Question about 2003 Mitsubishi Lancer

Open Question

How to replace the fuel tank and filler neck - 2003 Mitsubishi Lancer

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 5 Answers

SOURCE: Is a 2000 Dodge Grand Caravan fuel filler neck usable in a 1999?

yes it will swap and you have to remove it from the bottom of the van remove the screw/clips from inside the filler door and then from underneth disconect the filler tube ti tank and the vent hose to the tank i belive there is a bracket also holding the filler tube to the body with one bolt then it snakes out of the va r insalating is just reverse

Posted on Jun 25, 2009

scottyoung56
  • 89 Answers

SOURCE: gas cap is contacting inside of filler neck

YES IT CAN FROM THE RUBBER HOSE UP TO WHERE YOU PUT THE GAS IN

Posted on Aug 08, 2009

jim9813
  • 124 Answers

SOURCE: Replacing fuel filler neck on 2000 Crown Vic

Good news, no the tank doesn't have to come down. However, there needs to be less than 3/4 tank. Jack it up and set on a jack stand, remove the wheel, four screws housing to pipe, filler pipe sensing hose from filler pipe, screw retaining the cap, four retaining screws from filler pipe, screw from filler pipe retainer, slide into the tank until it can be rotated and pulled out through the fender. lube the tank grommet with clean oil and reverse the removal for install.

Posted on Aug 21, 2009

wireguy212
  • 1627 Answers

SOURCE: gas filler neck replacement

open the fuel cover and remove the bolts.Remove the ground strap from the filler tube from under the car.Remove the hose clamps to the rubber hose going into the tank and pull off the hose.Now the filler tube will come out[ if has'nt already fallen out and hit you in the head].

Posted on Nov 18, 2009

  • 1779 Answers

SOURCE: Can not fill 2002 Ford Explorer with gasoline.

Did you check the vent tube alongside the filler neck? If it is pinched or blocked with something, just what you describe will happen. The air in the tank needs some way to escape to make room for the gas, and it should be through the vent tube. If it's bent, pinched, blocked, you will have a hard time pumping gas in.

Posted on Dec 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there a way to change the Fuel Tank Filler Grommet without removing the fuel tank?


take filler neck loose at the fuel door this will give you just enough room . you have to slide the filler neck inside the tank enough to get it out of the fuel door compartment then you can turn it and wiggle an jiggle till you get out

Jun 26, 2010 | 1996 Ford Mustang

1 Answer

Gas filler neck replacement


open the fuel cover and remove the bolts.Remove the ground strap from the filler tube from under the car.Remove the hose clamps to the rubber hose going into the tank and pull off the hose.Now the filler tube will come out[ if has'nt already fallen out and hit you in the head].

Nov 18, 2009 | 1997 Oldsmobile Cutlass Supreme

1 Answer

How do I replace a fuel pump on a 1995 ford aerostar


drain all the fuel you can from the tank, SAFELY using proper saftey equipment, place the vehicle on jack stands, disconnect the battery, place a jack under the tank, remove fuel cap, remove 3 screws holding filler neck to the inside of fuel filler door compartment, remove tank straps, remove driveshaft, lower tank slightly & remove fuel neck, wires, fuel couplings, lower tank & remove from vehicle. Carefully remove locking ring from the tank where it holds down the fuel pump asy, remove pump asy & replace components as needed, reassemble, check for leaks, road test vehcile

Nov 02, 2009 | 1995 Ford Aerostar

4 Answers

Gas leak on fuel filler neck, how can I fix this?


if it's a hose or pipe go to dealer or junk yard get another if broken clamp replace if neck part of tank call rad shop see if the can solder if you drain & pull tank

Aug 30, 2009 | 1995 Buick Regal

1 Answer

Replacing fuel filler neck on 2000 Crown Vic


Good news, no the tank doesn't have to come down. However, there needs to be less than 3/4 tank. Jack it up and set on a jack stand, remove the wheel, four screws housing to pipe, filler pipe sensing hose from filler pipe, screw retaining the cap, four retaining screws from filler pipe, screw from filler pipe retainer, slide into the tank until it can be rotated and pulled out through the fender. lube the tank grommet with clean oil and reverse the removal for install.

Aug 21, 2009 | 1996 Ford Crown Victoria

1 Answer

HOW DO I REPLACE THE FUEL PUMP ON 2003 CHEVY S10 PICK UP


Removal & Installation To Remove:
  1. Properly relieve the fuel system pressure.
  2. Drain the fuel tank through the filler pipe.
  3. Support the fuel tank.
  4. Remove or disconnect the following:
    • Negative battery cable
    • Filler neck
    • Shield and tank straps
    • Fuel lines and vapor hose from pump and tank
    • Electrical connection from fuel pump
    • Fuel tank
    • Fuel pump/sending unit assembly by turning the locking ring (located on top of the fuel tank) counterclockwise using a spanner wrench
    • Fuel pump from the fuel lever sending device
To Install:
  1. Install or connect the following:
    • Fuel pump in tank with new seal around opening
    • Tank and connect fuel lines and vapor hose
    • Tank to the frame
      1. Torque to: 33 ft. lbs. (45 Nm)
    • Shield
    • Fuel filler neck and clamp
    • Negative battery cable
  2. Refill the tank.
  3. Run the engine and check for leaks.
1e2538e.gif

Jun 26, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

Fuel tank components


You will need to get the numbers off the fuel tank to verify which one you have, there is no other way, the numbers are large and on the bottom of the tank.

Mar 03, 2009 | 1996 Mazda Pickup

1 Answer

Fixing a leak between the fuel tank and the fuel filler neck


your best bet is to replace the fuel filler neck. the entire fuel system is a calibrated emissions system, meaning any changes to the specific setup may set a check engine light. you should be able to purchase a new fuel filler tube at your local dealer, not sure if parts stores carry those kind of parts. but you can try them too.

Feb 21, 2009 | 2004 Lincoln Town Car

1 Answer

CANT FILL GAS TANK FUEL BACKING UP


You will need to replace the filler neck, the vent hose inside the filler neck gets kinked and causes this problem. The air can not vent back out of the fuel tank as you fill it.

Sep 27, 2008 | Ford E-250 Cars & Trucks

Not finding what you are looking for?
2003 Mitsubishi Lancer Logo

Related Topics:

219 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...