Question about 1993 Oldsmobile Cutlass Supreme

1 Answer

93 Cutlass s Cal. emission stopped running while driving and will not start again.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Oldsmobile Master
  • 7,722 Answers

Possibly a timing chain issue. See my tips at http://www.fixya.com/cars/r5821173-doesnt_car_start_gasoline_engines
and let me know if you have questions.

Posted on Sep 09, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

93' cutlass ciera 3.3 wont stay on after turning over


run the fault codes
not running indicates that the air/ fuel ratio is incorrect for the ambient temperature so you should be checking the ambient temp sensor /baro sensor and coolant temp sensor

May 28, 2017 | 1993 Oldsmobile Cutlass Ciera

1 Answer

My truck some times dies on exceleration and ruff ideal than runs fine


I had the same problem with my 93 K2500 it only has 159000 on it. It was my catalytic converter, drop the Y pipe going into your exhaust manifold then drive it. You should feel an immediate difference. You can replace it or cut it open if your state doesn't have emission laws. It cost me around 250 and a couple hours of work.

Aug 03, 2012 | 1993 Chevrolet C/K 2500

1 Answer

I have 90 olds cutlas cal after running shout off will not restart till motor is cool again


ignition module
when it stalls take a can of compressed air (for computers) and spray the ignition module at bottom of coils, if car starts the module is bad, that test worked for me, the canned air is like spraying freon with the chemical in it

Sep 16, 2011 | 1990 Oldsmobile Cutlass Calais

1 Answer

92 cutlass ciera stalls when stopping after driving on highway


bad torque convertor solenoid , unplug the electric connector on transmission u can drive your car fine and save yourself a $1000 repair

Jun 01, 2009 | 1992 Oldsmobile Cutlass Ciera

1 Answer

High rpms in park, too low in drive


sounds like ecm sensor problems.does check engine light come on at all?you may be able to get a code reader at autozone to retrieve computer stored codes, this would more than likely lead you in the right direction.some shops will do a computer check cheap if you are unable to perform this task.however the code readers come with instructions and are user friendly;-)

May 31, 2009 | 1993 Oldsmobile Cutlass Supreme

1 Answer

Car starts fine, but stalls at stops and takeoffs occasionlly


Most likely it is running too ritch. should be around 7%. Mine did ecactly the same thing and I had several things done . Had the throttle body cleaned and installed a O2 senser.runs great now.

Hope this helps

May 14, 2009 | 1993 Oldsmobile Cutlass Supreme

1 Answer

1990 Oldsmobile Cutlass Supreme died and won't start


suggestion :
I have some experience with my oldie cutlass 90 that I had import to my farest country : CHILE .
My car seemed to run in three cylinders , of 4 .then started to run good in cold and after 10 minutes stop and die for a long time ...a few days after strat again and dies and so .. I studied about I read about the prom I learnt all abo¡ut this kind of irregular fails that even experiencied machanics can´t solve ...( It took 6 months and seven mechs to solve )..
the cars falls in limp in mode ( a kinda mem programmed mode for a few minutes and everybody thinks it the crankshft sensor , the ignition module , the ecu fial etc simply is code 51 : mem cal fail and limp in state i suggest work with and a code reader and it could be that kind of irregular fail..
ah. it´s too hard to find the eprom so the ECU dealer usually sell it without the eprom .. mine is ANLP 3645 ) federal emission .if you know when can I buy this or a good used one . I ´d shop it again cause I don´t want suffer about it again.. luck

Nov 23, 2008 | 1990 Oldsmobile Cutlass Supreme Conv

1 Answer

1991 cutlass supreme


my car was doing the same it would run while and then stop and it wouldnt start again until it sat a while. It was my crankshaft sensor. works fine on that score now.

Aug 25, 2008 | 1996 Oldsmobile Cutlass Ciera

1 Answer

93 Oldsmobile Cutlass


check for a crossed filament in the brake lamp bulbs on the right side. have seen this many times before- usually at 5:00 on fridasy when i was on the way out the door
good luck

Aug 17, 2008 | 1993 Oldsmobile Cutlass Ciera

Not finding what you are looking for?
1993 Oldsmobile Cutlass Supreme Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...