Question about 1992 Oldsmobile Cutlass Supreme

1 Answer

Drivers door lock will not unlock I have the inside door panel off but still cannot get it to release

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

The plastic lock slide device was poorly designed. You need to bury you fingers to the base every time you unlock it or it will slip off the inside mechanisms.

Posted on Sep 09, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My hatch won't release from the remote or the door switch. No solenoid sound at the hatch. How do I get it to open if it's not a bad fuse?


There are actually three relays , an there are controlled by the BCM - body control module !
When a door lock switch is activated in the lock or unlock position the BCM will receive a voltage signal on either the door lock switch lock or unlock signal circuits.
The BCM, upon receipt of a lock switch lock or unlock signal, will switch the appropriate lock relay control circuits to battery positive voltage. This will energize the appropriate lock or unlock relays. The relay will supply voltage to the door lock actuator lock or unlock control circuits to one side of the lock actuator. Since the opposing side of the lock actuators are connected to ground through the other lock actuator control circuit and the normally closed contacts of the lock or unlock relay, the doors and liftgate will then lock or unlock appropriately.
Three relays are used to operate the locks. DRV DR UNLCK relay, PASS DR UNLOCK and DR LCK relay. This is done to isolate the driver door lock actuator so it can be unlocked by itself using the keyless entry transmitter.
Rear Hatch/Gate Description and Operation
The liftgate can be opened by operating the switch on the instrument panel. Battery voltage is supplied to the liftgate actuator through the body control module (BCM). The BCM will pulse the liftgate actuator when a release input is received through the key fob, or the instrument panel switch.
Door/Lift gate Latch Assembly
  1. Install a 20-A fused jumper wire between the control terminal 3 and 12 volts. Install a jumper wire between the ground terminal 2 and ground.
  2. Verify the actuator turns on & off.
?‡'
If the function does not perform as specified, replace the applicable door latch.

Oct 01, 2015 | 2006 Pontiac Torrent

2 Answers

Why will my drivers door not open,even though it locks and unlocks with key fob.


Sounds like the activator rod that goes from the door Handle to the latch is disconnected. You will have to get the door open to repair it and a good mechanic or tow truck driver can use a slim Jim kit to get the latch to release and then you can pull the door panel and find the problem.

Jun 29, 2014 | 1999 Volvo V70

1 Answer

Mazda 6 2005 driver door jammed


if you talking about door latch wont let door close.try to reset all door locks.first if you cant get door close.work unlock button with remote or door switch.then hold open door handle while you flat screw driver pull up latch in door latch should stay up so door will close.once get door close.try resetting all door locks by sitting inside vechicle with all doors close.remove key from ignition.open drivers door.wait 24 seconds.turn ignition switch on and back to lock position 3 times.press and release drivers door courtesy light 3 times.ensure doors lock and unlock.if not wait 40 seconds and repeat procedure.if this procedure fails. you have problem in the door latch and lock mechanism inside the door itself.

Jan 04, 2013 | 2004 Mazda 6 Sport

1 Answer

Buick 2002 LaSabre Custom all windows do not go up and down, door lock/unlock switch drivers side does not work(passenger & rear doors lock/unlock door switches work, trunk release button does n


coulb be the control switch on your panel you can take the door panel off and check for loose connections and try to test for continuity. if you dont know how take it to a shop and have them diagnose the electrical. im quite sure it the switch that burnt out

Oct 24, 2012 | 2002 Buick LeSabre

1 Answer

On my 2006 Chrysler 300/ the auto lock button on my key remote doesn't lock or unlock doors?


how do I reset one of two keys that the unlock,lock,trunck does't work but the key turns the engine over.

Oct 08, 2012 | 2006 Chrysler 300

2 Answers

2004 Kia Optima LX gas door and trunk lid will not open using buttons on drivers sdie door?


Most vehicles that have a power release, also have a manual release. Check inside the vehicle, around the location of the outside filler door. You might have a removable panel, that will reveal the fuel door release cable.

Jun 05, 2012 | 2004 Kia Optima

2 Answers

2002 Hyundai Elantra Drivers dorr Lock Jammed not unlocking properly. Lock lever on inside and key on outside are stuck and door move bery much and will not unlock car. Originally cable in door to release...


Same thing happened with mine. It turned out that the power door lock motor went out. Since the handle or the switch can unlock the driver's door, both of these mechanisms are connected. When the door lock motor goes out it freezes in whatever position, it was last engaged.

Nov 06, 2010 | Hyundai Motor 2002 Elantra

1 Answer

2006 325 i door locks not working driver door will lock and other doors stay open if drivers door is locked it needs to be open manually back doors were locked by hand and now wont open by remote


I had a very similar situation. Was very annoying not being able to unlock or lock doors from pannel control nor from remote.
Only driver door can be opened with manual key.

Solution: One of the 15 amp purple fuses was blown. Fuses are located inside glove compartment, the interior end has to be removed releasing the two locks.
Use a light and the red tool located on the panel to remove fuses.

Oct 14, 2010 | 2006 BMW 3 Series

4 Answers

Passlock


turn key all the way on (not to start) let set for 1 hur cycle key and try it.

Jul 20, 2009 | 1999 GMC Jimmy

1 Answer

Car will not unlock.


To get inside the car .... Use the key in the lock cylinder, unlock the drivers door to get inside. You shouldn't have to reprogram the fob unless it or the keyless module was changed. There may be a blown fuse that supplies the keyless control module (check the owners manual for location). or wires that lead into the Drivers door may be damaged ... The keyless module is located inside the drivers door at the bottom behind the door panel ... do the unlock/lock and trunk release switches on the inside of the drivers door operate the locks and or trunk release? If so it is not the fuse ... and not the wires to it ... And it could be your BCM body control module, located in the dash board to right of your gas petal. Because the number entry keypad (code for that is on the inside of the right passenger trunk bracket arm) also doesn't work I assume it's not the key fobs themselves. Your 98 manual is correct for your car.

Apr 02, 2009 | 1998 Mercury Grand Marquis

Not finding what you are looking for?
1992 Oldsmobile Cutlass Supreme Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...