1987 Chevrolet Caprice
Problem for Chevrolet 1987 Caprice

1980 Chevrolet Caprice: transmission slips in reverse




By lawyer - usenet poster

" "
The transmission seems to slip when going in reverse in
my 1980 Chevrolet Caprice (OK going forward). Transmission
fluid is OK.

Is there anything one can adjust--or does the transmission
have to be torn apart or replaced to fix? (I assume replacement
from the junk yard would be cheaper?)

--
Jonathan Grobe Books
Browse our inventory of thousands of used books at:
http://www.grobebooks.com

Best Solution

posted on May 14, 2008
Very Helpful)

lawyer

Rank: Apprentice 
Rating: 0%, 0 votes
Rebuild is a possibility, no adjustments for that.
Problem is the reverse clutch.

...
Was this helpful?
Yes
No

Solution #2

posted on May 14, 2008
Helpful)

lawyer

Rank: Apprentice 
Rating: 0%, 0 votes



Depends on why it's slipping in reverse but yes, most likely it's not
going to last a whole lot longer. The deal with the higher pressure
is that due to design issues, the reverse band had to have VERY high
pressure applied to keep it from slipping, something like 150 psi.
Normal pressure for the bands and clutches is usually significantly
lower. As the tranny wears and the pump clearances increase the pump
can't generate as high a pressure, plus all the internal seals are
getting worn and leaking more and more which requires the pump to pump
a higher volume to maintain whatever pressure is needed. So even if
nothing is actually broken but it's all just getting worn out, the
high pressure for reverse may become impossible for the pump to
supply.

If it were my car and I wanted to avoid spending more then $15 on
repairs, here's what I would do

1 - buy a can of "STP" or other brand of oil viscosity improver, the
stuff that's like pouring honey into your engine and that makes the
oil "thicker". Except instead of putting it into the engine, put it
in the tranny. Make sure the tranny if fully warmed up before you
start adding it and it will take a while to pour it down the dipstick
tube because it's so thick.

This will raise the viscosity of the AT Fluid when it's hot and the
higher viscosity will allow the pump to generate more pressure and
will also reduce the leakage at the various internal seals.

2 - buy a can of Trans-X or some other "transmission seal conditioner
and rejuvenator". To avoid overfilling the tranny look for one that's
pint sized rather then quart sized. Pour that down the dipstick tube.
This stuff will soften and swell the internal rubber seals which will
also reduce leakage internally which will give the pump a better
chance of building up the high pressure it needs to keep reverse from
slipping.

It will take several days to perhaps a couple weeks for this to do
it's magic, if it works at all. Since we don't really know why it's
slipping, this may or may not help. It will not hurt anything in the
transmission. I have done this routine in several transmissions and
sometimes it helps. It has never caused a problem. You can even dump
in two cans of the "STP" type stuff if you want or feel it might help.
The only thing "bad" about the higher viscosity is that it takes a
little more power to pump it around which means theoretically your gas
mileage could go down one or two percent. You have bigger issues to
worry about then that.

If this does stop the slipping in reverse, then you may get quite a
few more miles out of the transmission. The other thing you can do,
but it's more work, is drop the tranny pan (before doing any of the
above) and change the filter just in case the filter is dirty enough
to be reducing oil flow to the pump which would lower the pressure.
My guess is that won't help, I've never seen a AT filter that had much
stuff on it nor have I ever had a filter change affect how the tranny
shifts felt or how it otherwise performed. Unless the tranny is
actually starting to come apart, there just isn't much to filter in
them. That's why new cars now go 100K on the original fluid and
filter (if nothing goes wrong).
--
Elbridge Gerry, of Massachusetts:

"What, sir, is the use of militia? It is to prevent the
establishment of a standing army, the bane of liberty. . .
Whenever Government means to invade the rights and liberties of
the people, they always attempt to destroy the militia, in order
to raise a standing army upon its ruins." -- Debate, U.S. House
of Representatives, August 17, 1789
Was this helpful?
Yes
No

Solution #3

posted on Jul 28, 2008
Somewhat Helpful)

buenf

Rank: Master 
Rating: 77%, 17 votes
well mines was just need a oil change filter was clogged and would let the oil flow thru tranny
Was this helpful?
Yes
No

Solution #4

posted on Jan 27, 2009
Somewhat Helpful)

kkared

Rank: Apprentice 
Rating: 75%, 1 votes
the worst people on earth the American they say they are free
but they are not they killed Iraqi people and ifgan people and they are
ruled bye bunch of idiot and now they pay the price but still they follow idiot government and they plan to go to another war they support thieves like Israel and corrupt monkey and they are blinded
they don't deserve to be human they should sunk on ocean but leave
caprice car don't sunk make sure
Jewish sunk too

Was this helpful?
Yes
No

Solution #5

posted on May 14, 2008
Not Rated)

lawyer

Rank: Apprentice 
Rating: 0%, 0 votes
I wouldn't worry aboiut it. My 85 Chevy Caprice has been doing that
(sometimes) for the last 7 years and last 100K. It hasn't gotten any worse
since it started.

