At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
My hazard lights and flasher works on my 1996 ford Taurus but both turn signals do not. I have changed turn signal fuse and flasher but turn signals still do not work at all.any suggestions?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
There are two flashers, one for the four ways and one for the turn signals. If I remember right the turn signal one is on the backside of the interior fuse box.
If the hazard flasher is working but the turn signals aren't, the problem is most likely either fuse A11 or the #2 relay in the trunk fuse block. However, if these check out, the problem could be either the turn/hazard switch assembly or the turn flasher module.
If both the turn signals and hazard flasher are not working, the most likely problem is the turn/hazard switch assembly.
Check the fuse/relay panel for a blown fuse/relay. Also look at the turn signal flasher and the four way flasher located in fuse/relay panel for problem. If the fuses are good replace the flashers to correct the problem. Hope this will help you.
Take the turn signal lever and jiggle it, a lot. If they start working, the switch is bad. You can also turn on the hazards and take hold of the button and push it left , right , forward and back and see if they start working. If so, replace the turn signal/ hazard switch.
FIRST Check for Blown Fuse Then Locate Flasher Units @ Fuse Block to Determine Wiitch one is Hazard Turn On Key Then Turn Syg. Feel Flashers The One you feel Clicking is For Turn The Other IS Flasher Replace this Flasher unit.
Verify the customer's concern by operating the turn signal/hazard flasher lamp to duplicate the condition.
Inspect to determine if one of the electrical concerns apply: VISUAL INSPECTION CHARTElectrical
Circuitry open/shorted.
Fuse junction panel Fuse:
+
15 (10 A)
+
29 (15 A)
Damaged multi-function switch.
Miniature bulb burned out.
Damaged lamp.
If the inspection reveals obvious concern(s) that can be readily identified, service as required.
If the concern(s) remains after the inspection, determine the symptom(s) and go to the Symptom Chart. See: ProceduresSymptom Chart(s)
×