Question about 2000 Mercury Mariner

Open Question

75hp mariner outboard clicks when shifted into reverse sometimes does not go in revers cable adjusted all the way forward work a ok

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 158 Answers

SOURCE: foward and reverse lever stiff

likely a bad shifter cable

Posted on Apr 03, 2009

Ad
  • 187 Answers

SOURCE: Outboard boat engine shifting problems

Check for a lose or sloppy shift linkage.

Posted on May 14, 2009

finish line
  • 207 Answers

SOURCE: 1999 Mercury Mariner 9.9hp outboard motor

should be on the side with a lever but could you give me more info please

Posted on Jun 27, 2009

  • 677 Answers

SOURCE: lower unit winterize ie.fill with oil....any

Nope .No special tools.Just a big screwdriver to get the inlet and outlet plugs out.Slightly loosen the bottom one.slightly loosen the top one.Take out the bottom one,put the oil bottle on and take out the top one.Fill her up till it comes out the top.Put all the plugs back in.Turn the prop a few turns each week and all should be good.Hope this helps

Posted on Jan 13, 2010

  • 95 Answers

SOURCE: outboard motor won't run under load

I have 1969 5hp Johnson. Starts and runs good, but will only push a 14ft row boat slow at low to medium rpm. When at higher rpm the the motor just revs up and the boat slows down to almost nothing just like it has seaweed around prop.Any help would be great.

Posted on Mar 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1991 Ford F150 won't shift into park or reverse. Will go into neutral and drive, and the linkage at the transmission moves ok


The linkage may be out of adjustment preventing the shifter from moving into reverse or park.
One way to test this is to disconnect the linkage and manually move the lever on the transmision making sure that it can be set into park. Also try moving the lever counting each click from park to low gear to make sure it is clicking into each gear. If this works then the linkage is probably out of adjustment.
On the link cable there is typically a bolt in an oval shaped metal near the transmission shift lever.
1)Detach the shift cable from the transmission shift lever
2)Put the transmision shift lever in the park position, and also the shifter in the cab
3)Loosen the adjustment bolt
4)Reattach the cable to the lever
5)Tighten the adjustment bolt in place
6)Confirm that you can shift through all of the gears
Hope this helps

Dec 01, 2013 | 1993 Ford F150 SuperCab

1 Answer

Ford 2004 5.4 revers not working but drives forward fine


Bad reverse clutch pack, transmission teardown and rebuild needed. Before doing that however, make certain your linkage and cable are properly adjusted.

Nov 02, 2013 | Cars & Trucks

1 Answer

I have honda city 2006 i have problem the car wont shitf in reverese any idea


1.
2.
3.

4.

5.
6.
7.

8.


9.


10.

Forward clutch defective
Reverse brake defective
Reverse brake piston stuck, worn, or damaged
Planetary carrier assembly worn or damaged
Sun gear worn or damaged
Ring gear worn or damaged
Input shaft needle bearing worn or damaged
Thrust needle bearing on planetary carrier seized up, worn or damaged
Thrust washer on planetary carrier seized up, worn or damaged
Shift cable broken or out of adjustment
Manual valve lever and pin worn
Valve body assembly defective
Control valve body assembly defective
Manual valve body defective
ATF joint lines worn or damaged
Inhibitor solenoid valve defective
Transmission range switch defective

Sep 01, 2012 | Honda City Cars & Trucks

1 Answer

Gear shift stuck


Hi Ray, The advise above is good and should be checked out. If that does not solve the problem, before looking for a replacement transmission check and make sure the clutch is fully disengaging. If the clutch is mal adjusted that can also cause a problem with shifting gears. If the gears are stuck and wont shift at all the problem is most likely with the selector rods and/or forks. In that case you'll need major transmission work carried out. Regards John

Nov 19, 2011 | 1987 Chevrolet Spectrum

4 Answers

How to replace water pump on a 1985 90 hp mariner outboard motor


mcdevito75 Here, If I;m not mistaken the water pump is in the lower houseing, a big job, let the marina take care of it as the water pump should be Changed only if it doesn"t pump at all.

Jun 16, 2010 | 2004 Mercury Mariner

1 Answer

3.3 voyager, would not go into reverse went forward a ok, now will go into reverse but wont go forward


With a partner and engine off but key in on (not start) position: Have them shift from Park to Low one gear at a time, while you watch the shift linkage located on top of the transmission. Sounds like the shift cable is loose. IF SO: Place Shift Lever in Park. Loosen the the cable adjustment screw. Move the shift rod (going into the transmission) towards the front of the vehicle until in Park. Tighten the cable adjustment screw to 100 in-lbs. Check Park/Neutral starting only.

Nov 13, 2009 | 2000 Chrysler Grand Voyager

1 Answer

Gear shifter for 40 h. p. mariner outboard


With your lower unit off have someone shift the engine into forward while watching the gear shift select shaft's rotation,let gearshift remain in forward,now place your lower unit in forward and reinstall. In the future just put engine in forward when installing a water pump as there won't be a need to move gearshift

Jul 23, 2009 | 2004 Mercury Mariner

2 Answers

Rough reverse and shifting problems


needs a new valve body on top of the trans

Jun 22, 2009 | 1998 Saturn SL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

fordexpert

Level 3 Expert

5537 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...