Question about 2000 Ford Excursion

1 Answer

Front blower not working - 2000 Ford Excursion

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 40 Answers

Check the fuse then check the motor at its leads with it hooked up and see if its getting power if it is not getting power check the fuse to the cluster for the heat and cool if good then most likely its the swich

Posted on Sep 08, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Front blower not working


Could be that the front blower has its own separate fuse than the rear....start with the fuse as its inexpensive....if this does not work, it could be a sensor that controls and adjusts the blower...

May 10, 2013 | 2005 Acura MDX

1 Answer

2001 sequoia front ac blower not working, blower motor is OK


Sounds like a Controller Issue with the Climate Control. Seeing that you applied power and it worked, then it is not the Motor.

UNLESS you try it on ALL SPEEDS and if it then does not work, you have an Input problem.

If it only works on ONE SPEED, then you have a Resister Issue for the Blower

Apr 06, 2013 | 2003 Toyota Sequoia

1 Answer

Blower motor always high front and rear


look in the fuse panel there is a fuse for blower high and blower low check the one for blower low the location is on the inside of the fuse box lid

Mar 27, 2013 | Cars & Trucks

1 Answer

AC won't work in the front of the car. It works in the back


{: ) If the rear a/c is cooling normally, check again your front a/c settings. Try to operate blower at all speed settings, if one speed is missing or none at all. It could be that the front blower is working but the air is just diverted elsewhere.
If the front blower is not working at all speeds, it's either your blower resistor or your blower motor that is faulty. Usually it is the blower resistor.
But before proceeding deeper, you should check first the fuses. At the underhood fuseblock, check out the BLWR fuse 40amp. And on the rear fuseblock, check all the fuses labeled HVAC. There could be two or three of them.

Jul 02, 2011 | 2006 GMC Envoy

2 Answers

The front heater/air conditioner blower stopped


First check the voltage at the front blower moter. If it has voltage then it may just need a new motor.

May 17, 2010 | 2001 Dodge Grand Caravan

1 Answer

Front blower dont work but back blower works


First Check the Front Blower Relay located in the IPM Fuses and Relay box in the Engine Compartment. There should be individual Front and Rear Blower Relays. The Identification and Location should be on the rear of the IPM Cover. If not check your Owner's Manual.
Switch these two Relays and recheck operation of the Front and Rear Blowers again. If the Front now works and the Rear does not, then the Relay was bad and needs to be replaced.
However the most common problems I have found is that the Front Blower only works on High. Is that the Case? Check it to be sure. If it only works on High then it is 100% the Resistor that is bad and needs to be replaced. The Front Blower Motor Resistor fail in these more often that the Blower Motor itself.
Remove the Dash Glove Box out of the Dash to gain access to the Resistor.
Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.Com!

Feb 16, 2010 | 2004 Dodge Grand Caravan

2 Answers

Front Air condition blower quit working


Check for BLOWER RELAY Problem if RELAY is Good the BLOWER MOTOR is BAD

Jul 12, 2009 | 2005 Dodge Durango

1 Answer

Front blower motor doesn't work, rear does


check or replace your front blower motor resistor. this is the most common problem aside from a bad blower switch. you could also try to recalibrate your system but that usually doesn't work. I'm betting on the resistor.

Apr 30, 2009 | 1998 Plymouth Voyager

1 Answer

Blower motor does not operate, front defrosters not blowin


  1. Disconnect and isolate the negative battery cable.
  2. Remove the glove box from the instrument panel
  3. Disconnect the two wire harness connectors from the front blower motor resistor.
  4. Remove the two screws that secure the front blower motor resistor to the front HVAC housing and remove the resistor. 815198ec.gif

Mar 12, 2009 | 2003 Chrysler Town & Country

1 Answer

Front Blower does not work


the resister is located behind clove box or under dash passenger side this more than likely is the problem

Jan 30, 2009 | 2001 Dodge Grand Caravan

Not finding what you are looking for?
2000 Ford Excursion Logo

Related Topics:

212 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...