Question about Ford Ranger

1 Answer

My truck keeps blowing the engine comp lp fuse its a 1992 ford ranger with a 2.3 i was wondering what that stood for and where it goes to

Posted by on

  • tylor1992 Sep 10, 2010

    my truck does not have either one of those lights

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,600 Answers

Its the complementary light for the hood open the hood and look to see if the light bulb for the engine is burned out if it is replace it. The light is on a cable that rolls up into a box when your done with it. And is used for inspecting the engine at night.also could be the curtsy light for the mirror on the passenger side sun visor.

Posted on Sep 10, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1987 ford ranger turn signals keep blowing fuses. have changed flasher fuse and switch on column. just keeps blowing?


first thing i guess to understand what is going on here ,is a little back to basics on how turnsignals work , first item you have is power fuse then it's off to flasher module than it goes to the turnsignal switch on colum ,of course anywhere on it way to there the power could got to ground and cause the fuse to trip, now the power depending on Left or right selection , is directed to lights on both front and back of truck,thankfully rangers don't have em on the side) now any place in this pathway the wire could go to ground and blow the fuse, now to troubleshoot and narrow down the area that fault is located , (1) replace fuse with correct size and ck for proper fit in fusebox and start and operate truck for a few minutes DO not use turnsignals, ck fuse is it still good if so go to step 2 if not stop and ck wire conditions in steering colum and switch(2) start truck and try right hand turn signal only verify lights working ,Ok yes/no if not replace fuse and try left side same way, Ok yes /no if right or left side only blows fuses take ALL bulbS OUT of lights and try again , if fuse still blows then look for wire fault on that side of truck if fuse is still good then look carefull at light bulb sockets for rust and powered corrosion (ill bet an 87 has some ) you may need to replace bulb sockets , they do sell em in autoparts stores .

Jun 30, 2014 | 1987 Ford Ranger

1 Answer

Why does my fuse for fuel pump keep blowing on 1992 ford ranger even after i replaced relay thinking that was the part needed?


the power wire to your relay or pump is very weak or grounding take a reading with an ohm meter continuity one lead from fuse other on ground

Mar 26, 2012 | 1992 Ford Ranger

1 Answer

1992 ford ranger alternator keeps blowing fuse when starting,


fuse for what, give the fuse number and whewre does it located

Sep 13, 2010 | 1992 Ford Explorer

1 Answer

Is there a fuse for the check engine light on 1992 ford ranger


Generally it will be the same fuse as the cigarette lighter.

Sep 05, 2010 | 1992 Ford Ranger

1 Answer

Where to start looking for a short in a 1992 ford ranger. keeps blowing the fuse that runs the dash lights and the tail lights ..first it blew .i replaced .was fine till next night .turned on lights...


connector under the truck, near the trans
cannot remember specifics at this time but remember starting there every time one cam into the dealer with tail light issues and blown fuses

Jun 17, 2010 | 1992 Ford Ranger

3 Answers

Looking for a fuse diagram for a 1992 ford ranger.


tail lights wont come on my 1992 ford ranger xlt but brake lights and back up lights work also instrument panel lights wont come on

Jan 15, 2010 | 1992 Ford Ranger

1 Answer

What fuse goes to the radio and interier light in a 1992 ford ranger


it will be in your owners manual or on the fuse cover lid

Nov 22, 2009 | 1992 Ford Ranger

1 Answer

1992 ford ranger wiper wont work wiper pump not working fuse ok?


check wire continuity with multimeter, have had switch go out on ranger as well.

Apr 05, 2009 | 1992 Ford Ranger

1 Answer

Hi i have a question


you need to get a used one out of a junkyard and just reconnect the wires. alldata also has a great site for wiring

Sep 10, 2008 | 1992 Ford Ranger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...