Question about 2005 Dodge Magnum

Open Question

2005 Dodge Magnum RT -front of sunroof will not fully close-not flush with metal roof. Doesn't leak yet. Sunroof used to come flush with metal roof.I closed it once with something left in the track & it came out of adjustment. tonyjos39@hotmail.com

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: tiburon sunroof problem

Hi guys you have to re-program the computer function that controls the sun roof. Turn the ignition to off. Hold down both buttons that open the sunroof simultaneously and switch the ignition to on. Continue holding the buttons to open for about 10 seconds, or until you here a click, or until the sunroof opens. This should fix the problem, and remember the solution because it will happen again.

Posted on Dec 07, 2008

SOURCE: Renault Clio sport R Reg - leaking manual sunroof

I had the same problem with a 51reg clio expression.
Only way to fix it was to remove the sun roof from the car, clean all the old sealant from the rim, apply new windscreen/sunroof type silicone to the sunroof rim and re-fix.

If you remove the inner trim of the sunroof you can access the 10mm bolts which clamp it to the roof.

Posted on Oct 26, 2008

  • 14 Answers

SOURCE: 1992 Volvo 940 Gl Sunroof Problem

to find out if it is off its track you can remove the cover between the rearview and the sunroof that is the motor/drive assembly. there is a slotted pin in this assemply that you turn with a screwdriver to move the sunroof manually if it wont move manually then you have a bigger issue. sometimes thie drive assembly screws get loose, i believe there are two screws that hold it up,when those are loose you will get a grinding sound when the gears skip. good luck.

Posted on Mar 21, 2009

polarcycle
  • 1392 Answers

SOURCE: sunroof will not close

If the motor is stuck, you can probably hold the switch to the forward position, and smack the roof. This may allow the motor to start working. I don't think there is any way to do it manually.

Posted on Jun 15, 2009

  • 3 Answers

SOURCE: Camry sunroof stuck

Probably bad switch.

Posted on Jun 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

'06 Chrysler Pacifica w/sunroof: When it rains water is leaking out of the front door frame covers and sun visor screws. (Sun roof is closed.)


hi i'm not familar with your car but if you can wind the sunroof back so the sunroof is fully open look at all four corners where the sunroof sits into there should be at least 2 drain holes which can over time become clogged with debris, if you find them use some warm water and flexi pipe to clean the drain holes out. hope this helps

Oct 09, 2016 | 2006 Chrysler Pacifica

2 Answers

How to install replacement sunroof motor on a 1999 Pontiac grand prix


Important: This sunroof system is timed from the factory in order to allow the actuator to shut off automatically when the sunroof window reaches a certain position. Use extreme care when removing the actuator from the sunroof module. This may cause the timing to be thrown off. This may damage to the sunroof. Anytime the actuator needs to be removed from the module, ensure that the sunroof window is in the fully closed position.
Remove the sunroof window. Refer to Sunroof Glass Panel Replacement .
Slide the sunshade fully rearward. Move the sunroof window to the vent position. Remove the sunroof screws (two on each side). Remove the sunroof window from the module.
Place the sunroof module in the fully closed position. Remove the headliner. Refer to Headlining Trim Panel Replacement in Interior trim.
Tools Required ?€¢
J 38778 Door Trim Pad and Garnish Clip Remover


