Question about 2003 Honda Odyssey

Open Question

The back hatch on my 2003 Honda Odyssey, beeps intermittently when closed, while I'm driving. It is annoying. What should I look for, to solve this problem? It is the sound I would expect to hear if driving with the hatch open.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 496 Answers

SOURCE: 2003 Honda Odyssey Brake light replacement

open the rear hatch. Between the tail light housing and the rear hatch opening there is a trim strip with two flush fitted flap doors. Insert a small straight blade screwdriver into the small slot on the tail light side of the flap. Pry gently inboard and the small flap will open (the hinge side of the flap is on the side of the rear hatch opening.) Now you can remove the screws that hold the tail lamp assembly in place. Finally, there is still a "spear point" clip that fits into a socket near the front outboard corner of the assembly. Gently pry with a tape wrapped screwdriver (avoids scratches) and force the assembly straight back. The clip should release and free the assembly so you can change the bulb(s).

Posted on Jan 24, 2009

Ad
  • 1 Answer

SOURCE: Replacing a hatch strut

Don't pay the dealer to doit, this takes about five minutes and is very basic.

First prop the hatch up, the closer to full open the better.

Second, locate the spring retaining clip at each end of the strut.

Third, with a small point, flat blade screw driver, carefully pry the spring retaining clip loose from the strut end. It actually kinda slides in a groove until it's free of the strut end. Repeat for the other end of the strut.

Forth remove the strut from the vehicle.

Now you can install the replacement strut. Installation is reverse of removal; you should start with the retaining clips pulled back from the strut ends. attach one end, secure the retaining clip, then adjust the length of the strut and the height of the door until you can attatch the other end. I found that securing the bottom end of the strut to the body first made it easier to attach the top, instead of the other way around.

Also, a good place to look for parts is www.hondapartsdirect.com; best prices on new dealer, OEM parts as I have found anywhere.

Posted on Feb 22, 2009

emissionwiz
  • 76691 Answers

SOURCE: Right rear window of 2004 Honda Odyssey will close.

you can close it by pulling the door panel and removing the electric motor that raises the window, then lift the window closed and reinstall the motor, but the motor is most likely defective so if u go to all that hassle just replace the motor.

Posted on Mar 30, 2009

  • 58 Answers

SOURCE: replacing rear hatch door cylinders on honda

Why are you replacing? If your just wanting to get them off pull the ends out and slide them off hte ball. May need a small flat screwdriver or a "vessel" for this.

Posted on Aug 12, 2009

  • 1 Answer

SOURCE: Honda Odyssey 2005 sliding doors won't open, beep 3 times

If you click once your remote control ,will open just driver side doors.To unlock all of them have to press twice , and then sliders.

Posted on Sep 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What s the procedure to change stop light 2006 honda odyssey


Open the rear hatch. The lens assembly is held in place with two 10mm bolts located on the side panel, just under where the hatch closes.

after you remove the bolts the whole lens assembly will pull out and expose the bulb sockets.

Here is a video for a 2007 model. it is the same as yours.

Mar 14, 2015 | 2006 Honda Odyssey

1 Answer

Key fob will not unlock rear hatch 03 odessey key works


only rear fails
do ALL the manual switch controls work on that hatch?

Dec 20, 2013 | 2003 Honda Odyssey

1 Answer

2004 Honda odyssey battery light, brake, and all door lights on


close the doors and start engine
the cluster lamps all glow key on , not started engine,that is normal.
tell the full story.
i open car door, sit in drivers seat
close door.
then.... you see what?
then key on
see lamps glow, that is normal.
start engine, see them mostly out,normal.
the lights not out, now,are called warnings.

RTM? or Read the meticulously formulated manual RTMFM.
see here. read , the section on, before driving...
http://justgivemethedamnmanual.com/honda/honda-odyssey-owners-manuals/

Aug 24, 2013 | 2003 Honda Odyssey

2 Answers

I own a 2005 honda odyssey ex...have an ongoing problem with the sliding doors on both sides.doors close, but within seconds they beep and reflect not being locked.this is an ongoing problem.have brought...


check to see if there are elect contacts in front of each door at the door jamb,,perhaps they need cleaned with steel wool...hope this helps,,,it does on my windstar..

Feb 26, 2010 | 2005 Honda Odyssey

1 Answer

Door sensor going off when driving


scotch brite the contacts , see if that helps.

Oct 19, 2009 | 2003 Honda Odyssey

1 Answer

2004 Honda Odyssey EX brake light replacement. How do you remove


open the rear hatch. Next to the brake light assembly, between it and the hatch there are two flap doors in the brake light trim. Take a small flat blade screwdriver and open these doors. The hinge side of the flap is nearest the hatch opening. When opened, the flaps will reveal two screws. Remove these. Then wrap a flat blade screwdriver with some tape (protects the paint) and put the blade at the front outside corner of the brake light assembly. Pry gently rearward and a plastic spear point clip will release. With the assembly off, you can see how to twist out the bulb sockets and replace the bulbs. to replace, put the spear point clip in first, replace the screws, and close the flaps in the trim.

May 30, 2009 | 2004 Honda Odyssey

1 Answer

Door will not slide automatically; emits loud beeping noise


Something similar to that was happening with our Odyssey...the beeping when you are driving whether it's ongoing or intermittent is the "safety alarm" letting you know the door is not closed. The power lock is not engaging. What I do when I get the beeping while driving is hit the Door Close button. It causes the door to attempt to engage again. To fix it...we first cleaned out the space below the side running board (kids were hiding crayons and things in there), then looked for any obstructions along the top and bottom tracks. I sprayed a lubricant along the tracks (I'd suggest the dry lube kind...I used WD40 the 1st time and had streaks of it dripping down after driving), use a lube that has a long straw to spray in small places...and spray up into the track that runs the length of the middle of the car. Manually open and shut it a few times to get the tracks lubed, then try it out.
If you press the open OR close button by remote or in the car and get nothing...no movement/no noises/no beeping...then it could be the electrical circuit itself, the signal itself may be impeded...or the motor shot. Have you tried any of these suggestions before?

Mar 16, 2009 | 2000 Honda Odyssey

1 Answer

2002 Honda Odyssey brake light replacement


open the rear hatch. Next to the brake light assembly, between it and the hatch there are two flap doors in the brake light trim. Take a small flat blade screwdriver and open these doors. The hinge side of the flap is nearest the hatch opening. when opened, the flaps will reveal two screws. Remove these. then wrap a flat blade screwdriver with some tape (protects the paint) and put the blade at the front outside corner of the brake light assembly. Pry gently rearward and a plastic spear point clip will release. With the assembly off, you can see how to twist out the bulb sockets and replace the bulbs. to replace, put the spear point clip in first, replace the screws, and close the flaps in the trim.

Mar 05, 2009 | 1997 Honda Odyssey

1 Answer

2003 Honda Odyssey Brake light replacement


open the rear hatch. Between the tail light housing and the rear hatch opening there is a trim strip with two flush fitted flap doors. Insert a small straight blade screwdriver into the small slot on the tail light side of the flap. Pry gently inboard and the small flap will open (the hinge side of the flap is on the side of the rear hatch opening.) Now you can remove the screws that hold the tail lamp assembly in place. Finally, there is still a "spear point" clip that fits into a socket near the front outboard corner of the assembly. Gently pry with a tape wrapped screwdriver (avoids scratches) and force the assembly straight back. The clip should release and free the assembly so you can change the bulb(s).

Jan 22, 2009 | 2003 Honda Odyssey

Not finding what you are looking for?
2003 Honda Odyssey Logo

Related Topics:

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...