Question about 1991 Honda Accord

1 Answer

How do i clean the air idle control valve on a 1991 honda accord stand shift

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 5,763 Answers

You need to unbolt it from throtlebody, disconnect connector, then remove the coolant hoses to it, then clean with throtlebody cleaner, ive found that this doesnt work to often on these honda that use the coolant to also control the idle with electrionics, but give it a try, hope this is helpful.

Posted on Sep 10, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1991 Honda Accord Miss-fires dies


I would try replacing the ignition control module and the distributor pickup as the next most likely cause of this problem. Also I would do the following

This problem can be caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control



Jun 20, 2012 | 1991 Honda Accord

1 Answer

1991 HONDA ACCORD EX REALLY HIGH IDEL


High idle conditions could be a result of low coolant levels causing the fast idle valve under the throttle body to catch air and not operate accordingly as it needs pressure built once car is warmed up to close the gap of allowed air passage reslting in lower idle at time engine reaches operating temperature. Or the valve could simply

Jan 08, 2011 | 1991 Honda Accord

1 Answer

91 honda accord engine surges until its warmed up


You need to remove the idle air control valve(s) and clean the carbon deposits out with either mineral spirits or paint thinner and a tooth brush. There are two separate parts to the idle control system and they are connected together by hoses. The main valve has an electric motor, but the rest is a hallow system that needs cleaned - one of holes has a screen filter that has to be cleaned with a tooth brush - the rest can be soaked in mineral spirits - just make sure the electric motor section of the part does not get sumbmerged in the mineral spirits. The second part is simply a valve and can be completely submerged in the mineral spirits. The valves are located on the front vertical side of the fuel injection block behind the engine's valve cover.

Feb 21, 2010 | 1991 Honda Accord

1 Answer

My 1986 honda accord runs at a high RPM when cold and dies when its warm


i'm really not familiar with the older hondas but if you've got an idle air control valve yours is a common symptom of a faulty idle air control valve. check the wiring to it and make sure the connector is clean and tight. if the wiring and connector is good i'd recommend replacing the iac valve.

Feb 08, 2010 | 1986 Honda Accord

1 Answer

Erratic idle surging at idel and in gear 91 honda accord LX


Sounds like an idle air control valve issue. these can stick open and cause surging. That would be my first step.

Mar 24, 2009 | 1991 Honda Accord

2 Answers

92 Honda Accord hard start when cold


also check the fitvalve... may need opening and cleaning the spring mechanism

Dec 18, 2008 | 1991 Honda Civic

2 Answers

1998 HONDA ACCORD EX V-6


It may be the throttle position sensor (tps)

Oct 10, 2008 | 1998 Honda Accord

3 Answers

Idle problem


How much is the Idle Air control valve?

Jul 27, 2008 | 1991 Honda Accord

Not finding what you are looking for?
1991 Honda Accord Logo

Related Topics:

194 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...