Question about 2003 BMW 325

1 Answer

On my 1984 bmw 325e im having problems gettin both driver and passenger windows down the switch is lighting up but when i press the switch its blacking out no noise or anything what should i do to fix that?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    Visited the website for 3 consecutive days.


    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 66 Answers

Fuses, or power window motors, it's not uncommon for both motors to conk out at the same time. It's 26 years old. Maybe your ground wire is to the motors could be broken

Posted on Sep 07, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Most of my guages(speedometer, mpg,thermostat and mileage) dont work but my rpm and gas workWhat seems to be the problem?

is it a digital read out dash ? if so i'd say it needs replacing , i presume you've checked the fuse's

Jul 15, 2014 | Cars & Trucks

1 Answer

Passenger side window

You don't list what the problem is but I am assuming the passenger window is not going up or down. If it works from the driver side and not the passenger side then it is the passenger switch. If it does not work from either side it is the driver side switch. They are about 50 dollars and very easy to replace.

Apr 14, 2014 | 1999 BMW 323i

1 Answer

My 1984 bmw 325e DASH BOARD LIGHTS dont work

Check a couple things:

1. Verify that the dimmer switch for the dash lights isn't in the full dim position (it turns off the dash lights).

2. Check your fuse panel (in the engine compartment) for a blown fuse.

Jan 02, 2014 | 1984 BMW 3 Series

1 Answer

How do you change the oil on a 1984 325e BMW?

Please watch the YouTube video on the general info needed to change oil.

Nov 07, 2012 | 1984 BMW 3 Series

1 Answer

84 325e: when you 1st take off, there's a heavy loud knocking from underneath the car, in the area behind the passenger seat. Once you reach 20-30 mph, it stops. Thanks for your help..

It sounds like the driveshaft carrier bearing is bad, Once you reach speed the centrifical force of the driveshaft centers it and the noise goes away. Most noticable at take off.

Dec 28, 2010 | 1984 BMW 3 Series

1 Answer

Bmw 325e power windows both stopped working at the same time. Fuse is the same for the power sunroof which still works. I jumped power to the window mortor and the motor works. i also already went thru and...

hey did you ever figure this out? Im working on the same problem right now... have power to the sunroof and just replaced the 25amp circuit breaker that is right after the sunroof... I have a circuit diagram if it would help you at all

Feb 21, 2010 | BMW 325 Cars & Trucks

2 Answers

Im buying a 1986 bmw 325e and it has a check engine light im familiar with locations and diagnostics of obd 1 and 2 vehicles but im not sure how and where to pull codes off of this vehicle is there a plug...

You can get hte codes from this BMW by turning the ignition key to the run position and then press the accelerator pedal to the floor 5 times, it will enter the diagnostic mode, count the flashes just like obd 1. Hope this helps, let me know

Nov 29, 2009 | 1986 BMW 3 Series

1 Answer

Window motor expired.

If you look very closely, the motor does unscrew from the regulator. However, getting the regulator is a bi***. Remove all the bolts to loosen the regulator and carefully work it around towards the biggest opening. The neumatic little hose is bendable, but be careful. Prior to doing this, remove a switch from another door to elimate a faulty switch. The plug comes down from above. You need to stick your hand inside the door well to find it. If you need the regulator too. just go down to the junk yard and practice removing the motor and regulator.

Apr 09, 2009 | 2001 BMW 325

1 Answer

1985 bmw 325e

Its your transmission...BMW made bad transmissions up to 1990.

Jul 15, 2008 | 1984 BMW 3 Series

2 Answers

BMW 325-e4 clutch

your clutch slave cyclinder underneath the car is probbably leaking

Jun 11, 2008 | 1984 BMW 3 Series

Not finding what you are looking for?
2003 BMW 325 Logo

Related Topics:

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers


Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides