Question about 2006 Buick Terraza

Open Question

REAR WINDOW WINDSHIELD WIPER NOT WORKING - 2006 Buick Terraza

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: 1998 Toyota Sienna Windshield Wipers not working

The fuse is the 20 amp WIPER fuse, located in the fusebox under the driver side of the dash, farthest on the left, 2nd one up from the bottom.

Posted on Jan 02, 2009

  • 840 Answers

SOURCE: Rear Windshield Wiper Problems

Check the wiper motor connection if its touching anything and loose it will automatically ground out and check at connection make sure you put some gel and then snap it in/ Please rate my response thank you very much

Posted on Jan 31, 2009

  • 205 Answers

SOURCE: Rear windshield washer motor works, but no fluid comes out

Rear washer may have it's own reservoir . Can you hear a pump humming when you activate the washer? Look in the under flooor compartment

Posted on Mar 22, 2009

FixurNissan
  • 61 Answers

SOURCE: my 07 nissan murano rear windshield wiper doesn't

You need to adjust the wiper arm location. Loosen the 12 mm or 10 mm nut that holds the rear wiper arm. Wiggle the arm until it comes off. Then turn on the rear wiper for a second and turn it off, leaving the key on. This way the rear wiper motor will do it's sweep, and them park where it's suppose to. Then reattach the rear wiper arm and secure the nut and recheck.

Thanks Jay!

Posted on Jul 22, 2009

  • 2 Answers

SOURCE: 07 Kia Sportage 4x4 V6 Front windshield wipers stopped working.

o yeah take back to dealership where they will fix it for free

Posted on Aug 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My front windshield wipers will only work on high. Any suggestions?


Search Results

    My windshield wipers only work on high speed...? ' Yahoo Answers

    https://answers.yahoo.com/question/index?qid...
    Nov 11, 2006 - My windshield wipers only work on high speed. ... If it's the compound switch on the lever on the steering wheel, it can be a bit complicated to ...

    Windshield wipers - CarGurus

    www.cargurus.com > Questions > Mercury > Grand Marquis

    CarGurusMay 19, 2015 - Windshield wipers - My wipers stopped last week and the next day they ... slow or intermitt and only work on high speed and the washer wiper doesn;twork ... The LCM does not effect the operation of the motor or switch it just ...

    Windshield Wipers only working at highest setting - Ford Flex Forum

    www.fordflex.net > ... > General Ford Flex Discussions
    Feb 16, 2011 - Windshield Wipers only working at highest setting ... rear wiper worksjust fine, just the front wipers only work at highest setting. ... the wipers sometimes grinds out the gears thus only working at high sppeds. If it is the motor or Transmission for the wipers, can I fix this myself and how much would it cost me.

    Common GM Wiper Problem - YouTube

    ? 3:23
    https://www.youtube.com/watch?v=kc6e2Tmar68
    Oct 25, 2010 - Uploaded by roadragecustoms
    The windshield wipers only worked occasionally. ... My 1998 dodge ram wipers only work on high will this help me? thanks.... Express van. you have to take out the motor and the transmission from under the front of the van..

Feb 09, 2016 | Cars & Trucks

2 Answers

Windshield wipers stop working when the defroster is on


The only thing they have in common is the ignition switch.

Dec 18, 2015 | 2007 Chrysler Sebring Sedan

1 Answer

Rear window lift and windshield wiper have stopped working. Do they have a fuse?


everything electrical is fused. also check the wires from the body to the rear door lift area as the wires will frey over the years causing a open circuit. hope this helps

Aug 30, 2012 | 2007 GMC Yukon

1 Answer

Why won't my Windshield wiper on back window stop? I need to know which fuse would operate the back window windshield wiper.


the rear wiper fuse locate at the interior fuse panel, #5 15A, if the fuse is ok, check the circuit braker 4.5 A,

Jul 24, 2010 | 1992 Ford Explorer

1 Answer

Windshield wiper for rear window does not work we can hear a clicking sound come from the motor of the rear windshield wiper


If you hear a clicking sound, then you know you have power. Check to see if the motor arm is moving any at the wiper arm.The small cap that covers the wiper arm to motor can be pulled apart, to see if the nut is loose or if the gear housing is stripped on the wiper arm, or if the motor drive is stripped. These are say to check and are cost effective for you.

