Question about Chevrolet S 10

1 Answer

Where is THE AIR INTAKE SENOR LOCATED - S 10 Chevrolet Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 22 Answers

Should be on the air intake tube or in that black box on the right side of engine compartment at front. thats right from cab lookig out windshield.

Posted on Sep 11, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whaer is the rear senor location


There is no rear sensor they got 02 sensors map sensors air intake sensors..what rear on top or under the car you mean by rear

Jul 03, 2014 | 2006 Jeep Commander

1 Answer

98 chev silverado..........stops running when the air temp is 90* and above. acts like it just runs out of gas. set for 15 min and runs fine.


if you can see the data of pcm the coolant senor could be out of range.or the map sensor itself located on intake manifold defect when getting hot

Aug 29, 2013 | GMC Cars & Trucks

1 Answer

When i started my madaz b 2300 truck up the engine idle up high and i had to switch the engine off.after that time i had trouble with the engine running ,when i started the engine it idle good for 15


may be you should make a diagnostic and you can do it in a garage or you can do it by yourself if you want to do it by yourself you need some tools and you can find some good ones here: chinasinoy.com

Feb 20, 2013 | Cars & Trucks

1 Answer

Engine stalls going down the road, then starts right back up


Possibly - Mass Air Flow Sensor, poor oxygen mix
Possibly -Air Intake Sensor at Intake manifold, clean with carb cleaner.
Possibly - Crank Shaft Positioning Magnet, not aligning properly
Possibly - Oxygen senors, 1 before catalytic and 1 after it, poor exhaust eventing stemming from clogging catalytic converter
Possibly - Clogging in fuel delivery system starting from fuel pump and ending at intake manifold.

I would check these in that order.

May 27, 2012 | 2000 Pontiac Grand Prix

1 Answer

Where is the air temperature senor located on 1994 Subaru Legacy


They are usally in the air intake tube going to the throttle body.

Jan 19, 2012 | Cars & Trucks

1 Answer

My car will not start, I replaced the starter, replaced the battery 2 months ago, I replaced the mass air flow senor,crank shaft senor and modulator? When you try to start it, it shudders and will not...


That still could be a number of things. Fuel pump, O2 sensor, Ignition coil, etc. A good way to find out if its a fuel or electrical problem is to get a can of starter fluid. Open the air intake and spray a little inside and see if it starts. If it does not, then you have a spark or sensor problem. If it does start, then you have a fuel problem.

Nov 21, 2010 | 2000 Buick LeSabre

1 Answer

I need to locate the air senor switch in a 2008 ford fusion


The mass air flow sensor is in the air intake tube at the lower left corner of the engine compartment. Please rate this info That will help me THankyou RJ

May 30, 2010 | 2008 Ford Fusion

1 Answer

My service engine soon light came on displayin po170. i have a mitsubishi galant 2000. how do i fix this problem


PO170 is a fuel trim malufunction. On a V6 this applies to the rear cylinder head. Lots of possibilities as fu"el trim" refers to the volume air flow sensor, fuel injector, fuel pressure, engine coolant senor, air intake sensor, barometric pressure sensor, oxygen sensor, intake air leaks, or cracks in the exhaust manifold

Mar 03, 2010 | 2000 Mitsubishi Galant

1 Answer

Map Senor location?


Hi,

Do not forget to accept the solution, if 100% satisfied with my solution.

Location -
MAP sensor is usually located near the intake manifold.

Diagrams

164514c.jpg

9a141c3.jpg

Let me know, if need further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Oct 09, 2009 | 1992 Buick Regal

2 Answers

Check engine light on - did computer check - knock senor bad - where is it located


depending on what engine it is most kias knock sensor are located under the lower intake manifold takes about 3 hours to get to it

Jul 04, 2009 | 2003 Kia Rio

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...