuel sender or its circuits. Recovery mode (empty [E] to full [F] approximately 20 minutes) is initiated when the following 2 conditions are met:
The instrument cluster is in the anti-slosh (default) mode.
The actual fuel level in the tank is greater than what is being displayed by the fuel gauge

Feb 18, 2009 | 1983 Mercury Grand Marquis

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

344 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fiat Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Fiat Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...