Question about 1995 Toyota Camry

1 Answer

My car started to cut off but will turn back on after i started the car up. every time i would stop at the stop sign or light it would cut off. it was loud and driving very rough. i took it to get fix and i got a tune up, my fuel injections change and a new idle air control valve on the car and it is still doing the same thing. the mechanic said now i need to get the timing on my car set. I wanted to know if that was true

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

I had the same problem ,Clean the egr valve and mountong port hole that connects to the throttle body. Also check the throttle position sensor it may not be in correct ranges. You need to get the haynes manual to tell you how to do this,Andy

Posted on Sep 11, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Starts and cuts off


serial number/keygen for registry reviver

Jan 28, 2014 | Cars & Trucks

1 Answer

When I accelerate from a stop sign or stop light my Honda Accord stops accelerating cuts out like it's missing a cylinder fire


this a problem ignition timing. Need to reset to manufacturer specification, They imply you need to make a mayor TUNEUP. Pass the scanner/computer for easy diagnostic and fix it. You can have some faulty ignition coil or PCM or BCM or sensor,distributorc4c56f9d-edf0-43e1-9703-e5fa31985ec4.jpg etc
see the diagram attached.

Jul 12, 2013 | Cars & Trucks

1 Answer

When i first crank the car it idles at like three or so then goes to zero and cuts of it does this a few times especially if i push the brake, i have learned to rev engine lightly and press brake and put...


Might be a leak on your brake booster (this will most probable give you a hard brake pedal or a "sucking sound " when applying brakes) also check the vacumm pipe from the engine to the brake booster. It might have a leak, so when you press the brakes it influences the air mixture.

Dec 14, 2012 | 2000 Nissan Maxima

1 Answer

1993 cutless cierra, when driving, all is fine, then when you come to a stop sign, or a light, the engine cuts off. It will start immediately, but when you put it into gear, it cuts off. had to have it...


sounds like the lockup converter is not releasing when you stop, like stopping with a stick shift and not pushing in the clutch. lockup solenoid most likely. Could just disconnect the lockup sol. (won't lock up at all) or replace the solenoid.

Mar 17, 2017 | 1993 Oldsmobile Cutlass Ciera

1 Answer

My jeep was idling pretty high and would come down go back up and cut off. I started it let it run for a little while went inside and it shut off. I got in drove it a bit if im going like 40 to 45 miles im...


Could be idle air sensor or throttle position sensor but first run the code check. On Jeeps you turn the key on and then off (without starting it) three times and leave in the on position on the fourth time. Code will appear on the monitor in front of the console. Write down the codes, the first one will be 12 if the battery has been unhooked before and the last one will be 55.

Jan 19, 2011 | 1995 Jeep Grand Cherokee

1 Answer

My 1993 cad sts keep cutting off when i ride for while then when i stop at light or stop sign for min and when i press gas to go forward the car turn off. then i start car back up and run again until i...


If you don't have any engine lights on, the first thing to replace would be the fuel filter. It is located under your car, probably about half way down. Just follow the gas line, and you'll find it.

Aug 30, 2010 | 1993 Cadillac Seville

1 Answer

It cuts off cuts completely off while im driving or even at stop sign or stop light


if it cuts off after you have been driving there is a good chance that you ignition coil or module is getting to hot. One good way to tell is if this happens after you have been driving and then it is starts back up after you sit for a little while.

Apr 10, 2010 | 1993 Toyota Camry V6

1 Answer

I have a 2002 Pontiac Grand Am GT and almost everytime I come to a stop and have to sit at light or stop sign, it cuts off. It will start right back once i put it in Park and cut it back on. Been going on...


You need a new repair shop. This is fixable when you say it happens this much. Intake leak. Bad IAC quickly come to mind. Go to IATN.com to locate a competent Tech.

Dec 08, 2009 | 2002 Pontiac Grand Am

Not finding what you are looking for?
1995 Toyota Camry Logo

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...