Question about 2006 Ford Escape

1 Answer

How do i let the spare tire down on my 2006 ford escape?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 8,197 Answers

On the link below page 213 and 214 will tell you how to get the spair tire down.

http://www.motorcraftservice.com/pubs/content/~WO6204/~MUS~LEN/34/06204og3e.pdf

Good Luck and please rate 4 thumbs up for the free answer

Posted on Sep 07, 2010

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 74 Answers

SOURCE: Ford F250 Spare Tire Removal

there is a hole in the bumper or when you let the tail gate down there should be a hole. there should be some rods with the factory jack to allow you to let the tire down

Posted on Jun 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tires keep losing air - 1006 Ford Escape


Tires --one tire?

Have a tire store resolve that

Jan 31, 2013 | 2006 Ford Escape

1 Answer

Ford Escape 2006 lug nuts are off but the tire won't budge


Aluminum wheels, huh? VERY common problem. I use a VERY LARGE rubber mallot at the shop to "beat" the wheels of when they are corroded into place like that. If you have the vehicle on a jack-stand, you can also start one of the wheel nuts onto the stud a few turns just to keep the tire from flying off and hurting somebody....then sit down on the ground and KICK HARD to break the wheel loose from the hub. Just make sure the vehicle is properly supported so it does not come crashing down.

If you can manage to get the thing loose, It will help in the future if you sand the inside of the wheel center hole a little and coat it with anti-seize compound before reinstalling it on the vehicle.

May 19, 2012 | 2006 Ford Escape

1 Answer

2006 escape front end bounceing and vibrating


It can only be one of two things, tires out of balance or a blown strut. rotate tires and verify that the tires are not the cause, if still have vibration replace struts.

Feb 22, 2012 | 2006 Ford Escape

2 Answers

Where is the fuel shut off reset on a 2002 ford escape


It's located in the spare tire compartment in the rear of the vechicle on the passenger side under the foam liner.

May 28, 2010 | 2002 Ford Escape

1 Answer

Replacement tires


Goodyear edges are nice ( and expensive) But boy are they good

Aug 13, 2009 | 2006 Ford Escape

1 Answer

I have a 2004 Ford f250 and I don't have the spare tire key. Where can I get a new one? I've gone to Ford dealers and they told me that they can't get it. I can't get my spare tire down.


If you can gain access to the plastic tube where the spare tire rod slides through to lower the tire. I would remove the tube so you can get to the lock. I would just pop the lock out and leave it out.Good luck,I hope this helps.

Jul 08, 2009 | 2006 Ford F-250 Super Duty

1 Answer

Low tire pressure indicator ligt on


this is covered by warranty if it is not just a low pressure concern. Did you chek your owner manual to see if you need to reset? Did you check the spare?

Mar 10, 2009 | 2007 Ford Escape Hybrid FWD

2 Answers

Ford F250 Spare Tire Removal


Hi there!

The only trick I know is to coat the bolts with coppergrease - and check yearly.

They get the worst of the road spray, then sieze.

Sometimes bolt croppers are the only way - then replace the mountings.

Try penetrating oil for several days ( I presume you're home now), and apply a self-grip wrench while using a good socket set on the other. If it snaps - job done, get a replacement.

Bad design.

Paint your spare steel rim with a rustproofing sealant - or it will soon rust around the tyre - causing a flat as well.

I hope this solves your problems - now and in the future. If it does, Please rate as Fixya, Thank you.

Jun 18, 2008 | 2006 Ford F-250 Super Duty

Not finding what you are looking for?
2006 Ford Escape Logo

Related Topics:

1,003 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...