How to remove centre bucket seats - 2005 Ford Freestar

transfer case shift control module
Transfer Case Shift Control Module Replacement
Removal Procedure
Important: The transfer case shift control module (TCCM) is located under the drivers seat carpet. For removal purposes, access the TCCM from underneath the carpet.
Remove the drivers bucket seat or split bench seat. Refer to Front Seat Replacement - Bucket or Split Bench Seat Replacement.
Remove the left front sill plate. Refer to Front Side Door Sill Plate Replacement.
Remove the left hinge pillar. Refer to Body Hinge Pillar Trim Panel Replacement - Left Side.
Remove the left center pillar. Refer to Center Pillar Lower Trim Panel Replacement.

you could try removing the electric runners off your original seats and fitting them to your new seats

check for any wiring under the seat that connects to the seat and disconnect, then there are 4 bolts that mount the seat to the floor boards that need to be removed then you can remove the seat.

In the down position try pushing real hard into the seat ( as if you were trying squeeze them together.) as you are pulling up on arm rest.

Do you have a bench seat or bucket seats. The difference between the two are: the bench seat is one seat, Bucket seats are individualy adjustible.

It is possible that the role pin to remove the armrest is hidden inside the zipper cover. I do not know this particular vehicle, but GM did that to some of the vans. Some also have to require the removal of the actual seat and turn counterclockwise to "unwind" the armrest. Good Luck, hope this may help.

Keep the rails and fab new mounting holes , and install risers if needed.

On these case go with the solved problems related to these issue.

Click the link below and follow the procedure:-----
1994 Lexus GS300: Power seat will not go back? http://howtobyme.blogspot.in/2012/05/1994-lexus-gs300-power-seat-will-not-go.html

-----------
1997 Toyota Avalon: Power Seat will not Move back? http://whatisbyme.blogspot.in/2012/05/1997-toyota-avalon-power-seat-will-not.html

----------
1998 Chevrolet Corvette: Power Seat Control Now Working? http://schematicsdiagram.blogspot.in/2012/04/1998-chevrolet-corvette-power-seat.html

-----------
Power seat will not go Forward http://repairhelpcenter.blogspot.com/2012/10/power-seat-will-not-go-forward.html

-----------
Replacing power adjustable bucket seats to both heated and cooled seats?

http://schematicsdiagram.blogspot.com/2011/12/replacing-power-adjustable-bucket-seats.html

-------------
Volvo Seat Removal with Heated Seats? http://schematicsdiagram.blogspot.in/2012/07/volvo-seat-removal-with-heated-seats.html

-------------

How to Remove Rear seat on Rover 600? http://repairhelpcenter.blogspot.com/2012/01/there-are-3-10mm-bolts-at-back-of-seats.html

---------
How to remove Seat? http://repairhelpcenter.blogspot.com/2011/11/how-to-remove-seat-on-acura-integra.html

-----------
These will help.
Thanks.

Try to lift up the whole bucket seats from the drivers side towards the right. Use the back seatbelt to hang the bucket seats. The engine is right inside the front row seats. That is where you can remove the engine thru drop it down..

You are going to have to remove the seat from the vehicle to refit the spring. Examine the pass seat spring, and refit the spring to the driver side; you prob can not perform this with the seat bolted to the floor.