Question about 1988 Chevrolet S-10

1 Answer

I have a chevy S10(S14) with an add-on A/C system possibly from factory but afterwards if you understand what I mean but my question is 1.I can't get air to blow through dash vents or rather the (white) vaccum line going to the actuater doesn't have any vaccum but there is no obstructions and the switch seems to be OK and when you switch the lines it will work 2. we don't know how much freon goes in the system because we can't find any literature

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert that hasĀ over 500 points.


    An expert who has answered 200 questions.

  • Expert
  • 228 Answers

Look for a site glass on the small high pressure line.This will be helpful when you charge the system. Charge the system at a fast idle or slightly above 1200 to 1400 rpm.As you charge you will see bubbles in the glass and a fommy look to the freeon as you charge the A/C It will start to cool even before the bubbles go away. Keep charging untill the site glass clears up! Stop as soon as there are no more bubbles seen.This is the best way i know how for you to charge the system and not check the high side pressures as you charge.

Posted on Sep 08, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1998 chevy S10 4x4 4.3 engine a/c compressor bolts

Hey Waynelee.. I would go to the local Chevy/GMC dealer and get the factory bolts..( and they usually offer some good advice when you tell them what you are trying to accomplish)...

Jun 16, 2017 | Cars & Trucks

1 Answer

200 chevy s10 2.2L 5sd 2wd code P0171 indicates that the bank 1 system is too lean for predetermined period of time

It means the engine fuel air mixture is incorrect. Too much air makes lean fuel burn. The computer will try to adjust by enriching the fuel air mixture. At some point it reaches a limit and kicks a code. Check for sources of intake or vacuum leaks.

Mar 15, 2017 | Chevrolet S 10 Cars & Trucks

1 Answer

What would cause you to lose fuel pressure while driving.

Chevrolet S-10 Questions - Fuel System Loses Pressure ... > Questions > Chevrolet > S-10

CarGurusJul 28, 2012 - Fuel System Loses Pressure - I have a 2003 Chevy S-10 Pick Up with the 4 ... car a few times, what essentially you are doing is priming the fuel pressure. ... A dirty fuel filter will not cause the lines to lose pressure after the engine is shut off. ... I have a 98 s10 2.2 liter and it was driving fine all day then when ...

Chevrolet S-10 Questions - My 2001 S10 has a hard starting ... > Questions > Chevrolet > S-10

CarGurusSep 16, 2012 - My 2001 S10 has a hard starting problem if the truck sits between 1 ... Vacuum leak, have you checked fuel pressure while it sits? ... Would the spider alsocause a misfire at low rpms? .... at an idle, or squeaking while driving and it gets faster as you go? ..... 1994 Chevrolet S-10 2 Dr STD Standard Cab LB.

Chevy S-10 Won't Start - Repalced Fuel Pump and Pressure ...
Chevrolet S-10 pickup won't run and has no fire unless I jumper the fuel pump relay. ... Once the truck starts and is running you can remove the jumper to the fuel pump ... Iwould get the fuel pressure checked to start with, because that's where the ... 93 gmc 4.3l FI runs but dies out loss of power after 5 mins of running then ...

Stalling S10: I Have a 1994 Chevy S10 2.2l It Stalls After 35 ...

Dec 10, 2015 | 1994 Chevrolet S-10

1 Answer

Throttle housing diagram for 1996 Chevy S10. 4 cylinder pick up truck

Sorry I have the tech to send diagrams .
However I do have the factory manual for this engine .
Why don't you send some more information and likely I can solve your problem

Mar 14, 2015 | Chevrolet S 10 Cars & Trucks

1 Answer

Replace the cat back exhaust in a 2002 chevy blazer (S10)?

If there is no flange just in front of the cat then it has to be unbolted from the manifold, If this is not possible you will have to cut pipes and purchase sleeves to connect afterwards hope this helps.

Jan 23, 2015 | 2002 Chevrolet Blazer

1 Answer

Chevy s10 change fuel pump now nothing works it wont say anything

What year--engine size? What do you mean, "it won't say anything?" I don't understand?

Nov 23, 2014 | Chevrolet S 10 Cars & Trucks

1 Answer

My 1996 chevy s10 won't stay cranked

Possibly the antitheft system. Check out this link and see if this sounds like your problem.

Mar 23, 2014 | 2003 Cadillac Escalade

2 Answers

What do the trouble codes mean? p0305 and p0135


May 01, 2009 | 1997 Cadillac Eldorado

2 Answers

Brake light on my chevy s10 blinks

Check the brake fluid level and add as needed.

Please rate this a fixya

Feb 01, 2009 | 1991 Chevrolet S-10

Not finding what you are looking for?
Cars & Trucks Logo

333 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides