Question about Honda Accord

Open Question

How to install starter in 2004 honda accord - Accord Honda Cars & Trucks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1779 Answers

SOURCE: 2004 Honda Accord spark plug gap

.044 Happy New Year!

Posted on Jan 02, 2009

philschneide
  • 448 Answers

SOURCE: locating the starter motor on a 2004 honda accord

Disconnect the negative battery cable. Disconnect the positive battery cable (if you have an anti-theft audio system, make sure you have the code).
Drain the cooling system. Remove the intake manifold ( not a real easy task).
Disconnect the starter cable from the B terminal on the solenoid. Disconnect the BLK/WHT wire from the S terminal.
Remove the harness clamp. Remove the harness holder.
Remove the starter retaining bolts. Remove the starter from the vehicle.
d6afbbe.gif
Hope this helps you find it.

Posted on Nov 18, 2009

freetek
  • 5568 Answers

SOURCE: replace starter in 2004 honda accord

Try 'jiggling' the key while you hold it in the start position' this could be a failed ignition switch.
It could also be that the + terminal on the starter or starter solenoid may be corroded. Since the battery was just replaced, those terminals are probably clean enough but check the negative cable where it attaches to the chassis or block. If the connection is flaky here, enough current can often pass to allow lower current devices to operate but drop too much voltage if the starter is trying to operate. Starters require 100-200 amperes, many times higher than anything else in our vehicles and show up cruddy connections pretty quick.

Posted on Nov 21, 2009

  • 819 Answers

SOURCE: how to remove starter solenoid from 1998 honda accord LX 4cyl?

the starter solenoid is integral to the starter.

Posted on Dec 26, 2009

  • 94 Answers

SOURCE: Replace starter on 2003 Honda Accord w/4 cylinder

disconnect the cable to the battery........there is 3 bolt holding the starter to the engine/transmission housing. You may need to remove the air intake manifold to gain access to the work area.

Posted on Mar 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace starter on 2003 honda accord


I'm assuming you have the 2.4 Liter engine. If not, please get back to me. I will paste instructions from autozone.com below, but recommend you also read thru my post at http://www.fixya.com/cars/r5973094-starter_replace and let me know if you have questions.

2.4L Engines
3.0L Engines


NOTE The factory sound system has a coded theft protection system. It is recommended that you know your reset code before you begin.

Remove or disconnect the following:

Negative then the positive battery cables Automatic Transmission Fluid (ATF) cooler Starter cable from terminal B located on the back of the solenoid Black/white wire from the S (solenoid) terminal Two bolts that mount the starter to the transaxle assembly Starter
To install:

  1. Install in the reverse order of removal.
NOTE When installing the heavy gauge starter cable, make sure the crimped side of the terminal end is facing out.

  1. Enter the anti-theft code and radio presets.
9d5b04a.gif

Nov 01, 2010 | 2004 Honda Accord

1 Answer

I've just buy a used Honda Accord 2004, sometimes i can't start it, sometimes i can. What is problem with my car.


Have your charging system checked. Meaning battery,alternator, starter. Also have your fuel system checked.

Oct 22, 2010 | 2004 Honda Accord

1 Answer

HOW TO INSTALL A STARTER


Never replaced starter on accord but all starters are pretty much the same. Now assuming that you have already located your starter on the vehicle.First you want to disconnect negative battery terminal. When you remove the old starter pay attention to where the wires connect to so that you put them on the new starter the same way. There will be 2 probably 3 bolts holding the starter on. Remove those bolts and take starter off. Simple as that, and installation is the exact opposite of removal. I hope that is the answer you were looking for.

Jul 02, 2010 | 2004 Honda Accord

1 Answer

Replace starter in 2004 honda accord


Try 'jiggling' the key while you hold it in the start position' this could be a failed ignition switch.
It could also be that the + terminal on the starter or starter solenoid may be corroded. Since the battery was just replaced, those terminals are probably clean enough but check the negative cable where it attaches to the chassis or block. If the connection is flaky here, enough current can often pass to allow lower current devices to operate but drop too much voltage if the starter is trying to operate. Starters require 100-200 amperes, many times higher than anything else in our vehicles and show up cruddy connections pretty quick.

Nov 20, 2009 | 2004 Honda Accord

1 Answer

Where is the starter at 2004 honda accord v4


hi on your car its situated under the intake manifold and not easy to get at

Nov 19, 2009 | 2004 Honda Accord

1 Answer

Locating the starter motor on a 2004 honda accord


Disconnect the negative battery cable. Disconnect the positive battery cable (if you have an anti-theft audio system, make sure you have the code).
Drain the cooling system. Remove the intake manifold ( not a real easy task).
Disconnect the starter cable from the B terminal on the solenoid. Disconnect the BLK/WHT wire from the S terminal.
Remove the harness clamp. Remove the harness holder.
Remove the starter retaining bolts. Remove the starter from the vehicle.
d6afbbe.gif
Hope this helps you find it.

Nov 18, 2009 | 2004 Honda Accord

3 Answers

Starter for 2004 honda accord


Is this for a 4 or 6 cylinder engine?

If it is for the 4 cylinder, it's not that easy as the intake manifiold needs to be removed before the starter can be removed as the starter is under the intake manifold. Once the manifold is removed then it's a matter of a couple bolts and connections. It's not that quick a job.

Aug 19, 2009 | 2004 Honda Accord

2 Answers

Where is the starter located in a 2004 honda accord?


i havnt worked on a 2004 but all the hondas i worked on the starter was on top of the trans runing inline with the valve cover on the 4 cyl i dont know what motor you have hope this helps some

Aug 18, 2009 | 2004 Honda Accord

1 Answer

2004 honda accord will not start


The starter is begining to fail, the contacts inside the starter are worn, replace the starter.

Jun 03, 2009 | 2004 Honda Accord

1 Answer

I would like tyo change the starte in my honda accord 2004 2.4 l


DISCONNECT BATTERY FIRST !!!!!!! THE START MAY NEED TO BE GAINED FROM UNDERSIDE OF VEHICLE,, RAISE VEHICLE AND SUPPORT ON AXLE STANDS !! UNDO WIRING FIRST THEN UNDO BOLTS/BRACKET..

Nov 13, 2008 | 2004 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

215 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...