Question about 1992 Volvo 240

1 Answer

Trying to locate engine temperature sensor 1992 volvo 240 wagon. Thanks

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 22 Answers

The engine temp sensor on a 1992 240 (b230f engine) is located on the passenger side of the engine, right next to the oil filter and right above the alternator. good luck :)

Posted on Dec 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the primary fuel pump location on 92 volvo 240 wagon


I believe it is attached to a support bracket for the dash behind the glove compartment.

Sep 15, 2014 | 1992 Volvo 240

2 Answers

1992 volvo 240 wagon, and rear break repair


rear disk brakes ,easly changed because the hand brake is inside the drum in the disk ,so just push out the pins and then push piston in on one side and renew pad then do the same on the other side of the piston .

Apr 17, 2010 | 1992 Volvo 240

1 Answer

How do i replace air flow meter on 1992 volvo 240 wagon. It stalls at low speed, intermittently.


It is a can shaped air flow sensro, in the plastic intake hose. To replace it all you have to do is pull the electrical connector, unscrew the clamps on the line on both sides, and switch out the sensor. Make sure you have the correct sensor, there were 3 different types used.

Jan 20, 2010 | 1992 Volvo 240

1 Answer

Radio code for 92 Volvo station wagon


look for the manual its inside there or go to volvo website and they will get you it

Nov 26, 2009 | 1992 Volvo 240

2 Answers

NEED TO KNOW THE LOCATION OF KNOCK SENSOR IN 1989 VOLVO 240DL


Check out you tube, type in knock sensor replacement, will offer a video, lot easier than me trying to explain it to you.
Hope this helps.

Sep 05, 2009 | 1988 Volvo 240

2 Answers

Just bought a '92 volvo 240 station wagon. Drove


you may want to check the fuel pump relay. this is a common problem

Jun 09, 2009 | 1992 Volvo 240

1 Answer

I want to put subs in my 1992 volvo 240 but i dont know where to put them.


MOUNT ON BACK OF SEAT FACING IN TOWARD FRONT OF CAR OR PLACE BOX FACING BACK TOWARD REAR WINDOW FOR BEST SOUNDS.

May 07, 2009 | 1992 Volvo 240

1 Answer

1992 volvo 240 gle wagon


MOST LIKLEY IS THE PUMP WHICH IS LOCATED UNDER VEHICLE DRIVER'S SIDE PASSEENGER SEAT AREA.(IN CHASSIS)
REAR LATCH CAN BE REPLACED

Dec 30, 2008 | 1992 Volvo 240

2 Answers

WILL NOT START ALL THE TIME


Had the exact same problem with my 240 wagon. There is a temperature sensor up near the manifold on the drivers side of the engine. This is not the temp sensor that feeds the dash gauge, but one that tells the engine control module whether you are starting hot or cold. Mine was cracked, so the engine computer would get a cold start signal even after the engine ran warm, and would flood. This can be a difficult problem to diagnose and an expensive one when mechanics start swapping parts. You cannot see this sensor, but you can feel it (when the block is cold, please) right under the exhaust manifiold. A replacement is about $80 plus labor. Even my very experienced Volvo mechanic overlooked it. But the car would start and run fine, then leave me stuck when I tried to restart it. After calling AAA for a tow, the temp sensor would reset, then the car would start normally. Cheers. The 240 is a great car - I ran mine up to 235,000 miles; now I have a 740 with the same engine.

Nov 29, 2008 | 1991 Volvo 240

1 Answer

Volvo 240 has no spark


Try a new engine rpm speed sensor. It is located at the back-top of engine block where it mates to trans. You will need to remove a single bolt (10mm socket or wrench). You may have to wiggle the sensor to lift it out. Another symtom you may experience, is when you are cranking the car to start, it will buck and act like it is out of time. Another possible component is the ignition power stage/amplifier.

Oct 25, 2008 | 1991 Volvo 240

Not finding what you are looking for?
1992 Volvo 240 Logo

Related Topics:

378 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...