Question about 2006 Dodge Ram 3500 Truck

Open Question

2006 Dodge 3500 auto 4 speed transmission temp light comes on and turns off overdrive and converter

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 36 Answers

SOURCE: Transmission problems

If you have not had your transmission serviced in the last 30K I would start with that. when the filters start to get restricted it can cause this problem. Be certain who ever does the job is familiar with chrysler transmission as they require atf+ 4 fluid and the clutch bands need to be adjusted to the right spec. It is also possible that the vehicle speed senser is bad this would most likely affect your speedometer as well. there is also the chance that there is an electrical problem bad switch or short in the wiring this is unlikely

Posted on Jan 05, 2009

Ad
  • 3 Answers

SOURCE: 2000 Dodge Sratus 4 speed auto transmission

Dave, The P0700 code is a generic fault code indicating the the TCM (transmission control module) has recognized a problem and the P0755 is the indicated problem. I'd recommend you check your transmission external electrical connector for water intrusion and corrosion at the terminals by disconnecting the connector. If nothing appears wrong, I'd then recommend you drop the lower transmission pan and take a look at the residue deposit that is laying on the bottom of the pan. You should only see a relativily minor amount of grayish, black clutch material residing there. Pay particular attention for a gross amount of this or any large particular material, including any metal, either filings or chunks, or any brass or aluminum. If this checks out to be fairly clean, then I'd recommend you replace that "B" solenoid (2-3 shift solenoid) and have the trans. pan and filter replaced.; I'd also highly recommend you have the trans flushed for anyother particular matter that may reside internally inside the transmission. You'll have to have the codes cleared and the transmission relearned for shift feel, at that point.

Posted on Jan 08, 2009

emissionwiz
  • 76691 Answers

SOURCE: transmission won't shift into 3rd

the trans has a serious failure, that is why the metal, it can be overhauled for less than a replacement

Posted on Mar 30, 2009

  • 245 Answers

SOURCE: I have a 2006 Dodge ram 3500, and my problem is my

usually it is a faulty vehicle speed sensor on these trucks. it is located in the rear axle taking a reading off of the ring gear look for a sensor with two wires in the center of the rear axle this should fix the issue

Posted on Apr 29, 2009

  • 1 Answer

SOURCE: Trouble code P1740 on 1999 Dodge Ram 2500

I had the same code on my 2001 dodge 2500. The truck wouldn't shift from 3-4. I pulled the trans pan off and replaced a broken spring ($2.00). It is behind a thin plate with 3-4 small torq screws. You don't have to remove the valvebody. Only took me 45 minutes to fix.

I would like to give thanks to Jeff Russel from Teal automotive. He said this is a very common problem. He sells any part for any automatic Transmision and his prices are very affordable.
Here is a link to the website.
http://www.tealautomotiveinc.com/

Hope this helps.

Posted on Jul 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 ply. neon wont shift into overdrive


Plymouth transmission wont shift into overdrive Questions ...

www.fixya.com > Forum > Tags > transmission wont shift into overdrive
Plymouth transmission wont shift into overdrive related problems. Ask your Plymouth transmission wont shift into ... My 2000 plymouth neon is stuck in park.

Dodge Neon Questions - my neon will not go into overdrive ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusSep 14, 2012 - my neon will not go into overdrive, it stays at 3500 rpms on highways - my neon does not ... 2003 Dodge Neon won't shift out of park 5 answers.

part2 replace the shift solenoid and speed switches in a ...

? 7:15
https://www.youtube.com/watch?v=2ETvtt8fcr4
Sep 10, 2009 - Uploaded by Sean Conley
Dodge Automatic Transmission Removal - Duration: 11:05. ...Dodge Neon Crushed By Mud Trucks ...

Jan 25, 2016 | Cars & Trucks

1 Answer

The Transmission shifts very hard after the first shift. Check engine light is on as well as the Green overdrive light blinks off and on. Speed sensor was cleaned and even replaced.


Your on the right track. Have you scanned the PCM, what codes did you get? If not and you changed the vehicle speed sensor,(VSS) did you check the (OSS) output shaft speed sensor, it will cause torque converter lock up and hard shifting and that pesky OD light flashing. I have also found that clutch packs inside auto tranny's dry out. Ford and some aftermarket companies sell a fluid that will recondition the clutch packs.

