Question about Ford Focus

Open Question

Wiring diagram for rear parking sensors - Focus Ford Cars & Trucks

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where does the pink praking brake wire go on 2003 cadillac deville go


Where are you seeing this pink wire ? I'm looking at a wiring diagram and I see a pink wire at the (RIM) rear integration module . It goes to the park brake relay A ,control side . The RIM supply's a ground on that circuit energizing the park brake relay A . There is another park brake relay - B . Are you familiar with the RIM module .
The park brake system is a mechanical and electrical system which operates on the rear disc brakes. The system is activated by depressing a foot pedal lever assembly, which sets the rear brake caliper via cables. The park brake is released by shifting the vehicle out of park or activating the manual release.

Park Brake Release
The rear integration module (RIM) controls the operation of the electric release park brake. The RIM uses serial data messages to determine if the correct conditions exist to release the park brake. The park brake is released under the following conditions:
• The engine is ON.
• The gear shift lever is not in Park or Neutral.
• The park brake switch is closed.
When all of the above conditions exist, the RIM releases the park brake by simultaneously activating the 2 park brake solenoids. After 2 seconds, the RIM deactivates solenoid A. The RIM continues to activate solenoid B while the above conditions exist, which prevents the park brake from being set.

Dec 23, 2016 | Cadillac DeVille Cars & Trucks

1 Answer

How do i replace the park assist module in a 2011 chevy traverse???/


Have you checked the fuse? If so, the module is located behind the left rear trim panel. Remove the panel to access. Below is a diagram of the trim panel and location of the module in BLUE>
Preliminary Procedures
  1. Move the rear seat to the full forward position.
  2. Remove the rear number?2 seat . Refer to 3rd Row Seat Removal and Installation.
  3. Remove the rear quarter upper trim panel. Refer to Quarter Upper Trim Panel Replacement.
  4. Disconnect the liftgate actuator rod from the liftgate. Refer to Liftgate Actuator Rod Replacement.
  5. Disconnect the rear seat number 2 shoulder belt anchor bolt. Refer to Rear Seat Number 2 Retractor Side Belt Replacement.
  6. Remove the liftgate door sill plate. Refer to Liftgate Door Sill Plate Replacement.



woauitf41mzpgaaaabjru5erkjggg==

Nov 16, 2014 | 2011 Chevrolet Traverse

1 Answer

Rearlight wiring diagram for 2006 chevy impala


Should be the brown wire for park lights but you can use a test light to find the correct wire (park lights switch on )

Aug 14, 2014 | Cars & Trucks

1 Answer

FAULT CODE 9E33 BMW 3 SERIES


rear parking sensors
Transducer lines are the wiring harness to the parking sensor. check the sensor is clean and that wire are connected right

Jun 06, 2014 | 2007 BMW 3 Series 328i

1 Answer

Rear parking sensor not working


test for open or faulty see the diagram use the VOM.
God bless youbb20c7e3-2399-4a4b-8cd0-d86d9ed8f8c8.jpg5af0394e-e7f6-4b08-b345-5c47df750f0e.jpg

Jul 11, 2013 | Cars & Trucks

1 Answer

Where can i find a fusebox manual for transit van year '52' . rear parking sensors aren't working so thought must be fuse.....Thanks


as the rear parking sensors are hardwired into the reversing light circuit/switch,they will not be shown on the wiring diagram/fuse panel.check your reversing lights.......as a starting point....

Nov 26, 2010 | Ford Transit Connect Cars & Trucks

2 Answers

I need a FREE 1992 Toyota Camry taillight wiring diagram. My side rear park lights come on but my park lights that work with the brake lights don't. I changed the bulbs and tested everything. I narrowed it...


brown wire is your park LT yellow Left-turn green right-turn. Now the break light my be on it own wire it is red black is ground. but if you have a test light see if the brown wire turns on the test LT when you turn on the park LT or what wire light up when you step on the break pedal. and so on.

Feb 25, 2010 | 1992 Toyota Camry V6

2 Answers

Need wiring diagram for rear defroster.


The common problem with the rear defrost not working on a park ave is the antenna integration modules on the rear c-pillars. This is the way they make the rear defrost and antenna part of the same grid on the rear window. If your external mirrors are heating up, the rear window is getting juice too. They are fed from the same circuit. And yes, the relay does go in a particular way. Compare it to the position of the others nearby and insert with the same orientation.

Sep 15, 2009 | 2000 Buick Park Avenue

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...