Feb 16, 2010 | 2002 Chevrolet TrailBlazer

1 Answer

Rear windshield wiper


Try tightening the bolt that holds the wiper in place. There is a cap over it at the base of the wiper where it attaches to the window pop that cap and you will see the it.

Jan 23, 2009 | 1999 Chevrolet Suburban

1 Answer

1999 Ford Explorer Rear Windshield Wiper


may have to replace the entire arm assembly as the tensioner spring in the wiper itself is worn

Jan 14, 2009 | 1999 Ford Explorer

1 Answer

1999 Ford Explorer Rear Windshield Wiper


you can unbolt the wiper arm and change to where you think it should be then bolt it back up /Please rate my response thank you very mudh

Jan 09, 2009 | 2003 Ford Explorer

1 Answer

2000 Jeep Cherokee Windshield Washer


You have a motor for the front and rear washer. Check the fuses. If the intermitted wipers does not work, there is a relay under the dash near the steering colum that needs to be replaced.

Jan 01, 2009 | 2000 Jeep Grand Cherokee

1 Answer

99 Nissan Quest real wiper runs continually when ignition is on


Principles of Operation
Operation of the windshield wiper and washer is controlled by the front wiper/washer amplifier assembly. The front wiper/washer amplifier input comes from the multifunction switch by means of a voltage divider circuit. A constant voltage is applied to the multifunction switch by the front wiper/washer amplifier. When the multifunction switch is moved into the LO, HI, or intermittent position, the voltage is directed through a series of resistors. This results in various voltages being returned to the module for each switch position. The module then grounds the appropriate circuit, based on the voltage signal received back from the multifunction switch. This causes the wipers to run intermittently, or at the appropriate speed. Voltage is supplied to the wiper motor by the CJB fuse F46 (20A).
When the multifunction switch wash button is depressed, it bypasses all of the resistors returning a full voltage signal to the module. The module then grounds the appropriate circuits to operate the windshield washer pump for as long as the switch is depressed. The windshield wiper speed is dependent on the position of the windshield wiper/washer switch.
Voltage for the windshield washer pump is also provided by CJB fuse F46 (20A).
Operation of the rear wiper and washer is controlled by the rear wiper/washer switch.
Voltage is supplied to the rear window wiper motor by the fuse junction panel fuse F44 (10A).
The rear window wiper motor ground is made or broken by the rear wiper/washer switch. When the rear wiper/washer switch is moved into the WIPER position, it grounds the rear window wiper motor circuit, causing the rear window wiper motor to run once every 10-15 seconds.
Voltage to the rear washer pump motor is also supplied by the CJB fuse F44 (10A). The rear washer pump is directly controlled by the rear wiper/washer switch which makes or breaks the ground for the washer pump motor, depending upon its position.
If the vehicle is equipped with a movable liftgate glass, a liftgate glass switch is utilized to prevent rear window wiper operation when the liftgate glass is open. This same switch also causes the rear window wiper to drop down approximately three inches when the liftgate glass latch is released.
------------------------------------------------------------------------------------------
  • The wipers stay on continuously — rear wiper
  • Circuit.
  • Rear wiper/washer switch.
  • GO to Pinpoint Test L .


---------------------------------------------------------------------------------------------
Measure the resistance between rear wiper/washer switch C288 pin 6, component side and rear wiper/washer switch C288 pin 2, component side.
  • Is the resistance less than 5 ohms with the switch depressed, and greater than 10,000 ohms with it released?
sxv~us~en~file=arrow.gif~gen~ref.gifYes GO to L2 .
sxv~us~en~file=arrow.gif~gen~ref.gifNo INSTALL a new rear wiper/washer switch. TEST the system for normal operation.

Measure the resistance between rear wiper/washer switch C288 pin 6, circuit WB08 (BU/YE), harness side and ground.
  • Is the resistance greater than 10,000 ohms?
sxv~us~en~file=arrow.gif~gen~ref.gifYes INSTALL a new rear wiper /washer switch. TEST the system for normal operation.
sxv~us~en~file=arrow.gif~gen~ref.gifNo REPAIR circuit WB08 (BU/YE). TEST the system for normal operation.

65501dd.gif 7e9d21a.gif

Dec 08, 2008 | 1999 Nissan Quest

Not finding what you are looking for?
2006 Buick Terraza Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...