Question about 2007 Ford Focus (3 Door) Hatchback

1 Answer

My key got stuck in the ignition... it turns the car on and everything works fine but the key just doesnt come out!! i dont want to mess with it too much because i dont want to break the key.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 7,353 Answers

You need a new "Ignition Lock Cylinder" I think a locksmith can help you , or the dealer.

Posted on Sep 07, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Key wont turn

The tumblers are probably stuck or messed up you can look at the key for damage or spray a little wd40 in the cylinder if that dont work its a faulty ignition switch

Mar 27, 2014 | 2013 Kia Soul

2 Answers

2003 range rover ignition key off power still key stuck in position 1

some of these electric interlocks require the brake pedal stepped on for releasing..have you tried that? along with shifting fully into park a few times?

Jan 26, 2014 | Cars & Trucks

1 Answer

I have a 2002 sunfire... and i have trouble turning it on. Once it startes it is stuck there because it will not turn at all. Once it is in this position the wipes wont work, the windows wont roll down,...

sounds like you need a new ignition, reason nothing works cause once it doese turn over n starts the car the tumbler is stick in the starting position jus not far enough to keep the starter engaged but far enough the it still trying to go trough the start process which cuts the power to everything else till the ignition returns to the on postion

did you try jus turning the ignition far enough to when the starter engages jus let go of it so the car doesnt start and see if everything else still doesnt work if it dont i belive its the igniton

also with out starting it or engaging the starter as in just turning the key on to get power does anything work?

Jul 12, 2012 | 2002 Pontiac Sunfire

1 Answer

Key locked in ingetion and unable to get it out also wipers and cruse control dont work have to unhook the battery to get it to stop when i hook the batery up again the car will automatily start

sounds like key cylinder getting stuck.happens after a lot of rabbit inside the cylinder(chambers) tend to stick out and keep the key stuck in and doesnt release.also mechanic inside cylinder might be worn down or broken causing the key not to turn back all the way on ignition rod or switch.sollution replace key cylinder should fix you problem.but if it doesnt shut of prob is also the ignition switch.located connected on steering colum lower right side.hope that helps.let me know how it goes.

Aug 15, 2010 | 2004 Chevrolet TrailBlazer

1 Answer

Car was running fine stopped the engine and now it turns over and will not start has gas and turns over but will not start

if you have a chip in your key you may what to have the ignition lock checked,there are contacts in the ignition that read the chip, sometimes they get stuck and dont pop out and read the key, this in turn doesnt turn on the fuelpump,look inside switch with a light and use a small pic, push on each sensor and it should pop back out if not try spraying a little wd40 on it and work it free by push it gentle until it pops out there are two sensors you will see them at the begining on the key hole.

Jun 11, 2010 | 1990 Oldsmobile Cutlass Ciera

1 Answer

2001 chevy malibu wont start

Is your theft light flashing. If it is try this. I learned this from emission wiz Put your key in turn it on dont start wait 10 mins remove key wait 10 seconds repeat this a total of 3 times. If that dont work try a different key do the same thing. This relearns your key to the ignition it started with Gm cars and trucks from 1999 to to 2006. It is a big problem but there is no recall that I know of. If that dont work a dealer needs to probably replace and reprogram your ignition switch and keys

Apr 12, 2009 | 2001 Chevrolet Malibu

1 Answer

Ignition key turns on but car will not start

I suspect the ignition switch is malfunctioning.

Nov 19, 2008 | 2000 Ford Focus

Not finding what you are looking for?
2007 Ford Focus (3 Door) Hatchback Logo

Related Topics:

216 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers


Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides