Question about Chevrolet Astro

Open Question

Remove engine cover from 1992 astro van - Astro Chevrolet Cars & Trucks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 141 Answers

SOURCE: removing idler arms for a 1989 chevy astro van

are you try to remove the tapered end that connected to the steering linkage ? if you are you will need a pickle fork, some part stores will rent this tool to you good luck kdc744

Posted on Dec 24, 2008

  • 64 Answers

SOURCE: trying to find the fuse diagram for my 1992 chevy astro van

It should be marked on the fuse block

Posted on Mar 29, 2009

  • 521 Answers

SOURCE: how do I replace the tps on my astro van

yes, the cover has to be removed as the tps is attached to the side of the throttle body and is located center to rear of the engine.

Posted on Aug 03, 2009

  • 462 Answers

SOURCE: 2001 astro chevy van 4.3 engines need to set the timing

The distributor in that engine can only be installed in one position. The hold down is built onto the distributor meaning when it is installed and the engine runs the computer is responsible for the timing. The distributor will move a little but won't correct major timing errors.

Posted on Sep 13, 2009

wracefans24
  • 1985 Answers

SOURCE: 1992 CHEVROLET ASTRO van no heat?

Since your blower is working and it is a heat issue,thats where we'll start,First thing is have you checked the coolant level in the radiator when engine is cold,make sure it is filled to top,next verify you have coolant in reserve ,Start your van and get it up to normal operation temperature,If your heat gauge on the dash works correctly it should be 190 degrees,Now lift the hood and locate the two heater hoses going into the heater assembly at the fire wall,Both hoses should be hot to hold on to,if both are hot and no heat inside your problem will be the blend air door in heater assembly.
if neither hose is that hot you need to replace the thermostat in the engine to get it up to 195 degrees.
if one hose is hot and one is luke warm then the heater core is blocked and to blame. hope this helps you.

Posted on Jan 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Removing 1989 astro van engine cover ???


two clips on floor, 15mm, and after you remove the top plastic cover on the doghouse itself, there are two 15mm bolts that go thru the firewall...will need 15mm socket and extension

Jan 15, 2015 | 1989 Chevrolet Astro Cargo

1 Answer

Where is the fuse box located in a 1992 astro van


can you tell me is there a fuse or relay for the PC on a 92 Chevy Astro van

Apr 24, 2012 | 1992 Chevrolet Astro Extended

1 Answer

Where is the idle air control valve located in a 2001 chevy astro van


You'll need to remove the interior engine cover(dog house).Torx screws for the covers, 2 bolts on floor. and bolts against the fire wall (i use a long extension with a swivel socket at the end). The IAC valve is screwed in to the side of the throttle housing (where the gas pedal hooks up to the engine).I can get a pic if you need it.

Dec 30, 2010 | 2001 Chevrolet Astro

2 Answers

Where is the engine coil on a 97 astro van...?


The ignition coil is mounted on the intake manifold near the distributor.
Remove the dog house, or engine cover and it will be on the right side.

Feb 25, 2010 | 1997 Chevrolet Astro

1 Answer

2005 no start astro van how to check if fuel pump is bad.


Open the hood ,remove the air box for the engine but leave the mass air flow sensor on.Get some carb cleaner and spray it in the air intake tube while someone tries to start the van and if it fires and runs on the cleaner it is defanetly a fuel issue and most likely the fuel pump.If you have a fuel pressure gague you can remove the engine cover inside the van and connect to the fuel pressure port to see what u have for fuel pressure which should be between 55-65 psi to run.

Jan 31, 2010 | 2005 Chevrolet Astro

1 Answer

Astro van accelerate by itself


there is a recall i do bleve for you van for that

Nov 16, 2009 | 1994 Chevrolet Astro

1 Answer

How do I replace the tps on my astro van? do i have to remove the engine cover?


yes, the cover has to be removed as the tps is attached to the side of the throttle body and is located center to rear of the engine.

Aug 03, 2009 | 2001 Chevrolet Astro

2 Answers

Will 1988 astro van parts fit on 1992 astro van


Yes, most of the parts will fit but may not be exact depending on the part/and RPO code.

For example, you could have a different gear ratio in the rear end, this would physically fit, but might not work for your purpose.

Oct 13, 2008 | 1988 Chevrolet Astro Cargo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...