Question about 2002 Chrysler Town & Country

1 Answer

Air conditioner driver zone not working. other 2 zones and rear work fine.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 182 Answers

Possible blower motor or resistor in the front

Posted on Sep 06, 2010

Testimonial: "I will investigate in that direction. thanks"

  • 1 more comment 
  • scricken Sep 07, 2010

    specifically, the air blows out fine (the same strength/speed as the other zones. It's that the temp is more like a vent. No matter what setting I use, it won't get any cooler on the driver zone. The other zones work as needed.

  • justin vanderpool Sep 07, 2010

    sounds like the temp blend door actuator has went bad

  • mrmarkin281 Sep 24, 2010

    Where can you get directions for digging into the dash as well as these parts? I have the same issue on the driver side

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

06 ford explorer, zone a/c but only hot air in the front, a/c works fine in the rear zone. Compressor and freon are fine. What do I do?


Blend door operation may be failed. Check for vacuum leaks, check valve failed, door actuator failed.

Jun 28, 2015 | Ford Cars & Trucks

1 Answer

The heat for my 2006 suburban doesnt work all three zones passanger,driver, and rear. Just blows cold air. Could this be an accuator problems if its all three zones? Or should I be looking at the...


Temperature blending doors might need a reset. Find the fuse and pull it for a few minutes. If that doesn't work you may need to replace the blend door actuator. Or your cooling system may be clogged.

Sep 17, 2013 | 2006 Chevrolet Suburban 1500

1 Answer

Air comes out colder on left than right and back


Well you say you do not have dual zones. so you can not adjust temperature for passenger side, there are no temperature dials for the passenger side,only one that controls both driver and passenger. if this is the case then you may just be low on Freon gas, that would be the first thing i would have tested as the rear is hot also.
Another thing that would cause the rear to be hot would be a bad blend door to rear or an expansion valve, the first step is to find out why you get hot air out of passenger side lets forget about rear for now, you do not have dual zones and drivers side is cold and passenger side hot, that is something when you do not have dual zones, so start with making sure the system is full, a low system can cause your problem. hope this is helpful good day.

May 27, 2012 | 2008 Jeep Grand Cherokee

1 Answer

I have the daul air conditioner and the driver side blows cool air, but the passager side blow hot air even if its on cool....help!


In the dash there are multiple "Mode Doors" that direct the flow of air in the dash for your AC. A duel zone system takes it further than that because it has doors for each zone.

Most likely, the temperature mode door for the passenger side isn't working properly because of a bad motor or other issue. There is a service bulletin on late model Chevrolet trucks that states as the motors age, they begin to work outside of the specified range the computer expects. As a result, they hang because the computer doesn't register them working correctly (out of range). It is recommended you have the vehicle software flashed to the latest configuration prior to diagnosing this issue as the new software takes the motor wear into account.

May 31, 2011 | Chevrolet TrailBlazer Cars & Trucks

1 Answer

2005 tahoe dual climate control, driver side blows HOT air.


You will need to replace the drivers side temp actuator. It is available at your local dealership.

Aug 30, 2009 | 1999 Chevrolet Tahoe

1 Answer

2006 malibu air conditioner blows warm air on driver's side and cold air on passenger's side.


1. If it worked fine recently, I would suspect low r134a charge. 2. If you have dual zone heating/cooling, your mode motor may be out on the driver's side. Switch the temp up an down slowly and check under the dash for the actuators to move. If one side moves but the other does not, you have found your problem.

Jul 14, 2009 | 2000 Mitsubishi Eclipse

1 Answer

Passanger side heater blows cold while driver side is hot


U will need to replace the pass side air temp control blend door acuator motor.

Jan 22, 2009 | 2004 Jeep Grand Cherokee

4 Answers

Heater/ac not working properly


Easy fix. The vacuum hose has come loose. Happens all the time. The hose is about 1/2" in diameter and can be found under the hood, in the middle of the engine compartment, on the drivers side. Just take a tie wrap and tighten it down over the plastic inlet.

Jan 05, 2009 | 2004 Jeep Grand Cherokee

4 Answers

Heating problem


my car is now fixed i bought an accuator from the dealer for around 54 dollars and replaced the driver side accuator by removing the panel below the steering wheel moved all the wires out of the way and it was held on by two screws( .5mm) took around 30- 45 mins. and now the heat is cranking on both sides the dealer said that it is a very common problem in these cars to bad gm is to cheap to put out a recall

Jul 21, 2008 | 2004 Chevrolet Impala

2 Answers

Driver side ac not cold


It is not a coolant leak. Nice try though. It is possible that the infra red temp sensor is faulty, also it may be a mode door(directs air flow in the heater box) or a mode door actuator. Your dealer can test for proper door actuation, and can also check temperature difference, some is not uncommon, but it depends on the temp setting, is this a dual zone, or tri-zone atc unit?

Jun 21, 2008 | 2002 Chrysler Town & Country

Not finding what you are looking for?
2002 Chrysler Town & Country Logo

171 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8567 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...