Mar 10, 2015 | 1997 Ford Thunderbird LX

1 Answer

I have a Dodge 3500 Ram with an Automatic 6 speed transmission. I pull a Gooseneck trailer with a GVW of 16k lbs. I have no issues when I am on the road, but when I leave the highway or I'm in heavy...


sounds like you may havea torque converter lockup issue, one way to check is while in slower traffic (15-35mph) gear down your transmission such that you are at a higher rpm (2000-2500) then take your foot all the way off the throttle, if it is in lockup your engine rpm will stay about the same, if not it will go to about idle.

If the tcc doesn't unlock while shifting it will shift very hard and if it slips it will make your temperature increase

Sep 22, 2013 | 1997 Dodge Ram 3500 Club Cab

1 Answer

Trans temp and od light is on what does this mean


Transmission Temperature light only comes on when the transmission has reached the operating limits and tells the temp sender to send a warning. The OD light is the Over Drive light.
There may be several reasons causing the Trans. Temp light to come on. The first would be if the transmission is low on transmission fluid.
Place you vehicle on a level surface. You can check this by letting the vehicle warm up to normal operating temperature, then open the hood and remove the transmission dipstick and wipe it clean with a paper towel or shop rag. Then reinsert it and remove it again, holding it horizontal look at the end of the dipstick. You will see a level mark and a add mark. If it's on the add mark then you need to add transmission fluid. Do not add more then 8 ounces at a time, before rechecking the level.
If the fluid is full, smell the fluid on the dipstick, does it have a burnt smell?
If the fluid has a burnt smell or it's a dark brown color then you will need to change the transmission fluid and filter.
The Overdrive light is on due to high transmission temp or because the Overdrive button has been pushed. ( If equipped with a manual overdrive button)
When the transmission is hot it will turn the overdrive off to increase the speed and pressure of the transmission fluid to help cool the transmission.
So this problem will go hand in hand if you find a problem with the transmission fluid.
You can also take you vehicle to you local auto parts store and have them check the engine codes. There may be another problem causing this issue.


Aug 13, 2010 | 1999 Dodge Durango

1 Answer

94 gmc 4x4 1500 overdrive sometimes works


Check for a transmission speed sensor fault (OBDII scan). Loss of speed sensor signal will result in no torque converter lock up, and no overdrive. Also transmission filter should have been changed at 80,000 miles. Age of your vehicle(1994) warrants the filter service. Transfer case (4WD) needs to be serviced as well.

Jun 04, 2017 | 1994 GMC Sierra

1 Answer

2006 ram transmission


Transmission has gone into "limp" mode. Have it scanned soon.

Oct 16, 2008 | 2006 Dodge Ram 3500 Truck

1 Answer

Error codes


Her is the definition and a list of possiable causes.


Code P1740-Torque converter clutch did not lock up when the PCM sent the command. Enabling conditions: No engine or transmissions codes are present, vehicle speed was under 70 MPH, TPS was under 33% open. When the PCM commanded the torque converter to lock, no change was detected in engine speed. Blocking action: This code can block the following monitors: none.
Testing: Check torque converter solenoid for proper operation.
P1740 TCC O/D SOL PERFORMANCE (GAS)
Theory of Operation
The Torque Converter Clutch (TCC) Solenoid is used to engage the TCC which improves fuel economy.
When Monitored
The Torque Convertor Clutch (TCC) and Overdrive Clutch (OD) will be tested each time the PCM requests TCC engagement in 3rd gear and OD.
Set Condition
The DTC will set if the expected RPM drop is not achieved while attempting to engage TCC or OD. This indicates a malfunctioning torque convertor or overdrive clutch.
Possible Causes
* ENGINE DTCS PRESENT
* TRANSMISSION DTCS PRESENT
* TRANSMISSION TEMPERATURE TOO COLD
* OIL PAN CONTAINS EXCESSIVE DEBRIS
* 3-4 SHIFT SOLENOID
* SHAFT OR SEAL DAMAGE
* TCC SOLENOID
* TORQUE CONVERTER

Sep 25, 2008 | 2005 Dodge Ram 3500

1 Answer

Electrical? no speedometer no overdrive no third gear no wait to start light


check fuse #9 in the fuse box for being blown or lacking power...if there is no power to the fuse it is possible the ignition switch is bad

Aug 20, 2008 | 2006 Dodge Ram 3500 Truck

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

312 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...