Question about 1997 Nissan Pickup

1 Answer

Engine turns over but will not start after going throuigh high water,

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 7,762 Answers

Check distributor cap for water/condensation and wipe dry inside. Also check other ignition components that might have got wet.

Posted on Sep 09, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 06 Chevy cobalt went through high water and shut off in it now it won't start It's been on high ground for about 8 hours now


Depends on high the water was and where it went. Start with removing all the spark plugs and cranking the engine over several times. Let it set for a while. Put in new spark plugs. Before you start it, check the oil. If it is really high on the stick, replace it and the filter. Try to start it then. If still no start, next I would remove the pre O2 sensor and see if it starts. If it does, this means the exhaust system is full of water. As the engine is running plug the hole and let the engine push it out. May take several attempts. And will smoke heavily.

Apr 18, 2016 | Cars & Trucks

2 Answers

Engine over heats


ck your water pump, sounds like no water movement,

Aug 18, 2012 | 1997 Nissan Sentra

1 Answer

How do you install a heater core for a1991 Mazda Navajo


remove dash assembly try to back flush first or drain cooling system put water back in add cascade dish washing soap and drive a couple days if heater starts woreking better turn heat on high run engine open drain with a hose nozel on high and a large pan under drain flush all water out with engine running refill system with heat on high and vehicle running if heat still weak remove heater hoses the top should be the return line put a hose about 8 inces long on both out lets run the bottom hose to a high area where it can be suspended put a funnel in upper hose poor clr into hose until it comes out top of lower hose let set for hour and a half then flush out with water into a clear jug flush water vthrough upper hose then if u have air compressor have a 6 inch hose attatched to upper pipe and blow out core into same jug until the jug has clean and clear water refill cooling system and drive if heat doesnt work at first put engine under a load to release residule deposits in heater core and it should start flowing

Apr 01, 2012 | Cars & Trucks

1 Answer

My mazda 2005 overheat but if i put high rpm like 3000 the temp. go to normal i allready change the termostat and water pump


Sounds like you need a new water pump. When you turn the engine at high rpm's then the pump is pumping faster and circulating the water. But isn't circulating the water good enough at lower rpm's

Sep 16, 2010 | Mazda MPV Cars & Trucks

2 Answers

How to drain and flush radiator


at the bottem on the left or the side there is a small key like screw ( righty tighty lefty lucy } then u must remove the radiator cap and also remove the themastate be sure to attach the therma housing and hose and unatch it at the top of the radiator the put water hose in the open cap area and flush for 20 mins turn on engine and let run for 2 min and repeat flushing untill all antifrez desapears. be sure to put every back tack pitchures as you remove so to put back the same way it might be good to get new thermastate

Jun 25, 2010 | 1998 Ford Taurus

1 Answer

2001 gram am the engine turns but wont statr


Here's where to look. You may have water in the crankcase, engine cylinders, fuel tank, and air intake. Electrical damage is also likely if the car was not dried out before engaging the starting system, and engine computer control system. This will be a tedious task. Dry it out and change the oil. You may have to pull the spark plugs to clear the rest of the water out of the cylinders. There may be water damage to the computer system if the key was turned on while wet. After you are sure it is completely dry, have self test diagnostics run to see if the engine control system is functioning properly. The exhaust should be clear, but if restricted, the engine may not start either. Time is best spent letting it dry and changing contaminated fluids.

Sep 19, 2009 | 2001 Pontiac Grand Am SE

1 Answer

The engine sometimes runs at a very high sound


Hi!
What you can try is to cool the "camshaft rotary sensor" by pouring (normal) water (which I also did just last week) and it works to start & run the car until the next pull-over. You have to redo pouring water if you stop the endine and does not re-start. But this may be just an emergency solution wherein you have to let the car be serviced by a mechanic.

Nov 25, 2008 | 2001 Suzuki Grand Vitara

2 Answers

Po118 the car is not cracking


Is the engine cranking over? Or is the clicking you described all that happens? If the engine is turning over, the first thing you want to make sure of is that you all your connectors plugged back in and that you have spark at the spark plugs.
If the engine is not turning over and you only hear a clicking sound, recharge your battery or replace it and go from there.
Post what you find out so we can go further.

Nov 20, 2008 | Mitsubishi Eclipse Cars & Trucks

2 Answers

Car won't start


clean the carparator

Aug 03, 2008 | 1995 Honda Accord

Not finding what you are looking for?
1997 Nissan Pickup Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...