?€¢
J 2772-C Headliner Installer

  1. Remove the sunshades. Refer to Sunshade Replacement .
  2. Remove the overhead console, if equipped. Refer to Roof Console Replacement .
  3. Remove the sunshade retainers. Refer to Sunshade Anchor Replacement .
  4. Remove the power sunroof switch, if equipped. Refer to Sunroof Switch Replacement in Roof.
  5. Remove the sunroof trim lace, if equipped. Refer to Sunroof Seal/Molding Replacement in Roof.
  6. Remove the dome light, if equipped.
  7. Remove the coat hooks. Refer to Coat Hook Replacement .
  8. Remove the assist handles. Assist Strap Replacement
  9. Remove the rail lamp. Refer to Roof Side Rail Lamp Replacement in Lighting.
  10. Remove the windshield side garnish molding. Refer to Windshield Pillar Garnish Molding Replacement .
  11. Remove the upper quarter trim panels. Refer to Rear Quarter Upper Trim Panel Replacement .
  12. Remove the center pillar upper trim panel. Refer to Center Pillar Upper Trim Panel Replacement .
  13. Pull down on the door opening weatherstrip seal on both the front and the rear doors.
  14. Remove the 2 rear retainers (2) using J 38778 Door Trim Pad and Garnish Clip Remover. Disconnect the headliner electric harness at the right side of the rear window shelf. Rotate the right front seatback to a horizontal position. Remove the headliner from the vehicle through the right front door.
Disconnect the electrical connector from the actuator.
Important: Before removing the actuator, ensure that the pins J 41718 are tight and holding the cable.
Thread the J 41718 into the front sunroof window screw hole in order to retain the cable adjustment. Remove the sunroof actuator screws. Remove the sunroof actuator from the module. Did you look for a video on youtube ?

Feb 27, 2015 | 1999 Pontiac Grand Prix

1 Answer

Why does my 2006 RT Charger with sunroof leak from the overhead light near the windshield? The sunroof remains dry


check to see if the drain hose is blocked,there's one on each side front corner of sunroof that go down through roof supports,along each side of windshield

Feb 10, 2013 | Dodge Charger Cars & Trucks

1 Answer

I have Mercedes SL500 2003. The hardtop in my car seems not fully closed, I can see that it is around 2 mm away from front seal. In addition, I can hear air leaking inside the car during driving. I heard...


  1. Move the sunshade rearward to the open position.
  2. Separate the mechanism covers (2) from the tabs (1) on the glass panel.

    813ada50.gif
  3. Verify the sunroof glass panel is in the fully closed position.
  4. Loosen the forward attaching screws (2) on each side enough to permit the front of the glass to adjust up or down.
  5. Adjust the front surface of the sunroof glass panel 0.00 mm to 2 mm (0.00 in. to 0.08 in.) below the top surface of the roof.
  6. Tighten the front glass panel attaching screws to 5.5 N•m (49 in. lbs.).
  7. Loosen the rear screws (2) on each side enough to make the rear adjustment.
  8. Adjust the rear surface of the sunroof glass panel 0.00 mm to 2 mm (0.00 in. to 0.08 in.) above the top surface of the roof.
  9. Tighten the rear glass panel attaching screws to 5.5 N•m (49 in. lbs.).
  10. Check for proper fit. If not OK, repeat glass panel adjustment.

    813bc829.gif
  11. Position the mechanism covers (2) over the glass tabs (1) between the locating features and seat fully.
  12. Verify sunroof operation and alignment.
There is a reprogramming from chrysler for the sunroof for recalibrating the sunroof for flushness also. the dealer will charge for this .You might want to do this first and then the adjust if not satisfied with the results.

Sep 10, 2012 | 2003 Mercedes-Benz SL-Class

1 Answer

Need to replace sunroof..


you need to replace glass or is it leaking if leaking then you have to remove upper seat belt covers pop off remove bolt 14mm and the trims on upper pillars pry off carefully held in by clips remove covers on interior light at front where sunroof switches are there are screws by bulbs disconnect connector remove center light cover and screws disconnect connector with clean hands remove rbber trim around sunroof opening and plastic cover on each side of sunroof glass held on with plastic screw clips then remove four 10mm nuts lift sunroof glass out of car remove cover and screws from rearview mirror all plastic trims around headliner move pass seat forward most and flip back rest all way down roll pass window fully down then slide headliner out of car now you can remove electrical connectors and remove water flow hoses from sunroof unit remove 8 12mm nuts holding frame to roof remove through door you will see the track sunroof slides on remove nuts along problem is silicone between track and frame is deteriorated lift track clean replace silicone reattach frame to roof dont put trims or liner in till test connect switches and glass to frame make sure sunroof works and closes fully then go through car wash to see if leak is fixed

Jan 13, 2011 | 2001 Subaru Legacy

2 Answers

Repair leaking sunroof / 2005 Chrysler 300c


my chrysler 300 2005 has a leaking sunroof, how much to repair??