OTOH, I had a 77 Ford Granada which started slipping in reverse, and it did get
worse, so I could not back up a hill. But forward gears were always OK.
Was this helpful?
Yes
No

Solution #6

posted on May 14, 2008
Not Rated)

lawyer

Rank: Apprentice 
Rating: 0%, 0 votes
...

Meh. My Celebrity had about 70k on it, and it stopped shifting into
overdrive at 45 mph, it would do it at some random later speed. Dropping the
pan and changing the filter cured it.

-Sam
Was this helpful?
Yes
No

Solution #7

posted on May 14, 2008
Not Rated)

lawyer

Rank: Apprentice 
Rating: 0%, 0 votes
A clean filter, and fresh fluid assures full line pressure,
full line pressure insures clutches grip tight. Some cars slip
after a fluid change because grit was " shimming " clutches tight,
now that grit is gone, clutches no longer fully engage.
My advice, add a drain plug, and change fluid frequently,
it takes more than one change out to expel old fluid. My TH350
lasted 180 K miles.
Was this helpful?
Yes
No

Solution #8

posted on May 14, 2008
Not Rated)

lawyer

Rank: Apprentice 
Rating: 0%, 0 votes
It's probably a worn out clutch. Unless it blew up into pieces, sometimes
pouring a transmission additive helps. Lucas Transmission fix was mentioned
by several people as being effective. At this point, it's broken anyway, it
can't hurt.

...
Was this helpful?
Yes
No

Solution #9

posted on May 14, 2008
Not Rated)

lawyer

Rank: Apprentice 
Rating: 0%, 0 votes
Has the tranny been serviced regularly?
Maybe it needs a fluid and filter change.
How many miles?

--
Paul
'91 XL1200
'77 GL1000 (W.I.P.)
"I feel more like I do now than when I got here"
Was this helpful?
Yes
No

Solution #10

posted on May 14, 2008
Not Rated)

lawyer

Rank: Apprentice 
Rating: 0%, 0 votes
On 2004-12-17, frank-in-toronto <
I talked to my mechanic and he said that slipping in
reverse in Chevrolets is an early warning signal that
the transmission is going bad (higher pressures in
reverse or something...) Anyone agree or disagree?
Is it going to start slipping in forward?

--
Jonathan Grobe Books
Browse our inventory of thousands of used books at:
http://www.grobebooks.com
Was this helpful?
Yes
No

Solution #11

posted on May 14, 2008
Not Rated)

lawyer

Rank: Apprentice 
Rating: 0%, 0 votes


i wouldn't care about it. i have a 1987 caprice and i'm
afraid it qualify as a "beater car". your's sounds
like one too. unless you can backup on a little hill,
let it go. stop backing up.
...thehick
Was this helpful?
Yes
No

Popular Solutions for 1987 Chevrolet Caprice


Questions and Unsolved Problems for 1987 Chevrolet Caprice


Do you recommend Chevrolet 1987 Caprice?
Answer

Answer
I sometimes find that my gas cap is hard to maneuver but eventually it'll loosen up after I pull up... (More)

Answer
I need to know how to replace the starter on my 1987 chevy caprice 4.3 engine

Answer
i have 1988 caprice with 200-4 transmision can i put the 350 although its only a 3 shifts tranny?

Answer
Transmission shutters and shifts up and down continuously between 40 &amp; 55 mph. Does this... (More)


Didn't find what you were looking for?

Describe your problem:

Select a Category:







Ask our Experts

 

Solve Your Problem Now!
Chat Live with an Expert
Chat Now
Browse popular Problems
More Common Problems
Most Common Problems for:
For 1987 Chevrolet Caprice:

Top Car Experts

Rank: Guru Guru  

Solutions: 14889
Member Since: June 2008

Experience: 40 years of automotive repair work, home appliance repair experience and general electrical repair.

Ask Me
Find more Car Experts

Top Car Repair

       
Solve Your Problem Now!
Chat Live with an Expert
Chat Now

X
Continue
When the original poster rates a solution that was given to his own problem, that rating is locked!
X

Are you sure the solution content is Inappropriate?
   
Tech buddies can communicate directly to answer questions. Become a Tech Buddy and have direct access to your favorite expert for FREE!
Insert Link
Insert Image
Insert You-Tube clip
Insert List
Insert List
Spell Check

What is this?



Select