Question about 2001 Oldsmobile Bravada

1 Answer

Wont put out heat is it the thermostat - 2001 Oldsmobile Bravada

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 120 Answers

Probable causes are thermostat,and low coolant

Posted on Sep 07, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What's the effect of removing a thermostat from a 4D56 L200 triton engine?


any time you omit the thermostat the heater wont work but the engine will operate at a cooler temp. I live in a hot climate year round and we southerners leave out the tstats on older jalopy.

Dec 23, 2016 | Cars & Trucks

1 Answer

1996 MAZDA MPV HEAT WONT GET HOT ENOUGH


You need to put a higher temperature thermostat in. Try a 200 degree thermostat and make sure that you have a full radiator. Also you could dilute your antifreeze a little more than 50/50 .
I would also try a 70/ 30 mix. Hope this helps.

Feb 18, 2015 | 1996 Mazda MPV

1 Answer

Cuttlas Ciera Wont Turn Over!!!


Sounds like it seized when you shut the engine off after driving it while overheated.

Jul 10, 2014 | Oldsmobile Cutlass Ciera Cars & Trucks

1 Answer

99 dodge stratus 2.4 liter 4 cyl heat wont work overheating if change thermostat works good on first run stops working again after shut off and cools then restart


I'm not trying to insult you but are you sure that the thermostat was put in right side up? I have seen this happen and have done it myself. Hope this helps!

Jan 05, 2011 | Dodge Stratus Cars & Trucks

1 Answer

I have a service engine soon light on. I was told it was either the temp sensor or thermostat. replaced the thermostat and now the heat wont turn on.


Meaning your not getting any heat? I would suspect a higher temp thermostat was put in, and now its taking longer to get heat... Its also possible the thermostat is faulty... Either way, I would try a new thermostat again... The check engine light wont come on from a thermostat so change the CTS...

Jan 25, 2010 | 2001 Buick LeSabre

1 Answer

Have 1990 voyager 3.3 that the engine wont heat up. replaced water pump, replaced thermostat( 6 times), have flushed heater core(lots of crud), no air bubbles in radiator when running,has winter...


are you using a 190 degree thermostat..do you have a faulty sending unit,also check the heater control valve,make sure you are putting the thermostat in correctly,dont mean to make you sound bad,some of these thermostats are funny

Dec 12, 2009 | 1990 Plymouth Grand Voyager

1 Answer

Need to replace a Thermostat on a 2001 PT Cruiser. Have the new Thermostat need insturctions on how to do the replacement.


Most thermostats are located in the upper radiator hose housing mounted to engine block. Make sure engine is cold put a catch pan under your car to catch any antifreeze that comes out. Remove the two bolts holding the housing on the engine and remove thermostat and gasket. Clean engine block where gasket goes very good and also the housing, have to remove all gasket material so when installing new one it will seal and wont cause a leak. Make sure when you put the thermostat back in it goes in spring side down towards engine. Replace housing and bolts. replace lost coolant with a 50/50 mixture in your recovery tank. Start engine let heat to temp and check for leaks.

Sep 08, 2009 | 2001 Chrysler PT Cruiser

1 Answer

93 buick skylark car wont start in part but once


neutral safety switch...the linkage isnt allowing it to fully be placced in park so the signal is acting like it is in reverse, it is in the collumn

Feb 21, 2009 | 1993 Buick Skylark

1 Answer

My 99 dodge dakota wont heat new thermostat motor


You have a bad heater valve, operated by vaccuum or cable its on the hot water line on its way to the heater core.

Feb 20, 2009 | 1997 Dodge Dakota

2 Answers

Car will not heat up


Did you "bleed " the system when you filled it with coolant ? You have to put in a some coolant and water.1/2and 1/2 mixture, Make sure it is the right coolant. All color coolant works fine.Rune the vehicle for a while . Turn off the vehicle and let it cool. Turn the radiator cap and a hiss of air will come out. Use a Rag . Be careful not to burn yourself. The pour some more coolant and water . And repeat the process until radiator is full. Some cars have a bleeder valve that you turn counter clockwise with a screwdriver near the thermostat housing or near the radiator hose .

Jan 09, 2009 | 2001 Dodge Neon

Not finding what you are looking for?
2001 Oldsmobile Bravada Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...