Question about 2002 Saturn VUE

1 Answer

Car drives fine untill you reach 55 and then vibrates underneath about dead center of car

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 228 Answers

Does steering wheel shake? How about when you brake?
Do you feel it in the floor,or the steering? Are you haveing to add transmission fluid? Check axle shart runout? Cv joints? In board Bushings in The transmission Housing do the inboard seals leak any? Is the transmission wet with fluid and dripping on floor?at the center of the car?

Posted on Sep 08, 2010

  • Patrick Ouellette Sep 19, 2013

    I have the same problem. when i reach 55 km/h the vibration starts and stop around 60. it comes back around 80 and stop at 90. it doeas it when i'm not accelerating fast . if the moro revolutuion is hight i don't have trhe problem. i had the center bearing changed ans rear axe fluid changed couples of months ago??

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vibration in driveline in 4wd at 40 mph+


Have the u joints checked on the drive shaft that goes from the front diff to the transfer case one or more my be seized or loose .

Jan 29, 2014 | 1998 GMC Sierra

1 Answer

Car has a clanking sound in park while running coming from under car on drivers side close to dash area. Vibrates and makes sound until the car reaches around 30mph and then quiets down.Runs just a little...


Sounds like catalytic converter inner material broken up inside casing. To verify, with vehicle thoroughly cooled down , raise vehicle high enough to get underneath, use jack stands for safety, and fist pound converter and listen for similar rattle.

Jan 10, 2014 | 1999 Buick Park Avenue

1 Answer

I need the points gap for a 1940 dodge business coupe


Top dead center:*Set breaker point gap from .018 to .022*Bring #1 piston to "Top Dead Center"*The zero "D-C" mark on the vibration damper must be aligned with the timing indicator/pointer*Rotate distributor until points begin to open slightly, then tighten distributor*Start engine & allow to reach normal operating temperature*Set warm idle at 475 RPM*Use timing light to verify that the zero "D-C" mark on the vibration damper is in alignment with the timing indicator/pointer

Nov 26, 2011 | Cars & Trucks

1 Answer

On a very cold day last week, I self washed my HHR. Spraying the wheel wells and under carriage and rims, extensively. When I finish I got on a state hiway and when I reached 55-58 mph, the rear end of the...


I would suspect a bad tire with a broken belt.. Have the tires inspected.. Or perhaps a broken shock or strut..Spraying water to the underside should not cause this type of issue..

Have a great day

Mar 06, 2010 | 2008 Chevrolet Hhr

3 Answers

Car shaking and vibrating at 55 mph. and does it again at 65-70.


Hi:
Since your BMW 540 series is a rear wheel drive car, a common cause of that sort of vibration is often the U joints on your drive shaft. The vibration often only shows up and certain speeds.

It isn't a particularly expensive repair, but is something to have checked out!

Nov 03, 2009 | BMW 5 Series Cars & Trucks

1 Answer

There is a vibration in my 1998 Chevy S10, 4 cyl., 5 transmission truck when I shift into 3rd gear. The vibration lasts until I reach about 38 MPH and then stops. There is also a clunking sound when I...


well i would check your universal joint's put the parking brake on and block the wheels put the car in n and reach under truck and see if there is play in universal if so need replacement if you have two peace drive shaft check your center support bearing good luck if these check good it could be in transmission good luck redoil

Aug 06, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

Whenever I turn on my car there is alot of vibration from engine


bad engine mount make car shake.cylinder misfire make engine shake.

May 10, 2009 | 2000 Mitsubishi Eclipse

1 Answer

Vibration at speeds of 45-55mph


Check your drive shaft u-joints..Number one cause.Have a great night!!!

Apr 03, 2009 | 1995 Dodge Dakota

1 Answer

Rhythmic vibration in 1986 bmw 735i


If I remember correctly, does your drive shaft have a locking coller
nut between the 2 sections. If there is a locking collar nut, make sure to not overtightend it. When the driveshaft changes loads, the 2 piece driveshaft should have the ability to slide, and that is why the collar nut should not be over tightend. One other thing to look for is when bolting the transmission bracket to the frame, make sure that it is equal on both sides, otherwise the transmission can sit crooked. It's been a while since I have worked on a pre-90's 7. Hopefully you won't need that driveshaft.

Mar 15, 2009 | 1986 BMW 7 Series

Not finding what you are looking for?
2002 Saturn VUE Logo

360 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...