Question about 2006 Ford F-150

1 Answer

I have 2006 f-150 4x4 4.6l. I have a bad batterie and replaced with new. After putting in truck still won't turn over. I can here iginition but nothing from starter no noise at all. Could it be the starter soliniod or something else. If it is soliniod where can I locate it? Thank you George

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 984 Answers

The starter motor relay is in the fuse panel in the passenger side kick panel.

Try turning the key to the run position, press and hold the brake, and shift into Neutral, and try to start. This will test if the DTR ( Digital Trans Range ) sensor is having an issue in the park position

Posted on Sep 11, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

By pass passlock on 97 chevy blazer

Check this site out!

Dec 14, 2014 | 1997 Chevrolet Blazer

1 Answer

Ford Ka starter motor won't start but makes whirring sound. It usually takes 3 turns of the iginition to start

Sounds like the solenoid is bad on the starter..Starter probably needs replacing.

Feb 23, 2013 | Cars & Trucks

1 Answer

Have 87 jeep comanche, have been told it has a cam shaft sensor, to keep it in time , if so where is it located? the engine is a 4.0

The cam sensor is located in the distributor.check the cylinder compression, check for ignition spark, check for fuel injector pulse and fuel pressure.

Aug 06, 2012 | 1987 Jeep Comanche

1 Answer

I have a 1992 saab 900S 2.1 non-turbo engine, The car has been running fine the psa few months, recenlty it will not start, I put the key in the iginition turn the key, the lighs on the dash comes on then...

The issue with starting systems is that there are many things that may be wrong with it. It certainly sounds like an electrical problem. I'm going to give you a way to check to see if it is actually the starter itself that may be bad. if you can physically reach the starter(on some you may not be able to) LIGHTLY tap on it with a hammer and then try to start it. DO NOT hit it very hard because this may cause the starter to become inoperable if it isn't already. if you turn the key and the batter just gets drained dead then I would sound to be a starter issue as well. These electrical issues are looked at by trained professionals in legal service shops.

As a licensed and certified mechanic I would highly recommend you have it tested before you start throwing parts at it because that may be VERY costly.and time consuming. when properly diagnosed you can save time, money, and a massive headache.

Hope this helps you out!

Feb 17, 2011 | 1992 Saab 900

2 Answers

My 1988 chevy truck won,t start.I put new battery clamps on .I charged the battery . I put new ground wire negative to body. all I GET is a click.what should I do next?

I would have the starter tested. Also check to see if the motor is turning freely, by turning the crankshaft pulley, just to make sure the motor isn't locked up.

Oct 27, 2010 | 1988 Chevrolet C1500

2 Answers

1990 Toyota Celica will not start.

Sounds like the connection from the battery to the chassis ground is bad. Try replacing the Negative battery wire and make sure where it attaches to the frame is as rust free as possible

Dec 30, 2009 | 1990 Toyota Celica

1 Answer

It wont start

Assuming that the connections are correct, you could have dirty battery terminals, bad starter-motor, blown fuse, bad iginition-switch.
If aall the above are good, take out the starter-motor to a shop to test it.

Nov 17, 2009 | 1997 Ford Escort

1 Answer

Nothing when I turn the iginition switch on.

New battery 2001 chev express van 1500 turn key will not turn over.All guages work .Sounds as if starter is clicking.

Feb 01, 2009 | 2004 Honda CR-V

Not finding what you are looking for?
2006 Ford F-150 Logo

143 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5655 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides