Question about Toyota Cressida

1 Answer

My 91 cressida keeps dying at stops and will shut stall and not re start all together when it is hot. has new plugs wires, distributor cap and rotor, any suggestions would be appreciated. Maybe fuel pump or fuel filter???

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 228 Answers

Sounds like ignition module or coil.check for weak spark to the spark plugs when engine is warm. it should jump at least a 1/4 inch gap.

Posted on Sep 10, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

HOW CAN I STOP MY 1986 MORGAN 4 X 4 MISFIRING AND DIFFICULT TO RESTART WHEN HOT


Plugs, plug wires, distributor cap, rotor button basic tune up is where to start.

Jul 19, 2016 | Morgan Cars & Trucks

1 Answer

Drives for a little then cuts off 30 min later starts then dies


could be
Starter
Spark plugs
plug wires
Distributor cap and rotor
Ignition control module
Ignition Coil
Fuel Filter

Feb 16, 2016 | Cars & Trucks

1 Answer

I have a 91 chevy sliverado 1500 heavy 1/2 ton 5.7 liter 350, and it's hard to start, it has an extreme hesitation and stall and when its at idle. I've replaced tps sensor, spark plug wires, distributed,...


Check the distributor cap and rotor for one. GM has issues with moisture inside the distributor and corrosion in the wiring going into and out of the distributor.

Nov 16, 2014 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

Car died while stooped at light


if it won't run on starting fluid then you have a no spark issue. i'd check spark out of the coil to the distributor. you could have a bad ignition control module or coil

Apr 18, 2014 | 1986 Toyota Cressida

1 Answer

My car will run fine till it gets hot it will stall then it want start till it sits for thirty minutes then it will start then


Replace hall effect pick up plate in distributor. Remove distributor cap, and rotor. Black round plate under rotor is the pick up. Remove it, unplug wiring, align it same as old one and install new, plug it in, replace rotor and cap. It was a common problem for those.motor1258_16.jpg

Apr 10, 2011 | 1989 Plymouth Reliant

1 Answer

My 91 gmc vandura 3500 skipping/stalling/bogging


It clearly sound as though your timing chain is stretched and should be replaced soon. Thanks' Dana

Sep 30, 2009 | 1991 GMC G3500

1 Answer

Car stalls


Hello and thank your for choosing fixya.com. I suggest changing the fuel filter and air filter to begin with. If that doesn't fix it, you may have a couple of plugged fuel injectors, or you may need to replace the coil pack and modular or distirbutor cap and rotor (whichever is equipped); either one, it is a good idea to also change the spark plugs and wires. Coil packs can be tested to determine whether they're good or not. Distributor caps and rotors will have obvious damage that will indicate the need for replacement. Modulars may have a melted, or bubbled look to the material on top of them (coil pack(s) ) removed. If the modular is bubbled, replace it, keeping the original coil pack(s) and try that - also, if equipped with a distributor; before replacing cap and rotor, make sure that the coil wire is secure at both end. (it will be the center wire in the distributor cap) and runs to the coil.
Please let me know if you need further information or have any other questions or comments. Thank you again for choosing fixya.com.

Apr 01, 2009 | 1996 Mercedes-Benz C-Class

1 Answer

Dies


Bad coil or Igniter

Aug 12, 2008 | 1983 Toyota Cressida

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

239 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...