Question about 1994 Mazda 323

1 Answer

Excessive smoke was release when i use my car after putting automatic transmission fluid.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

Trans fluid is leaking onto exhaust pipe, either level to high or bad seal.

Posted on Sep 08, 2010

Testimonial: "transmission has a leak...we already fixed it..thank you very from philippines.."


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Transmission will only shift in 4 low,no codes showing

1994 GMC 4l60e transmission shifting problems - CarGurus > Questions > GMC > Sierra 1500
CarGurusJan 17, 2011 - 1994 GMC 4l60e transmission shifting problems - I've got a 1994 GMC Sierra 4X4 5.7 I ... If you put it in low and lift the handle, it will go into second .... Justchange 1-2 - 3-4 solenoids first and if that doesn't work change the ...

Troubleshoot automatic transmission problems
Jul 15, 2015 - Rescan the PCM for trouble codes, if none appear the problem could ...Excessively low transmission fluid (Note: If transmission is operated for an .... it waslow, and now my car will only shift from 1st to 2nd manually and will ...

Nov 03, 2015 | Cars & Trucks

1 Answer


If smoke is black indicates too much fuel
If smoke is white Could be coolant in the exhaust system
If smoke is blue possible excessive oil entering in the combustion system
Also if you have an automatic transmission with a vacuum modulator, it could be leaking transmission into the combustion
If you have too much oil in the engine, it will also smoke

May 06, 2013 | 2007 Honda Accord Sedan

1 Answer

Gear shift locks and car will not start

For Automatic transmission problem,click the link below:---- Automatic transmission troubleshooting:----

Automatic transmission shift lever issues?-------




Transmission fault light on car dash?

Transmission shifting problem?

Transmission Slips out of 2nd gear?

OD light flashing and transmission fluid leaking?

Why Transmission fluid leaks near radiator?

Transmission fluid leaking?

****** wont go in reverse?

Automatic transmission will not go into reverse?

Transmission is making buzzing noise?


This will help.


Feb 19, 2012 | 1999 Toyota Camry

1 Answer

How do i put fluid in the automatic transmission of a 99 jetta?

Volkswagon says the transmission fluid is supposed to be good for the life of the car and therefore they make no provision for adding fluid. There is a breather with a plastic cap on the side of the transmission that you can use to fill the unit. There is no dipstick, so to find out if it is at the proper level VW has a tube into the pan at the drainplug which automatically levels the fluid. You fill at the breather and after removing the drainplug wait until it stops leaking or dripping. It is then at the right level. The excess fluid in the pan overflows the tube and drains out. Sounds complicated but I hope my crude explanation helps!

Dec 30, 2010 | Volkswagen Jetta Cars & Trucks

1 Answer

Need to check transmission fluid in my 06 tundra

On that particular vehicle there is no dipstick. There is a fill plug and an overflow plug on the transmission itself. To fill the transmission, you must use the Toyota manufacturer's automatic transmission fluid and have the vehicle on a flat, level surface. Remove the overflow plug and place a drain pan under it to catch any excess that runs out. Remove the fill plug, and fill the transmission with approved fluid until it begins to run out of the overflow hole. Wait until the excess has finished draining out, then reinstall the overflow and fill plugs and you're all set.

Oct 25, 2010 | 2006 Toyota Tundra

1 Answer

Transmission fluid is low with no leak. Where is the fluid going?

I would rec putting a flor dye in trans fluid which you can by at Autozone and using a UV light also you can purchase an inexpoensive one from Autozone to check for external leaks first. Otherwise sometimes fluid can be burned off or sucked through vac ports and burned in engine. If you notice excessive smoke then that could be the cause.

Jun 17, 2010 | 1998 Chevrolet Blazer

1 Answer

I have a 1994 ford E-350 Diesel 7.3 automatic moving truck that has some trani problems. When i put it into overdrive, it flashes and blows smoke when i slow down or put it in reverse. I disconect the...

.The seal that keeps fluid inside the transfer case and thus the transmission is vital for the smooth operation of the vehicle's transmission. When fluid is leaking from a broken seal, it reduces the volume of fluid that is currently working inside the transmission. A loss in fluid pressure also occurs, which will make shifting gears more difficult for an automatic or manually shifted transmission. If you notice that your transmission is having difficulty shifting to higher or lower gears, you should contact a certified mechanic as soon as possible to inspect this problem and offer a solution.

Nov 07, 2017 | Ford Cars & Trucks

1 Answer

Starts first time, no smoke on normal running, then rev up and white smoke comes out??? no wrong feul!!! changed air, oil and feul filters, but still throwing out white smoke on reving... can anyone help?...

It could be a coolant or transmission fluid leak in the combustion chamber. Check your coolant and transmission fluid to see if one or both are low. White smoke from the exhaust is a classic symptom of a blown head gasket, have your cooling system pressure checked. If that checks out good then have your transmission checked.

Sep 01, 2009 | 1992 Toyota Corolla

2 Answers

Car cuts out when reversing

this could possibly be a bad motor mount letting the engine rock to pinch hoses for vacume and or wiring . if you can watch the engine with the hood up and the car running with the brake peddle depressed and the parking brake on move the gear selector from D to R if automatic if manual let out the clutch just enough to put a little pressure on the engine and watch for excessive movement in the engine.

Aug 29, 2009 | 1993 Ford Festiva

1 Answer

Excess transmission fluid

The easiest way is to pull the line off and put a rubber hose over the connection. Crank the engine over. The best way is to drop the pan and put a new gasket on it and fill it with 4 quarts of fluid. Look at your dipstick, it will tell you whether the truck needs to be in neutral or park to check the fluid.

Jul 07, 2008 | 1991 Dodge Ram 150

Not finding what you are looking for?
1994 Mazda 323 Logo

Related Topics:

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8755 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides