Question about Jaguar XJ

Open Question

Is there a 1996 x300 jaguar wiring diagram? - XJ Jaguar Cars & Trucks

Posted by on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 100 Answers

SOURCE: jaguar x300 central locking problem

If the locks are working whilst you are driving then more and likely it is the actual door lock assy that is bad. the solenoid go bad and can cause erratic operation. But unfortunately they are only available with the whole door lock/latch assy.
I would disconnect the drivers and see if the problem still exists.
JPTCAT

Posted on Sep 22, 2008

alicantecoli
  • 22095 Answers

SOURCE: reset fault code on 1996 jaguar x300

dealer only sorry

Posted on Dec 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 jaguar xj6 will not start no response on remote suspect security system. any thoughts?


does the check engine light go off after a few seconds of swiching on without cranking engine?if so i suspect your car is a X300 model if so a common cause of this is a corroded/open circuit wire in or around one of the connectors under bonnet/hood at rhf around or below the washer bottle filler behind headlamp i think it was yellow/white wire in a white connector. its the ok to start signal coming from the security and locking module which is under the boot/trunk fuse box which can fail also if you get a wring diagriam for engine managment system that would make the job a lot easier i gave mine away when i retired otherwise i could have emailed the relevant part good luck

Jan 27, 2017 | Jaguar XJ6 Cars & Trucks

1 Answer

Jaguar x300 4.0 soveriegn alarm siren location


under the left hand front wheel arch area,

Oct 27, 2014 | 2000 Jaguar S-Type

1 Answer

My XJ6 jaguar won't start has a new battery


problem with security locking module located in boot fuse box. a simple check switch ignition on, the check engine light should stay on, it should only go out when engine starts. if it goes out with the other lights check for water ingress or poor connections on the ecm module,located o/s lower A post. a common problem was corroded wiring under the bonnet front o/s. under the washer bottle filleri assume this is a x300 car hope this helps.

Jan 06, 2014 | 1996 Jaguar Xj Series

1 Answer

Car stuck in theft mode, how do i get it out?


if your car is a 6 cyl. x300 see if the check engine light goes off when the ignition is switched on it should stay on until the engine starts, if it goes off with just ign. on, the ecm relay is not geeting the ok to start signal from the security/ locking module, the relay is located under bonnet front right the wiring to this relay is prone to corroding under the relays

May 06, 2013 | 1996 Jaguar Xj Series

1 Answer

I have aJaguar X300 series late 1996 xj 4L soveriegn and the button on the boot lid doesnt open it .The fob will open it but not the button.


Sounds like you have a faulty button switch or bad wiring, since the solenoid and micro switch seem to be working ok with the fob. Keep in mind, There is no manual release switch for these.
I hope this helps.

Jul 07, 2011 | Jaguar XJ6 Cars & Trucks

3 Answers

1997 Jaguar XJ6 will not start. new battery still wont start, good stater. what do i check now


crank relay on the front pulley or ignition module under the coil ,it has to one or the other

Dec 23, 2010 | 1997 Jaguar XJ6

2 Answers

My1995 jaguar xj6 x300 3.2ltr misfires on tickover


i have a 1995 jaguar xj6 3.2ltr.x300 model.the car has been running fine until yesterday morning when it wouldnt turn over at all.the battery is fully charged and now there is no dashboard lights.please help.cheers.

Sep 15, 2010 | 1995 Jaguar XJ6

1 Answer

96 jaguar 4.0 6 cylinder wont start from cold..but


Check to see if it has a cold start injector, and check the coolant temp sensor.

Mar 05, 2010 | 1996 Jaguar Xj Series

2 Answers

Jaguar x300 central locking problem


If the locks are working whilst you are driving then more and likely it is the actual door lock assy that is bad. the solenoid go bad and can cause erratic operation. But unfortunately they are only available with the whole door lock/latch assy.
I would disconnect the drivers and see if the problem still exists.
JPTCAT

Sep 06, 2008 | 1994 Jaguar XJ6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

185 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75117 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...