Question about 2006 Dodge Ram 2500

1 Answer

I have a '06 Dodge 5.9 cummins. I have replaced everything on the system (compressor, dryer, etc.) the expansion line is freezing up. i replaced twice thinking it was stopped up since it only freezes from behind the expansion tube back to dryer

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert that has over 500 points.


    An expert whose answer got voted for 20 times.

  • Expert
  • 182 Answers

Did you change the orface tube

Posted on Sep 07, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

So I can just replace ac compressor an bypass heater core an ac should work for 1991 Lincoln Town car

If the compressor is the problem A/C should work. But I work with idiots. I replace the compressor, expansion valve and dryer. And clean the system out. They replaced the compressor. then the expansion valve. then did it again after they clean the lines out, Then again, because the dryer held to much metal from the compressor going bad. And yes, you can bypass the heater core. But if the blend door actuator is bad, it won't be cold.

Jun 25, 2016 | 1991 Lincoln Town Car

1 Answer

Just bought. 5.9 cummins Can`t get it to start without pushing gas pedal slightly. Runs good after warms up. Still have to give it fuel to start.

Numerous Conditions May Cause Engine to Crank But Not ... > Problems > Dodge > Ram 2500
2006 Dodge Ram Laramie 2500, 5.9i liter Cummins ... I know in the old days the dodges had a way about starting up an engine and that would be where.

White smoke, rough idle at startup - Dodge Cummins Diesel Forum > ... > 3rd Gen. Powertrain
Jun 5, 2010 - 9 posts - ‎7 authors I have an 06 Dodge 5.9L that has a light white smoke and rough idle when first ... 2006Ram 2500 QCSB 4x4, 3" Carli coils w/ 1" Daystar spacer, ... Still ran good tho, dispite the exact conditions you describe on Cold Start up.

Oct 20, 2015 | 1995 Dodge Ram 3500

1 Answer

Compression hose on my 1993 chevy blazer k1500 is leaking how do i replace it and what tools do i need

AC compressor hose? If yes, confirm system is empty before disconnecting from the compressor and the next piece(dryer/expansion valve/etc). When installing new hose(s) , replace associated o-rings and the dryer too. Pull vacuum after everything is buttoned up. Then add few ounces of pag oil and they factory oz's of 134a.

Oct 25, 2013 | 1999 Chevrolet Silverado 1500

1 Answer

Trying to find expansion device on 06 dodge megacab diesel

If you are referring to orifice tube,(takes the place of the expansion valve for the air conditioner) then it is made in the liquid line,and the whole liquid line would have to be replaced.

Oct 05, 2013 | Dodge Cars & Trucks

1 Answer

1999 dodge ram 2500 cummins hard to steer when gets hot

It can be the issue with pressure in power steering.Get the pressure checked at power steering hose.
This will confirm the issue.-:---
Click the link below for troubleshooting:---
This will help.

Jun 25, 2012 | Dodge Ram 2500 Cars & Trucks

1 Answer

My air conditioner does not work on my 06 dodge 2500 5.9 l diesel. The blower motor works fine but the compressor does not engage. I've checked pressures and shows to be charged. What eles could it be?

The factory harness is known to have a voltage drop at the clutch which slips the clutch causing heat and melts the clutch coil and burns the oil out of the berrings, your next problem is going to be a siezed idler berring now the pump turns allways while the engine is running, over pressurizes pops something (mine was the evap core, under the dash), then the pump berring goes out spitting metal trash through your whole system. It all in all is a very expensive problem, replace your compressor "now" with an updated version clutch, and replace your harness to the compressor, before this $2500 problem happens to your truck then call dodge and complain! I am on my second compressor at 70k on my 2006 cummins, my compressor supplier said he sells 200 of these a month! Gee do you think its a manufacturers error???

Jul 08, 2011 | 2006 Dodge Ram 2500

2 Answers

Took my 2001 dodge grand caravan in to have compressor replaced, it was going out. Ac worked great before it went in, now they have replaced the compressor, dehydrator,expasion valve etc. Now it blows hot...

Check your A/C heater controls at the dash, it is not controlling the opening and closing of doors inside your dash, it might need to be replaced or some rods or levers got accidently disconnected when they were installing the Expansion Valve. The shop that repaired your A/C is responsible for making sure everything is working properly.

Jun 16, 2010 | 2001 Dodge Grand Caravan

2 Answers

A/C not working on my 06 Dodge Ram 2500. How do I

I have a 2006 Dodge Ram sometime the ac blowes hot and sometimes it freeze out of the cab please help me

Jul 24, 2009 | 2006 Dodge Ram 2500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

194 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides