Question about 2000 Chevrolet Venture

1 Answer

My tail lights have stopped working. left blinker is working but very dim

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 749 Answers

A common issue are the boards that the tailights and brake light bulbs plug into But you may want to check and make sure that all your other parking lights come on just to make sure a fuse didn't blow on you. Before doing anything else with the boards check those particular bulbs out to make sure didn't burn out on you.

Posted on Sep 11, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
dgjtex
  • 405 Answers

SOURCE: left blinker light stays on solid when headlights are on

I have had this happen and it is rare, but I have had a filiment burn out in a two filment buld and short to the other filiment. It does happen and I think this might be your problem, the only way to find it is a visual inspection of each bulb. I am sure many people will think this is crazy, but I have had the exact same problem, I had the schematics, tested the circuits,etc. and them by accident found a stop/blinker 1157 bulb that had done this exact thing. I hope this helps you, check the bulbs in your headlights also.

Posted on Dec 27, 2008

  • 26 Answers

SOURCE: left rear tail lights/ blinker will not come on

Blinker too fast, the same side blinker light bulb on the front (or back) is burned. Check the fuses for the rear lights. You might have a light bulb filament stuck.

Posted on Apr 02, 2009

  • 5 Answers

SOURCE: Brake lights and Tail lights not working.

you might need to get new wiring done to the lights because there either riped or old

Posted on Aug 26, 2009

pumpkinman
  • 1147 Answers

SOURCE: I don't have tail lights blinker very dim and

You either have a short in that part of the electrical or a bad ground..

Posted on Sep 20, 2009

  • 112 Answers

SOURCE: NO LEFT SIDE TAIL ,STOP OR BLINKER REAR LEFTLIGHT

did you try to replace the bulb in the back normally when it blinks fast like that its just the bulb and its doulbe film thats why the brake and blinker dont work

Posted on Dec 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ok i have a 1995 sonoma highrider and im suspecting a bad relay for my tail lights because when i turn on my blinker on the left or right side and hold the brakes the tail lights dim out and the indicator...


dimming lights are a usually a ground issue. find all the body grounds loosen them give them a good wiggle or clean them with sand paper then tighten them back down.20 years to slowly corrode
i'd start there. relays are just low draw electro magnets that contact to allow high draw current thru......they either work or they dont.

Mar 07, 2015 | 1995 GMC Sonoma

1 Answer

2001 DODGE DURANGO RT REAR TAIL LIGHT OUT AND FRONT LEFT HEADLIGHT GOES OUT BUT TAP HEADLIGHT AND IT COMES BACK ON


Check the harness connection for trailer hitch lights near back bumper in chassis rail. launching a boat gets this connector corroded.

May 17, 2017 | Dodge Durango Cars & Trucks

1 Answer

Can not get my tail lights to work onk 1989 gmc truc


The front park lights work correct? If the front park lights work than there is not a problem with the light switch since the brown wire from the switch supplies power to the front park lights, front side markers, and the rear taillights. There should be twelve volts on the brown wire from the headlight switch with the connector plugged in and the park lights turned on. If this is true that there is a problem with the wiring to the back of the vehicle. A thorough inspection of the harness should reveal the problem. The dim break and blinkers support the above. High resistance also know as corrosion, in the wires or connections would cause this problem.

Aug 24, 2012 | 1989 GMC Sierra

1 Answer

I have pontiac montana and the shop i got it from replaced and or riged the wire harness. recently both blinker lites are always on, on the dash. and when i push on the brakes my brake lites dont work and...


check for a bad ground wire for the tail lights. You are looking for a black ground wire near the bottom of the left rear corner of the car, inside. you may need to take the trim panel off to find it. if you take out the left tail light you should be able to follow the harness to where the black wires come out and a terminal is screwed to the body. turn on the hazard lights and when you get near the problem the lights will brighten and dim.

Aug 26, 2011 | 2000 Pontiac Montana

1 Answer

Tail lights donot work blinker very dim break light very dim on my 1971 malibo chevy


Check the grounds on the tail light sockets. If necessary re-ground them using a separate wire attached to a clean spot on the chassis.

Jun 28, 2011 | Chevrolet Malibu Cars & Trucks

1 Answer

My HJ75 landcruicer ute has an electical issue. rear indicators, brake lights and reverse lights work fine until the parking lights or headlights are turned on. The rear left hand lights are then working...


Almost certainly a bad earth in your left hand rear light somewhere.
Clean the earths up REALLY well, ( like silver shiny metal ) and put a new end on the wire to be sure.
You can test it by grounding one end of an extra wire on a really good contact point on the chassis and getting someone to hold the other end on the common earth contact for your rear left blinker, stop light, reverse light and tail light while you try it again.

Definitely not getting a proper earth somewhere.

I have also seen a whitish corrosion on the bottom of the bulb itself, and in it's socket, cause the exact same symptoms.

If there is evidence of water in the taillight lens, go for the bulbs and their sockets first. Clean, clean, clean.

Oct 15, 2009 | 1987 Toyota Land Cruiser

2 Answers

Brake lights and Tail lights not working.


easy one this ....... check all the earth/ground wiring to the car chassis.

Aug 26, 2009 | 1998 Mercury Villager

1 Answer

Left rear tail lights/ blinker will not come on


Blinker too fast, the same side blinker light bulb on the front (or back) is burned. Check the fuses for the rear lights. You might have a light bulb filament stuck.

Mar 30, 2009 | 2006 Dodge Charger

Not finding what you are looking for?
2000 Chevrolet Venture Logo

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...