Question about Dodge Ram 3500

1 Answer

1999 dodge ram 3500 diesel how to replace the crankcase positioning sensor and where is it located?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Transmission bell housing, for a diagram go to sinautoscan.com/forum

Posted on Sep 07, 2010

  • abstlc Dec 24, 2010

    its behind the starter. pull the starter, 3 bolts 10 mm 12 point wrench, and one bolt on crank sensor, you may have to move the dipstick, a little to pull it straight out,, Also disconnect the batteries, he RED wire on starter will arch, if you ground it!! jc

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can I get a wiring diagram for a 1997 Dodge RAM 3500 diesel pickup?


1997 3500 Wiring Diagram - Dodge Diesel - Diesel Truck Resource Forums

www.dieseltruckresource.com/...dodge-ram.../1997-3500-wiring-diagra...
Jan 24, 2011 - Hey guys, I'm working on a 97 3500 that's had the bed removed and replaced with a flatbed. There is the biggest mess under that truck wiring wise and. ... 2007 Ram 3500 A/C compressor wont engage, need wiring diagram ...

Dodge Wiring Diagrams / Schematics - YouTube

? 1:13
https://www.youtube.com/watch?v=UI6_vhCHFYU
Nov 19, 2013 - Uploaded by Robert Nauert
Dodge Wiring Diagrams / Schematics ... Nitro, Power Wagon, Ram 1500, Ram 2500, Ram 3500, Ram 4500 ...

1997 Dodge Cummins - Full color wiring diagrams - 12 Valve ...

forum.mopar1973man.com/.../1638-1997-dodge-cummins-full-color-wi...

Jan 01, 2016 | Dodge Cars & Trucks

1 Answer

Location of heater fan resistor on 2004 dodge ram 3500 diesel 2wd


Please visit this YouTube link for a detailed explanation on the location and how to replace the resistor. http://www.youtube.com/watch?v=5Q2rM1pGw5k

Thanks,
Will

Dec 01, 2013 | 1998 Dodge Ram 3500 2WD

2 Answers

My 1997 Dodge 3500 diesel is having a gauge / electrical problem ? The tachometer, fuel gauge, over drive, and some other electrical problems have been baffling me for months. Occasionally the check engine...


PCM (power train control module!) my truck did the exact same thing replaced with new one all is good! hope it helps! 1997 Ram 2500 4" skyjacker 35" BFGs

Sep 02, 2010 | 1997 Dodge Ram 3500 Club Cab

1 Answer

2001 dodge 3500 van cam position sensor location


Crank sensor is in the bell housing of the transmission. Cam sensor is in the distributor.

Jul 25, 2010 | 2001 Dodge Ram 3500 Truck

1 Answer

Where is the cam shaft position sensor on a 2001 dodge ram 3500 diesel?


it is in the rear of the timing cover, below the injection pump and above the vacuum pump. hope this helps!!

Mar 23, 2010 | 2001 Dodge Ram 3500 Truck

1 Answer

Where can i find a engine diagram of a dodge 1999 3500 van


Do need you to know where the sensor is located ? If so it's located inside distributor housing, just below rotor on (3.9L-V6 5.2L-V8 5.9-V8) 8.0L-V10 cam sensor is located on the timing chain cover.

Jul 01, 2009 | 1998 Dodge Ram 3500 2WD

1 Answer

Error codes


P0523 means the Oil pressure voltage to high. Your Oil pressure sensor may need to be replaced. P1682 means your charging system is to low. Your voltage regulator may be going bad or the whole alternator. p1693 means a Diagnostic trouble code (DTC) has been detected in the ECM or PCM which is related to the above DTC P0XXX codes. Good luck and hope this helps. Keep me posted, be glad to help

Jun 11, 2009 | 1999 Dodge Ram

1 Answer

I cant find where the trans fluid thermostat goes in my 2001 dodge ram 3500 with a 46re trans and a 5.9 engine


if your vehicle is a diesel truck then removed transmission pan. removed transmission filter as well. you will find wiring going to two solenoids side by side. follow harness to other sensor. single solenoid which is located on governor. there will be a square sensor on side, should be black in color. that is your temp sensor. make sure to replace the governor and sensor together. they can be bought seperately but not advisable to just replace temp sensor. should range in price of $200 for both.

Apr 22, 2009 | 2001 Dodge Ram 3500 Truck

1 Answer

Clutch position sensor on dodge 2500


Jim, I have the same problem. Looking in my Chilton's manual doesn't help much. But, if you look at the firewall from the driver's seat, where the clutch master cylinder rod goes through the firewall, you will see a plastic cylinder around the rod. There should be a wire that goes from that plastic cylinder and connects into a wiring harness. The manual says that if you separate the clutch position sensor wire from the wiring harness, and jumper the two contacts at that connection in the wiring harness, you will bypass the clutch position sensor switch. I have not yet done this but it is the recommended method of debugging starting problems. If you continue to have problems, I can email to you the section of the Chilton's manual for evaluating the starting system. At least I think I can get my computer to copy this section of the manual. The manual does not give the location of the clutch position sensor but that is the only location i can find that meets the description. I have a 1999 Ram 3500 4WD diesel quad cab.

David Wagner davidwagnerpe@comcast.net

Nov 20, 2008 | 1999 Dodge Ram 2500 4WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

241 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...