Question about 1999 Suzuki Vitara

1 Answer

Frontwheel shimming when i doing about 80mph - 1999 Suzuki Vitara

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Suzuki Master
  • 22,095 Answers

Eother deformed tyres or balance ,but it could also be caused by a worn ball joint so if balance doesnt work then ask local mechanic to jack up vehicle and put a crow bar in the suspension and check the joints ,unless your in europe where this is done on every annual mechanical inspection

Posted on Sep 09, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Celica has a bad bump / knock at rear of the car


sound travel far.problem do can sit in the front.check rubbers of,
excaust and stabelizer between frontwheels

Jun 30, 2013 | 1996 Toyota Celica

1 Answer

Shimming


have a wheel alignment done as it is most likely a castor wobble. Check all steering ball joints and connections. Check balance of tyres both dynamic and static

May 05, 2013 | Cars & Trucks

1 Answer

Speedometer stuck on 80mph at idle


These trucks are well known for faulty instrument clusters.There is a recall on them aslong as the vehicle is not over 7 years old or have over 70,000 miles on it.

Jan 20, 2012 | 2004 Chevrolet Silverado 1500 Crew Cab

1 Answer

I recently purchased a 2003 hyuandai tiburon GT with 171k miles on it i was on the interstate doing 80 mph in 4th gear at around 6k rpm when my clutch pedal dropped back into the floor board and just...


hmmm... 80mph @6000 rpm is not normal. you are needing a lot of power to produce 80mph. it seems clutch assembly needs replacement. clutch assembly includes clutch disc, fly wheel, and release bearing. might as well check your clutch master if the vacuums are still working properly. this might be the culprit to the stuck up clutch pedal.

after replacing the clutch assembly, you can reach 80mph @ 4000-4500rpm

Aug 06, 2011 | 2003 Hyundai Tiburon

1 Answer

When replacing delta 88 olds waterpump frontwheel drive is there any timing issues that i have to worry about or is it take off and replace no worrie


if it is the 3.8 there is no timing you have to do. just replace the water pump. suggest the thermostat while your at it. hop this helps

Feb 09, 2011 | 1988 Oldsmobile Delta 88

1 Answer

Do i need to install the shims that come with the front brake pads on the 95 grand marquis


It is not necessary to install the shims. If, after replacing pads and installing caliper, the pads are loose, then you may install one shim at a time until it is tight. Also, if there were no shims on the previous pads, then there is no need to install the shims.

Oct 10, 2010 | 1995 Mercury Grand Marquis

1 Answer

I need to repair my brakes on frontwheel and I need at manual to see have to due it


These are pretty easy to do. Email me at iambanshee74@yahoo.com for I can not send pictures and diagrams through here.

Jul 12, 2010 | 1990 Volvo 740

2 Answers

Check frontwheel drive light is on. Where do I


this is most likely the switch. use a test light to check it and also check to be sure the plug is connected properly. The plugs will come loose if jard. If you find the swicth is bad, you can get them almoct any place, i have seen the even on Ebay.

Mar 13, 2010 | 2000 GMC Jimmy

1 Answer

Noises coming from th left frontwheel of my 2000 hyundia sonota could this be a hub and bearing noise


What kind of noises are you hearing? Most likely, you need to replace the brakes. It is very unusual for a 10 year old car to have wheel bearing problems, especially on the front wheels.

A squeal when you apply the brakes or a grinding/dragging noise while you are driving are signs that it is time to replace the brakes.

Jan 30, 2010 | 2000 Hyundai Sonata

1 Answer

Body vibration when engine is in strain (70-80mph)


your flex plate inside your trans is broke

Jun 03, 2009 | 2004 Jeep Grand Cherokee

Not finding what you are looking for?
1999 Suzuki Vitara Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...