May 13, 2010 | 2005 Chrysler 300

1 Answer

07 Equinox Leaking water at the front corners of the sun roof. usually during heavy rain, but also when going thru the car wash and the blowers come on to dry the water off.


check the adjustment of your sunroof, i work at a dealer and i just had a 2006 equinox in with the same exact problem, if you look at where the glass attaches to the sunroof rails you will see 2 torx screws on each side, with the sunroof closed, loosen the screws a little bit, don't remove them, push the glass up untill its level with the roof and the seal around the glass looks even all the way around where it contacts the roof sheet metal, then tighten down the screws while holding the glass in place. if it continues to leak, remove the sun visors and the clips for the sun visors, i believe they are either philips scres or torx, there will be 2 screws on the visor itself, and 1 for the clip. then remove the front pillar trim panel, you will see a small cover in the upper panel, use a pick or a sharp thin tool to pry the cover off and remove the 7mm screw in there, pull the door weatherstrip off and pull the trim panel off, after you do that gently pull the headliner down in the front corner and peek up at the sunroof frame, make sure the drain ose is still connected, the procedure is the same for both left and right sides. this should definitely clear up your problem!

Jun 28, 2009 | 2005 Chevrolet Equinox

1 Answer

Sunroof will not close


If the motor is stuck, you can probably hold the switch to the forward position, and smack the roof. This may allow the motor to start working. I don't think there is any way to do it manually.

Jun 15, 2009 | 2005 Dodge Neon

1 Answer

How do i manually close a sunroof for a mitusbishi montero after the sunroof motor fails?


Depending on the year of your vehicle....
Earlier models had a sunroof wrench. The manual states that ..."the electronic sunroof system cannot be operated manually. The sunroof wrench that was used in previous models is not provided".

Now that may mean that if you had the wrench it could be operated manually.

I did find something else here :
NOTE: If there is a problem with the sunroof motor so that the
roof lid glass cannot close fully, use an Allen wrench to turn the
gear section of the sunroof motor to fully close the roof lid
glass.

Access seems to be just above the sunroof switch.

Jun 04, 2009 | 2001 Mitsubishi Eclipse

1 Answer

Moonroof Problems


Heres the adjustment procedure.
ADJUSTMENT
813bc829.gif
  1. Move the sunshade rearward to the open position.
  2. Separate the mechanism covers (2) from the tabs (1) on the glass panel.

    813ada50.gif
  3. Verify the sunroof glass panel is in the fully closed position.
  4. Loosen the forward attaching screws (2) on each side enough to permit the front of the glass to adjust up or down.
  5. Adjust the front surface of the sunroof glass panel 0.00 mm to 2 mm (0.00 in. to 0.08 in.) below the top surface of the roof.
  6. Tighten the front glass panel attaching screws to 5.5 N·m (49 in. lbs.).
  7. Loosen the rear screws (2) on each side enough to make the rear adjustment.
  8. Adjust the rear surface of the sunroof glass panel 0.00 mm to 2 mm (0.00 in. to 0.08 in.) above the top surface of the roof.
  9. Tighten the rear glass panel attaching screws to 5.5 N·m (49 in. lbs.).
  10. Check for proper fit. If not OK, repeat glass panel adjustment.

    813bc829.gif
  11. Position the mechanism covers (2) over the glass tabs (1) between the locating features and seat fully.
  12. Verify sunroof operation and alignment.
There is a reprogramming from chrysler for the sunroof for recalibrating the sunroof for flushness also. the dealer will charge for this .You might want to do this first and then the adjust if not satisfied with the results.

Mar 18, 2009 | 2005 Chrysler 300

Not finding what you are looking for?
2005 Dodge Magnum Logo

Related Topics:

446 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...