Question about 2002 Jeep Grand Cherokee

Open Question

Broken 2002 Jeep Grand Cherokee glove compartment door latch

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 82 Answers

SOURCE: glove box latch broken

The latch is sold seperately. Call your local dealer with the last 9 of you vin number to get the right color. Most dealers sell at the same MSRP price as all the others in town. I know cause I sell these all the time at my Chrysler dealership.

Posted on Jan 08, 2009

Ad
  • 1 Answer

SOURCE: 2002 jeep cherokee laredo

My 98 Jeep Grand Cherokee had the same problem. Over heated when standing still. Took it to dealer and they could not find any problem with cooling fan. After doing my own investigation I found out that the electric cooling fan would begin to seize up after about 1hr. of operating. (gets hot)

The dealer would look at fan and see that it was running and think its ok. The problem is, it wasn't running fast enough.

I have a relay on the right side of front fender and jumped the fan to stay on with motor off. (must know what your doing). After about 1hr. fan started slowing way down. Returned it to dealer told them what the problem was. They were not smart enough to jump the relay so they put a couple hundred miles on it even though i told them it works OK when moving. Make sure you tell dealer to use the relay to jump.
Replace cooling fan motor. Works great

Posted on Feb 27, 2009

  • 114 Answers

SOURCE: 2002 wj jeep grand cherokee p1756

The governor pressure sensor is the most likley cause however an inspection of fluid or debris in trans pan would be a good idea to make sure there's nothing excessive in it. Attached is a list of possible causes however the senor would be the most common.

POSSIBLE CAUSES

  • Powertrain control module
  • 5 volt supply circuit open
  • Check transmission fluid level and condition
  • GOV press sensor signal circuit shorted to voltage
  • GOV press sensor signal circuit shorted to sensor ground
  • GOV press sensor signal circuit shorted to ground
  • GOV pressure sensor signal circuit open
  • Sensor ground circuit open
  • GOV press sensor signal circuit shorted to voltage inside transmission
  • 5 volt supply circuit open inside transmission
  • Intermittent governor pressure solenoid
  • Internal transmission problem
  • Oil burnt or oil pan has excessive debris
  • Other transmission DTC'S
  • GOV press sensor signal circuit shorted to sensor ground inside transmission
  • Valve body
  • GOV press sensor signal circuit shorted to ground inside transmission
  • GOV press sensor signal circuit open inside transmission
  • GOV press sensor ground circuit open inside transmission
  • Governor pressure sensor (high)

Posted on Mar 26, 2009

  • 412 Answers

SOURCE: How do you program a 2002 Jeep Grand Cherokee FOB?

if you have an original working fob and your owner's manual,it will explain procedure,otherwise will have to go to dealer to be programmed

Posted on May 17, 2009

  • 12 Answers

SOURCE: overhead console completely dead 2002 jeep grand cherokee laradeo

Check the fuses for the overhead console, could be that if not then the console needs to be replaced.....

Posted on Jun 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How much air should I put in the tires


Look on the door pillar of the drivers door. There should be a chart there. Also in the manual in the glove compartment.

Dec 04, 2015 | 2002 Jeep Grand Cherokee

1 Answer

DAsh wont close


DAsh? can we have a lil hint as to what?
do you mean, glove box?
if yes, then empty it, close now?
yes, solved
no, broken latch.

Aug 09, 2013 | 2002 Jeep Grand Cherokee

2 Answers

Where is the fuse box located in a 1993 Jeep Cherokee?


one is under driver side of dash, the other is behind the battery, and the relay center is in the glove compartment under the bottom panel.

Apr 14, 2011 | 1993 Jeep Grand Cherokee

1 Answer

How do I disconnect the security system? My truck won't disengage & I can't start it.


The security module is located in the dash behind the glove compartment. You cannot disconnect the security module without bypassing the starter wire. The system disarms by unlocking the front doors or tailgate with the key or using the remote key fob. The switches on the door latches are notorious for going bad on the grand cherokees. These switches are inside the doors attached to the lock cylinders and cost about 40 bucks at the chrysler dealership. You can also get a replacement remote fob on ebay but they are around 50 bucks and you will need the owners manual for the Jeep to program it.

Oct 02, 2010 | 1994 Jeep Grand Cherokee

1 Answer

Broken door latch


Yes, it would involve removing the door panel, disconnecting the actuator rods connected to the latch and unbolting the latch from the door.

Mar 09, 2010 | 1996 Jeep Grand Cherokee

1 Answer

2002 Grand Cherokee power windows none work at


check for a broken black wire in the drivers door wiring harness between the body and door.

Jan 08, 2010 | 2002 Jeep Grand Cherokee

1 Answer

I have a 98 jeep grand cherokee, and my driver side door lock is in the lock position and I can not shut my door. How do I release the lock?


Have you tried unlocking it with the key? If that does not work, try moving the latch with a scredriver, back into the open position. If the latch has broken internally you will need to remove the inner door panel and remove the latch assembly for visual inspection and replacement. You can get another latch at just about any scrapyard and key will not need to be changed to do this.

Oct 21, 2009 | 1998 Jeep Grand Cherokee

2 Answers

2001 jeep grand cherokee code 56???


hi
your blend doors are damaged or broken, go to heatertreater.net they have a quick fix blend door repair kit that you can install yourself in around half an hour, this really works as i have fitted a few myself. jeep will quote you around £800 to fix.
hope this helps

Sep 03, 2009 | 2001 Jeep Grand Cherokee

1 Answer

Glove box latch broken


The latch is sold seperately. Call your local dealer with the last 9 of you vin number to get the right color. Most dealers sell at the same MSRP price as all the others in town. I know cause I sell these all the time at my Chrysler dealership.

Jan 08, 2009 | 2002 Jeep Grand Cherokee

Not finding what you are looking for?
2002 Jeep Grand Cherokee Logo

Related Topics:

405 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...