Question about 1999 Nissan Pathfinder

1 Answer

At a stop light the car suddenly stopped. The starter continued to crank but would not start and run. After about 20 minutes the car started and ran.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 197 Answers

Sounds like your selonide is sticking. Replace selonide or clean the one you have to get grease and dirt off.

Posted on Sep 11, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car shuts of suddenly while driving. Starts back up after 20 minutes.


When the gas-cap is plugged, you build up vacuum in the gas- tank and cause the gas flow to stop.
Use premium gas only, ETHANOL in the mix is attracting moisture/water which is part of the problems.

Jun 26, 2015 | Cars & Trucks

1 Answer

I have a Diesel 4WD Grand Vitara. Was driving normally and then all of a sudden it would not start. Previously when I tried to start it there was a little whirring noise and then when the light sequence...


you failed to say, does crank, when it don't start?
and btw, the fuel pump on most cars only run cranking or running
some run for 3 seconds, key on, but you'd miss that fact. using
only one person.
the key word here is crank, does it crank as full speed, via the cranking starter motor. that is the engine cranks spins fast.
on this car it will spin min 250 RPM, cranking, and uses large
battery current , so on diesels it takes a very strong battery to start
and working glow plugs.

Feb 21, 2014 | Suzuki Grand Vitara Cars & Trucks

1 Answer

Car has no power to start


If you turn the key and the engine does NOT crank over (try to start) then test to see if the battery has any power. Turn the headlights on and if they come on strong then your battery is good and something is wrong with your starter. If the lights do not come on strong then your battery is empty. You will need a jump start using cables. After that run the car for 15-20 minutes without stop. If it will not even run after the jump start then your alternator is bad. After running it for some time turn the car off and try to restart it. If it starts your battery is still working. If the car will not start again after running it for 20 minutes then you need a new battery because your old one is not charging up anymore.

Nov 14, 2013 | 1999 Pontiac Sunfire

2 Answers

03 grand am 3.4l no crank at all. All the light on dash work good fuel pressure starter spins and engine starts and then stalls when jumping the starter directly installed new pass lock switch and...


If the Passlock switch has been replaced, the computer has to "learn" the new Passlock code. You will need to hook up a battery charger to perform the learning process. (It takes about 30 minutes with the key in the "ON" position and it will run the battery down.)

Step 1:

Turn the key to the "START" position and release to the "RUN" position. The "SECURITY" light will be flashing. After about 10 minutes, the light will stop flashing.
.
Step 2:

Turn the key "OFF" then back to the "RUN" position. (Do NOT try to crank it yet) The light will start flashing again. Wait about 10 minutes for it to stop flashing.
.
Step 3:
.
Turn the key "OFF" and back to "RUN" one last time. The light will be flashing again. This time, when it stops flashing, do not turn the ignition off. Instead, turn the key from the "RUN" position to "START". The engine should start and run. The computer has now learned the new Passlock code.

Please help myself and others by taking the time to rate my answer. Thank yoou for using fixya!

Feb 08, 2011 | 2003 Pontiac Grand Am

1 Answer

The car wont again start after driving it any for about 20


I HAD SAME PROBLEM, ENDED BEING CRANK SENSOR GETTING WEAK, AFTER HOT THE CRANKING SIGNAL IS TO WEAK TO TRIGGER FIRING.

Feb 13, 2010 | 1995 Toyota Camry

2 Answers

1991 chevy lumina 3.1 liter.problem started it was fine then went 3 blocks and it died stopping at sign.had problems getting it back started and it drive fine for a minute and lost power to like 20 mph but...


It is one of 2 things fuel pump or Crank Shaft Position Sensor. Best bet would be the Crank Shaft Sensor, and what that does is tell the computer where the crank is and when to fire the right plug at the right time

Feb 18, 2009 | 1991 Chevrolet Lumina

1 Answer

ABS light and pump


after you took the fuse out and it stopped did you put the fuse back in and see if it continued to run?

Sep 02, 2008 | 2002 GMC Yukon XL

Not finding what you are looking for?
1999 Nissan Pathfinder Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...