Question about 2001 Mazda MPV
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Welcome to FIxYa.com Follow the upper radiator hose to the engine thermostat inside that house. Make sure dot on thermostat shown above is the correct way.
Regards, Lee Davidian Thank you for using FixYa,com.
Welcome to FIxYa.com
Follow the upper radiator hose to the engine thermostat inside that house. Make sure dot on thermostat shown above is the correct way.
Regards, Lee Davidian
Thank you for using FixYa,com.
Posted on Oct 28, 2010
if you do not here the motor then its the regulator or motor that needs to be replaced/ cif you hear the motor check the control switch on the trim panle coould be just a five dollar part to replace/ Please rate my response thank you very much
Posted on Jan 31, 2009
I replaced this sensor about 6 months ago. (If this is the sensor that is located near the firewall on the exhaust manifold under the ignition coil.) The only way to easily replace it, is to remove the MAF and air filter assy. then remove the intake plenum, remove the ignition coil, and then you'll have access to the sensor. You'll need a sensor removal socket. If the socket slips around the hex of the sensor, then you'll need to use a regular deepwell socket and cut the cable from the top of the sensor, or use a combination wrench that will fit it.
The most difficult part of removing the intake plenum is getting the nut loose from the EGR valve. DO NOT just remove the two bolts holding it to the intake plenum. It will not line up correctly during re-assembly and may not seal tightly either.
This took about a Saturday to do. You'll need new plenum gaskets to replace the old. While your at it remove the throttle body and clean the carbon from the ports that lead to the EGR valve and replace that gasket as well. The gaskets will run about $30.
Posted on May 04, 2009
you must remove axle and plastic cover behind wheel exhaust section 4 bolt crossmember disconnect battery first 3 bolts on block for axle brace 2 bolts hold brace to axle tensioner pulley is reached from below support on jack stand far enough back so it doesnt get in the way good luck may the force be with you
Posted on Sep 13, 2009
Tips for a great answer:
Nov 29, 2015 | Mazda Cars & Trucks
Jun 12, 2012 | 2001 Mazda MPV
Feb 12, 2012 | 2001 Mazda MPV
Jan 12, 2011 | 2001 Mazda MPV
Aug 18, 2010 | 2001 Mazda MPV
Jan 07, 2010 | 2001 Mazda MPV
Apr 07, 2017 | 2001 Mazda MPV
Apr 06, 2017 | 2001 Mazda MPV
910 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: