Question about 2008 Buick Enclave
I just watched the service station replace the rear turn signal bulb of our 2008 Enclave in about 5 minutes for $30! He opened the tail gate door, there were two small squares in the black lighting panel trim that he popped open. Inside each was a screw that he removed. This enabled him to remove the whole lighting panel. He then twisted the bad bulb and removed it and replaced with a new one. He checked that it was working then popped everything back into place added the screws and closed the squares back up. DONE!
Posted on Aug 29, 2011
Hi, if no visible screws on the outside then the bulbes are accessed from inside the inside of the boot usually behind the carpet has popet or a door / pannel. normally whole cluster has clips or cuple of nuts. before putting it all back together make sure they work. gerry
Posted on Sep 10, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Peel back the trunk lining to reveal three wing nuts. Remove wing nuts to pull lens cap away from car. To remove bulb socket push on the rectangular button (the release) while pushing on the end of the socket to unlock and spin counter clockwise to release. pull out old bulb and reinstall lens cap.
Posted on Oct 26, 2010
This is straight from the owner's manual.
#1 Make sure the headlamp switch is in the OFF position and open the trunk.
#2 Carefully pull the carpet away to expose the backside of the tail lamp assembly.
#3 Remove the nut and washer assemblies, then pull the lamp assembly away from the vehicle.
#4 Remove the bulb socket by rotating it counterclockwise, then pulling it out of the lamp assembly.
#5 Pull the bulb straight from the socket.
Install new bulb(s) in reverse order.
Posted on Jan 23, 2010
Open tailgate 2 screws hold housung in. Remonve the screws pull the huosing out and change bulb. On mine the housing had melted so O called the Ford garage and they got the socket out for me. I had to buy a new socket but that was it.
Posted on Aug 03, 2008
Tips for a great answer:
Jul 09, 2014 | 2004 Mercury Mountaineer
Feb 27, 2011 | 1998 Plymouth Neon
Sep 14, 2009 | 2006 Chrysler PT Cruiser
Jul 19, 2009 | 1998 Chevrolet Cavalier
Aug 08, 2008 | 2001 Jeep Cherokee
2,162 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: