Question about Daihatsu Charade
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Daihatsu Sirion
I assume you are changing the timing belt. I am a mechanic and although not familiar with your vehicle, you would usually locate the timing mark on the bottom pulley and line this up. Careful not to turn the engine over too hard as pistons can strike valves. then you should look for similar marks on the camshaft pulley[s], and line these up. Then fit belt. This has to be tensiond correctly which is important. Hope this helps. Mike the bike01.
Posted on Aug 19, 2008
SOURCE: 1999 Daihatsu Sirion
Your engine is probably an EJ-DE twin cam 12 valve.
Generally Daihatsu belts have marks on them that line up with dimples on the sprockets for the intial phasing. You rotate the engine to top dead centre on No1 piston and install the belt from there. The cams should be not be putting any pressure on the intake and exhaust valves of No1 when phased correctly.
Posted on Oct 10, 2008
The light should normally be "off", by pushing the small button on the transmission shifter. For power or passing at high speed, push the button again to light "O/D off", signifying that the overdrive is off. Overdrive (O/D) is normally for cruising at highway speeds to maximize gas mileage. Having it off increases the motor RPM's, increasing power, and decreasing mileage and gas efficiency.
For most purposes turn "on" overdrive, and the light on the dash should go out.
Posted on Jun 13, 2009
THERE IS NO CAM BELT , THE TIMING BELT IS TURNED BY THE CAMSHAFT , THE POWER STEERING IS POWERD BY THE CRANKSHAFT PULLY WHICH ALSO POWERS THE ALTERNATOR,
Posted on Oct 25, 2009
Your Rocky has a 1.6L 4 cylinder it only has one ignition coil, the coil runs about $75.00 and labor to install is .5 (1/2) hr X there shop labor rate, NAPA part # for ignition coil is # IC135. At my repair shop to remove and replace ignition coil parts and labor no more then $125.00, also I think this is some thing you can do, just unscrew small coil bolts, disconnect harness ans install new one.
Posted on Jan 23, 2010
Tips for a great answer:
Aug 24, 2016 | 2005 Daihatsu Sirion 1.3
Aug 18, 2016 | 1999 Daihatsu Sirion
May 27, 2015 | Daihatsu Sirion Cars & Trucks
Apr 26, 2015 | 2008 Daihatsu Sirion 1.3i
Dec 21, 2013 | 1991 Daihatsu Charade
Feb 28, 2013 | 1998 Daihatsu Sirion 1.3
Oct 22, 2012 | Ford Explorer Cars & Trucks
Mar 31, 2012 | 2006 Daihatsu Sirion 1.3
Feb 03, 2012 | 1998 Daihatsu Sirion
Jan 18, 2012 | Daihatsu Sirion Cars & Trucks
48 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: