Question about 2005 Hummer H2

1 Answer

Engine light still on after oil change - 2005 Hummer H2

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 182 Answers

Turn key on and pump the gas pedal 3 times and then it should reset

Posted on Sep 06, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oil light comes erratically on 92 accord


my guess is one of three things:

1. clogged inlet or worn out oil pump gears: change oil pump
2. Engine is tired and has leaky loose bearings and journals, hemorrhaging oil out all internally bleeding places. Engine flush unclogged the varnish that was holding oil pressure up. Rebuild engine or change when current engine blows.
3. Bad oil pressure sensor causing strange readings. Diagnose actual oil pressure and change sensor if needed.

These vintage honda engines are everywhere for cheap at junkyards. i wouldnt pay more than 350 for one.

Feb 17, 2015 | 1992 Honda Accord

2 Answers

How to do I reset the maintenance service light on my 2007 Chevy Trail Blazer


there is no light for emissions testing on this vehicle. there is a ses light that can come on, indicationg a problem with the engine or transmission electronic system. this will require a scan tool to pull trouble codes. there is another light called oil life monitoring that needs to be reset after oil changes, which I suspect is what you are seeing. here is a picture of the light and the instructions for resetting.,

The Engine Oil Life System calculates when to change your engine oil and filter based on vehicle use. Anytime your oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where you change your oil prior to a CHANGE OIL SOON message being turned on, reset the system.
After changing the engine oil, the system must be reset as follows:
  1. Turn the ignition to RUN, with the engine OFF.
  2. Press the information and reset buttons on the Driver Information Center (DIC) at the same time to enter the personalization menu.
  3. Press the information button to scroll through the available personalization menu modes until the DIC display shows OIL LIFE RESET.
  4. Press and hold the reset button until the DIC display shows ACKNOWLEDGED. This will tell you the system has been reset.
  5. Turn the key to LOCK.
If the CHANGE ENGINE OIL message comes back on when you start the vehicle, the Engine Oil Life System has not reset. Repeat the reset procedure.



485d3b2.gif

Sep 09, 2010 | 2007 Chevrolet TrailBlazer SS

2 Answers

Reset change oil light


hello, here is the instructions on how to reset the light

When the system has calculated that oil life has been diminished, it will indicate that an oil change is necessary. A CHANGE ENGINE OIL SOON message will come on. Change the engine oil as soon as possible within the next 600 miles (1000 km). It is possible that, if driving under the best conditions, the oil life may not indicate that an oil change is necessary for over a year. However, the engine oil and filter must be changed at least once a year and at this time the system must be reset.
If the system is ever reset accidentally, change the engine oil at 3000 miles (5000 km) since last oil change.
To reset the Engine Oil Life System, do the following:
  1. Turn the ignition to ON, with the engine off.
  2. Slowly fully press and release the accelerator pedal 3 times within 5 seconds.
  3. The reset is complete when the chimes sound and the CHANGE OIL lamp goes out. If the lamp stays on and no chime is heard, repeat the reset procedure.
  4. Turn the key to OFF.
If the CHANGE OIL lamp comes back on when the vehicle is started, the engine oil life system has not reset. Repeat the procedure.

Jun 20, 2010 | 2001 Pontiac Grand Am SE

2 Answers

Oil maintenece light is on. Oil level is good. Could a clogged filter make this light go on?


This should only be indicating time for an oil change. Now, if the red, check engine light comes on, then you have an oil/engine problem.

Possibly the maintenance light wasn't reset when the last change was done. If you don't have the owners manual to check, I found a referenced method (below) to reset it through AMSOIL synthetic oil products. Good Luck

To reset Engine Oil light. Turn the ignition key to RUN with the engine off. Fully press and release the accelerator pedal three times within five seconds. If the Change Engine Oil light is flashing, the system is reset. The light will flash for up to 30 seconds or until the ignition is turned off. If the light comes on again and stays on for 30 seconds at the next ignition cycle, it did not reset. You will need to reset the system again.

Feb 09, 2010 | Saturn L-Series Cars & Trucks

2 Answers

How do i reset my oil light? my husband changed


TURN THE IGNITION KEY TO RUN WITH THE ENGINE OFF.FULLY PRESS AND RELEASE THE ACCELERATOR PEDAL THREE TIMES WITH IN FIVE SECONDS.YOU HAVE TO DO THIS MORE THAN ONE TIME.ITS NOT GOING TO RESET FIRST TRY BUT DO THIS PROCEDURE.UNTIL THE CHANGE ENGINE OIL LIGHT WILL FLASH WHILE THE SYSTEM IS RESETTING.TURN THE KEY TO OFF.WAIT A FEW SECONDS.START CAR UP TO SEE IF CHANGE OIL LIGHT COME BACK ON.IF YES YOU HAVE TO TRY THE RESET PROCEDURE AGAIN.

Sep 26, 2009 | 2006 Chevrolet Equinox

2 Answers

OIL PRESSURE LIGHT ON AFTER OIL SERVICE


Sorry if these questions might seem dumb........but with out being there........
Do you have actual oil pressure?
Was the correct filter used?
Is there oil in the engine?
Is it the oil pressure indicator or possibly the change oil indicator that is on?

Is the engine running quietly....as if it has oil pressure?
If the engine is running after the oil change.........you might have oil pressure even though the light inside is on.........because the fuel pump usually needs to see oil pressure to continue to pump fuel.

Aug 31, 2009 | 2001 Oldsmobile Silhouette

3 Answers

Change oil light came on


In your owners manual there is a procedure listed for resetting thr oil change reminder/maintenance light. Some vehicles you turn key on..do not start it.. step on gas pedal all the way to the floor 3 times... then key off. others haver u hold the trip odometer reset button when u turn key on.
It varies from manufacture to manufacturer.

Jul 10, 2009 | 2006 Isuzu Ascender

2 Answers

How it reset service engine light


Is it the "oil change req." light? Your owners manual will have the process for reseting the oil change light.
If it is "service engine soon" light, the vehicle will need to be scanned with a professional scanner.

Jun 20, 2009 | 1996 Dodge Caravan

1 Answer

I have a 1992 toyota camry LE, 4 cyl. and the oil indicator light keeps flickering on and off, what is the problem. I have checked the transmission and the oil levels and they are all okay. Confused as to...


Is it an oil pressure light or an oil change light (check the owners manual) If its an oil change light it may be time to change the oil. If its an oil pressure light you could have a short to ground in the wiring or at the oil pressure sender mounted on the engine. Also are you checking the engine oil with the engine running or off. The transmission is checked with the engine running, engine oil with engine off. If it is low on oil it will intermittently flash. Also when you check the oil wait five to ten minutes after the engine stops to let the oil settle before checking or you may get false readings.

Apr 02, 2009 | 1992 Toyota Camry V6

1 Answer

Oil light comes on and beeps


Changing oil can't hurt. When was the last time you had it changes?How many miles on that engine?Changing approximately ever 3,000 miles is common practice. The engine oil light and the automatic transmission are two seperate problems.     Engine oil light come on because the sensor reads a low oil preasure.If the engine is not worn then the light can be caused by the sensor getting cloged up (from dirty oil ) and not reading the preasure correctly.  

Jan 04, 2009 | 1996 Volkswagen Jetta

Not finding what you are looking for?
2005 Hummer H2 Logo

Related Topics:

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hummer Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Hummer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...